Vimar 01985.120 Manual de Usario

Vimar Regulador de intensidad 01985.120

Lee a continuación 📖 el manual en español para Vimar 01985.120 (1 páginas) en la categoría Regulador de intensidad. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/1

Viale Vicenza, 14 - 36063 Marostica VI Italy

Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709

www.vimar.com

MASTER dimmer 120 V~ 60 Hz for incandescent lamps 40-500 W electronic

transformers 40-300 VA, CFL lamps 10-200 W, LED lamps 3-200 W, for LED

electronic power supplies, protection fuse, installation on DIN rails (60715

TH35), occupies 4 modules size 17.5 mm. For nautical scope.

ON/OFF switch and adjustment with two built-in buttons. MOSFET+TRIAC microprocessor

technology, works in both LE (Leading Edge) and TE (Trailing Edge) modes. MASTER function,

protection fuse. The device receives commands directly from the Busbar and is able to control

the load directly. It can also control up to 3 SLAVE dimmers for DIN rails 01986.120.

IMPORTANT: Lamps controllable from a single master or slave dimmer must all be the

same. All controllable loads must be declared DIMMERABLE by the manufacturer. Check

the type of compatible dimmering on the lamp package: LE (Leading Edge) or TE (Trailing

Edge). If it is not specified, the lamp can operate in both modes (chosen at the discretion

of the installer).

CHARACTERISTICS.

• RatedsupplyvoltageTPBusbar:29V

• Ratedsupplyvoltagemains:120V~,60Hz

• AbsorptionfromTPBusbar:15mA

• Dissipatedpower:7.8W

• Terminals:N neutral, load, phase, L Ssynchronization,TPBusbar

• ProtectionfusetypeF5AH250V

• Functionsthatcanbeaccomplishedwiththedimmer:

- Switching on, off and dimmering

- Changing absolute brightness

- Actuating/saving scenarios

- Enabling "Flash Start" mode for CFL lamps

- "Ramp" operation

- Switch-off delay and warning function

-Phasecutting:LE/TE

• Localcontrols:

Pressingthe button enables using the local buttons. All messages from the busbar are

ignored.

- Briefly pressing the button :ONcontrol

- Briefly pressing the button :OFFcontrol

-Pressingandholdingdownthebutton :Increasebrightness

-Pressingandholdingdownthebutton :Decreasebrightness

In normal operation (that is when the commands are sent over the bus) pressing the buttons

for the outputs is ignored.

• Protectionagainstshort-circuitingwhenturningonwithflashingblow-outindicator.

• Thermalprotectionwithflashingblow-outindicator.

• MASTER-SLAVE function: paying attention not to exceed maximum power controllable by

each dimmer. A MASTER device can have up to 3 SLAVE dimmers (art. 01986.120) for a

maximumtotalload of2000W(VA)correspondingto500W/VAmax connectedtoeachof

the 4 devices.

• InstallationonDINrails(60715TH35),occupies4modulesof17.5mm.

CONFIGURATION.

FOR THE OPERATIONS OF INSTALLATION AND CONFIGURATION, SEE THE BY-ME

SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL PANEL.

•Functionalunits:1;theunitcanbelongtoatmost4differentgroups.

• Selecting the functional unit (configuration): during group creation, when the control panel

requirespressingthedevicebutton:

-ItisrecommendedtoconfigurethedevicewiththeloadOFF;

-PresstheCONFbutton,theredLEDwilllightup;

- With the red LED on, the control panel will configure the functional unit; at the end of this

operation the red LED will go out.

Controllable loads LE TE

40 to 500 W 40 to 300 W

10 to 100 W 10 to 200 W(Max5lamps) (Max 10 lamps)

3 to 100 W 3 to 200 W(Max5lamps) (Max 10 lamps)

Electronic transformers

for halogen lamps

40 to 300 W

(Max 3 transformers type

)

40 to 300 W

(Max5transformerstype

)

Dimmering with Leading Edge mode Dimmering with Trailing Edge mode

INSTALLATION RULES.

Installation should be carried out in compliance with the current regulations regarding the instal-

lation of electrical systems in the country where the products are installed.

• Itshouldbeusedinplacesatatemperatureofbetween-5°Cand+45°C.

• Thelampsconnectedtothemasterorslavemustallbethesame.

• Notsuitableforcontrollingmotors(e.g.fans,ventilators).

•Theratedpowerlevelshouldneverbeexceeded.

• Overloading, power surges and short-circuits may irreparably damage dimmers. Before

installation check the circuit carefully and eliminate any of the above causes.

• The dimmer does not have a mechanical circuit breaker in the main circuit and so is not

galvanically separated. The circuit load should be considered always powered.

For further instructions see the manual enclosed with the control panel.

CONFORMITY TO STANDARDS.

For MARINE use,thisdevicehasbeensubmittedtothefollowingtests:

IEC60068-2-52-TestKb:Saltmist,cyclic(sodium,chloridesolution),

IEC60068-2-6-TestFc:Vibration(sinusoidal)

Thisdevicecomplieswithpart15oftheFCC Rules (with the limits for a Class B digital device).

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference

that may cause undesidered operation.

FRONT VIEW

CONNECTIONS

MaximumlengthofcablesconnectinguniversalMASTERdimmeranduniversalSLAVEdimmer:100m

Connect at least the minimum load required to the universal master dimmer.

A:IndicatorLED

B:Switchingonandincreasingbrightness

C:Switchingoffanddecreasingbrightness

D:LEDandconfigurationbutton

CHANGING FUSE

OFF

01985.120

MASTER DIMMER

120V~

60Hz

40-50 0W LE

40-300W T E

CONF.

NLS

By-me

NLS

BUS

NLS

01986.12001985.120 01986.120

N L S

TE Flash

Soft

01986.120

SLAVE

DIMMER

40-500W LE

40-300W TE

120 V~ 60 Hz

N L S

TE Flash

Soft

01986.120

SLAVE

DIMMER

40-500W LE

40-300W TE

120 V~ 60 Hz

N L S

01985.120

MASTER DIMMER

120 V~ 60 Hz

40-500W LE

40-300W TE

Bus

MASTER SLAVE SLAVE

BUS TP

N L S

01985.120

MASTER DIMMER

120 V~ 60 Hz

40-500W LE

40-300W TE

01985.120

49400502A0011309

VIMAR - Marostica - Italy

Especificaciones del producto

Marca:	Vimar
Categoría:	Regulador de intensidad
Modelo:	01985.120
Color del producto:	Zwart
Peso.:	900 g
Ancho:	- mm
Profundidad:	- mm
Altura:	- mm
Brillo:	- cd/m²
Impermeable:	Nee
Plegable:	Nee
Distancia de enfoque más cercana:	8 m
tipo prisma:	Porro
Aumento:	30 x
Diámetro objetivo:	50 mm
alumno de salida:	5 mm
Campo de visión (a 1000 m):	65 m
Alivio del ojo:	15 mm
Recubrimiento de lentes:	Multi-coated (MC)