Teka EX 90 5G AI TR IX Manual de Usario

Teka horno EX 90 5G AI TR IX

Lee a continuación 📖 el manual en español para Teka EX 90 5G AI TR IX (18 páginas) en la categoría horno. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/18
Instructions for the installation
and advice for the maintenance
EX/90 5G AI TR - EX/90 5G AI TR FUND
EX/90 5G AI AL TR FUND
Instructions Manual
EX/90 5G AI TR - EX/90 5G AI TR FUND
EX/90 5G AI AL TR FUND
COD. 04032MO (04032ING) - 03.10.2005
2
1 Ultra rapid burner of 3100 W
2 Rapid gas burner of 2800 W
3 Semirapid gas burner of 1750 W
4 Auxiliary gas burner of 1000 W
5 Enamelled steel pan support ultra rapid central burner
6 Enamelled steel pan support 2 right burners
7 Enamelled steel pan support 2 left burners
8 Burner n° 1 control knob
9 Burner n° 2 control knob
10 Burner n° 3 control knob
11 Burner n° 4 control knob
12 Electric ignition button
Attention: this appliance has been manufactured for domestic use only and it employment by
private person.
DESCRIPTION OF THE HOT PLATES
TYPES: EX/90 5G AI TR - EX/90 5G AI TR FUND
EX/90 5G AI AL TR FUND
1) BURNERS
A diagram is screen-printed above each knob on
the front panel. This diagram indicates to which
burner the knob in question corresponds. After
having opened the gas mains or gas bottle tap,
light the burners as described below:
- Manual ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
place a lighted match near the burner.
- Electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress and release the ignition button.
- Automatic electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame fig.1)
and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations.
Keep the knob depressed for about 10 seconds
once the burner has ignited.
HOW TO USE THE BURNERS
Bear in mind the following indications in order to
achieve maximum efficiency with the least possible
gas consumption:
- Use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
- Use only pan with a flat bottom.
Burners Power ratings Pan Ø in (cm)
Ultra rapid 3100 24 ÷ 26
Rapid 2800 20 ÷ 22
Semirapid 1750 16 ÷ 18
Auxiliary 1000 10 ÷ 14
WARNINGS:
- Burners with flame failure device may only be
ignited when the relative knob has been set to
the Full on position (large flame fig. 1).
- Matches can be used to ignite the burners in a
blackout.
- Never leave the appliance unattended when
the burners are being used. Make sure there
are no children in the near vicinity. Particularly
make sure that the pan
handles are correctly positioned and keep a
chek on foods requiring oil and grease to cook
since these products can easily catch fire.
- Never use aerosols near the appliance when it
is operating.
- If the built-in hot plate has a lid, any spilt food
should be immediately removed from this
before it is opened. If the appliance has a glass
lid, this could shatter when the hot plate
becomes hot. Always switch off all the burners
before closing the lid.
3
USE
FIG. 1 FIG. 2

Especificaciones del producto

Marca: Teka
Categoría: horno
Modelo: EX 90 5G AI TR IX

¿Necesitas ayuda?

Si necesitas ayuda con Teka EX 90 5G AI TR IX haz una pregunta a continuación y otros usuarios te responderán




horno Teka Manuales

horno Manuales

Últimos horno Manuales