Uni-T UT131B Manual de Usario
Uni-T
multimetro
UT131B
Lee a continuación 📖 el manual en español para Uni-T UT131B (72 páginas) en la categoría multimetro. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/72
Eng l i shSve n skaNo r skSuo m iDe u tsc h
UNI-T UT131B Multimeter
Multimeter UNI-T UT131B
UNI-T UT131B multimeter
Yleismittari UNI-T UT131B
Art.no.
41-1599 Ver. 20201120
UT131B
HOLD/SEL
FUSED
250V Max
10 sec Max
FUSED
200mA Max
CAT II 250V
OFF
20M
200k
20k
10 12V 9V
1.5V
2000
200
200
V
V
200m
2000m
200
20
250
250
200μ
200m
2
Eng l i sh
UNI-T UT131B Multimeter
Art.no: 41-1599
Please read theentire instruction manual before using theproduct and then
save it for future reference. We reserve theright for any errors in text or
images and any necessary changes made to technical data. In theevent of
technical problems or other queries, please contact our Customer Services
(see address details on theback).
Information about themeter
Themultimeter has been designed and tested in accordance with
therequirements for installation category II up to nominal voltages of
250V and acontamination level of2.
Categorisation
Meters are divided into different categories depending on theelectrical
environment in which they are to be used and how safe/protective they are
in theevent of avoltagesurge.
Themeter label should indicate which category it belongs to.
Thecategorisation also determines how safe theinstrument is with regards
to any overvoltage which could represent ahazard for theuser.
Thecategorisation is described briefly below:
In theevent of avoltage surge in theelectricity grid (atransient from
alightning strike, etc.), therisk will be greatest where themains supply
cable enters thebuilding, for example. Further inside thebuilding,
theresistance (impedance) in thecables will increase and connected
devices will reduce and dissipate theovervoltage. Themeter category will
therefore determine which electrical environment theinstrument is designed
to be usedin.
3
Eng l i sh
Thecategories which meters are divided into are as follows:
• For measuring electronics and products that have inbuilt Category I:
protection against voltage surges.
• For measuring single-phase equipment which is fed via Category II:
thebuilding’s electrical power supply system. Bothplug-connected and
permanently installed.
• For measuring thebuilding’s electrical systems. Category III:
Permanently installed cables, sockets, fuse boxes and switchgear
cabinets. Three-phase distribution (allpower supply cables and three-
phase equipment, machinery and appliances).
• Category IV: Three-phase at primary level and all conductors for
outdoor use.
This multimeter belongs to installation category II and is intended for
measuring voltages of up to 250V in single-phase products. Themeter
must not be used for measuring three-phase products, three-phase
conductors or switchgear cabinets even if thenominal voltage does not
exceed 250V.
Contamination level
Themeter is designed for use in environments in which contaminants
which do not conduct electricity are present. Withtheexception that
temporary conductor contamination can occur due to condensation.
Examples of environments with contamination level 2 are home
environments in dry rooms, offices, test stations and laboratories. Inother
words, rooms which have anormal indoor climate.
Themeter must not be used or stored in rooms where it could be exposed
to electrically conductive contaminants in any form (solid, liquid or gas).
Themeter should for example not be exposed to relative humidities in
excess of 75% or used in unheated rooms and must not be used in
wetrooms or outdoors where it could getwet.
It is not intended for use with electrical equipment which is used in industry
or agriculture.
Especificaciones del producto
| Marca: | Uni-T |
| Categoría: | multimetro |
| Modelo: | UT131B |
¿Necesitas ayuda?
Si necesitas ayuda con Uni-T UT131B haz una pregunta a continuación y otros usuarios te responderán
multimetro Uni-T Manuales
17 Septiembre 2024
16 Septiembre 2024
16 Septiembre 2024
16 Septiembre 2024
13 Septiembre 2024
13 Septiembre 2024
13 Septiembre 2024
13 Septiembre 2024
13 Septiembre 2024
13 Septiembre 2024
multimetro Manuales
- multimetro Alecto
- multimetro Appa
- multimetro Amprobe
- multimetro Silverline
- multimetro Ferm
- multimetro Stanley
- multimetro Parkside
- multimetro Milwaukee
- multimetro EMOS
- multimetro Extech
- multimetro Tacklife
- multimetro Metrix
- multimetro Benning
- multimetro Voltcraft
- multimetro Somogyi
- multimetro Velleman
- multimetro Kyoritsu
- multimetro Ideal
- multimetro Flir
- multimetro Maxwell
- multimetro Digitus
- multimetro Testboy
- multimetro Hager
- multimetro Topcraft
- multimetro TFA
- multimetro Clas Ohlson
- multimetro Powerfix
- multimetro Owon
- multimetro Fluke
- multimetro Jung
- multimetro Greenlee
- multimetro Högert
- multimetro Laserliner
- multimetro REV
- multimetro Testo
- multimetro Bruder Mannesmann
- multimetro Keithley
- multimetro Monacor
- multimetro Multimetrix
- multimetro Digi-tool
- multimetro GW Instek
- multimetro Elma
- multimetro Mastech
- multimetro PeakTech
- multimetro Chauvin Arnoux
- multimetro Megger
- multimetro Gossen Metrawatt
- multimetro PCE Instruments
- multimetro Klein Tools
- multimetro Aim TTi
- multimetro Sanwa
- multimetro EEVBlog
- multimetro Elworks
- multimetro Qian
- multimetro Bearware
- multimetro Noyafa
Últimos multimetro Manuales
22 Octubre 2024
21 Octubre 2024
18 Octubre 2024
18 Octubre 2024
17 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024