Speco Technologies O4VLD1 Manual de Usario

Lee a continuación 📖 el manual en español para Speco Technologies O4VLD1 (11 páginas) en la categoría Cámara de vigilancia. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/11
Quick Start Guide
4MP IP Vandal Dome Camera
O4VLD1
Version 1.0
i
Welcome
Thank you for purchasing this network camera!
This manual is designed to be a reference tool for your system. owner’s
Please read this manual carefully before operang the unit and retain it for future reference.
Should you require any technical assistance, please contact Speco Technologies Technical Support.
ii
Important Safeguards and Warnings
1 Electrical safety
All installaon and operation here should conform to local electrical safety codes.
Use a certied/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in
device damage! The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage and
installation.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature conditions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor failure.
Do not block any venlation openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small
quanty of neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as
using cloth) may result in poor IR functionality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the
camera.
Dome cover is an opcal device, please don’t touch or wipe cover surface directly during installaon and use,
please refer to the following methods dirt is found: if
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward.
Change the cloth and wipe several mes if it is not clean enough.
Warning
This camera should be installed by qualied personnel only.
All the examinaon and repair work should be done by qualied personnel.
Any unauthorized changes or modicaons could void the warranty.

Especificaciones del producto

Marca: Speco Technologies
Categoría: Cámara de vigilancia
Modelo: O4VLD1

¿Necesitas ayuda?

Si necesitas ayuda con Speco Technologies O4VLD1 haz una pregunta a continuación y otros usuarios te responderán




Cámara de vigilancia Speco Technologies Manuales

Cámara de vigilancia Manuales

Últimos Cámara de vigilancia Manuales