Velleman K6714-16 Manual de Usario

Lee a continuación 📖 el manual en español para Velleman K6714-16 (16 páginas) en la categoría Niet gecategoriseerd. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/16
Total solder points: 351
Difficulty level: beginner 1 4 5 2 3 advanced
Universal relay card
ILLUSTRATED ASSEMBLY MANUAL H6714(16)IP-1
K6714
K6714
If you want to switch large electric currents
using an electronic control and require control
isola
tion a t
t he same time, then this card is a
valuable asset.
K6714
K6714 -
-16
16
2
Features & specifications
Features :
The relays can be controlled in different ways : direct control from open-
collector outputs, TTL or CMOS level or trough other kits (K6711, K8000,
K8023,…)
Every output of the print can be equipped with a noise suppressor network.
Output 12V CC can be used as a power supply for other kits: K6711,
K8023,...
Specifications
Power supply:.................................................... 230 or 125VAC max. 12VA.
Output voltage: ...........................................................................12V/250mA.
Relay switch-over contact: .................................................max. 5A at 220V.
PCB dimensions m (5.9" x 8.4") :..................................................150 x 212m
3
Assembly hints
1. Assembly (Skipping this can lead to troubles ! )
Ok, so we have your attent you to make this project ion. These hints will help
successful. Read them carefully.
1.1 Make sure you have the right tools:
A good quality soldering iron (25-40W) with a
small tip.
Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to
the tip, to give it a wet look. This is called ‘thinningand will protect
the tip, and enables you to make good connections. When solder
rolls off the tip, it needs cleaning.
Thin raisin-core solder. Do not use any flux or grease.
A diagonal cutter to trim excess wires. To avoid injury when cutting
excess leads, hold the lead so they cannot fly towards the eyes.
Needle nose pliers, for bending leads, or to hold compo-
nents in place.
Small blade and Phillips screwdrivers. A basic range
is fine.
For some projects, a basic multi-meter is required, or might
be handy
1.2 Assembly Hints :
Make sure the skill level matches your experience, to avoid disappointments.
Follow the instructions carefully. Read and understand the entire step before
you perform each operation.
Perform the assembly in the correct order as stated in this manual
Position all parts on the PCB (Printed Circuit Board) as shown on the draw-
ings.
Values on the circuit diagram are subject to changes.
Values in this assembly guide are correct*
0.000

Especificaciones del producto

Marca: Velleman
Categoría: Niet gecategoriseerd
Modelo: K6714-16

¿Necesitas ayuda?

Si necesitas ayuda con Velleman K6714-16 haz una pregunta a continuación y otros usuarios te responderán




Niet gecategoriseerd Velleman Manuales

Niet gecategoriseerd Manuales

Últimos Niet gecategoriseerd Manuales