Whirlpool AWT 2055 Manual de Usario

Whirlpool lavadora AWT 2055

Lee a continuación 📖 el manual en español para Whirlpool AWT 2055 (14 páginas) en la categoría lavadora. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/14

GB QUICK REFERENCE GUIDE

BEFORE USING THE APPLIANCE FOR THE FIRST TIME:

• IMPORTANT: MAKE SURE YOU HAVE READ THE INSTALLATION INSTRUCTIONS.

• IMPORTANT: REMOVE THE TRANSPORT SCREWS AND THE TRANSPORT BRACKET.

• First wash cycle without laundry:

1. Open the tap(s).

2. Close the drum flaps.

3. Pour a small amount of detergent (about 30 ml) into the detergent dispenser

compartment .

4. Close the lid.

5. Select a short wash programme and a low spin speed (see programme chart).

6. Switch on the appliance.

This will remove any water remaining in the machine from the manufacturer’s test run.

NORMAL DAILY USE:

1. Open the tap(s).

2. Sort the laundry according to fabric type and colour and load the machine.

3. Close the drum flaps.

4. Add detergent and any additives required into the dispenser.

5. Close the lid.

6. Select the programme, temperature, spin speed and special options.

7. Switch on the appliance.

Read these user instructions carefully to learn about all the functions of your washing

machine.

CONTENTS GB

INSTALLATION INSTRUCTIONS PAGE 18

WASHING MACHINE AND ACCESSORIES PAGE 21

PROTECTING THE ENVIRONMENT PAGE 22

SAFETY INSTRUCTIONS PAGE 22

TRANSPORT / HANDLING PAGE 22

PREPARING THE WASH PAGE 23

DETERGENT AND ADDITIVES PAGE 24

DYEING AND BLEACHING PAGE 24

STARCHING PAGE 24

REMOVING THE FOREIGN BODY TRAP PAGE 25

DRAINING RESIDUAL WATER PAGE 25

MAINTENANCE AND CLEANING PAGE 26

TROUBLESHOOTING GUIDE PAGE 28

AFTER-SALES SERVICE PAGE 29

HOW TO UNPACK THE APPLIANCE

1. Cut and remove the shrink-wrap.

2. Remove the top protection and the protection corners.

3. Remove the bottom protection by tilting and

turning the appliance on one rear bottom corner.

4. Open the lid by pulling at the handle. Remove the

polystyrene cushion.

HOW TO REMOVE THE TRANSPORT

SCREWS AND THE TRANSPORT BRACKET

The appliance is fitted with the transport screws and

the transport bracket to prevent internal damage while

being moved.

Before using the appliance, the transport bracket

at the back MUST be removed.

1. Unscrew the two screws A and the four screws B

with a flat screwdriver or a N°8 hex nut screwdriver.

2. Remove the transport bracket.

3. Replace the four outer screws B into the machine

again and tighten.

4. Tear off the two stop plugs C from the hose holder

and clip them into the openings of the machine

Note: In case of future moves, always transport the

washing machine upright.

Keep the transport bracket for future use.

INSTALLATION

•Install the appliance on a solid and level floor

surface close to electrical, water and drain

connections.

•Make sure that all feet are stable and resting on

the floor and then check that the appliance is

perfectly level (use a spirit level).

•If the floor is uneven, adjust the levelling feet as

required (do not insert pieces of wood, cardboard

etc. under the feet).

•The appliance can be installed in a 40 cm width

and 63 cm depth space.

Note: It is important to avoid blocking the openings on

the underside of the appliance when installing on a

carpet floor.

ADJUSTMENT OF THE APPLIANCE

1. To move the appliance into its operating position:

Pull the mobility lever situated on the bottom of

the front (optional on certain models) a little bit by

hand and pull it in the final driving position by foot.

Afterwards push the mobility lever back into the

original, stable position. The front feet can be

adjusted in order to level the appliance.

2. Loosen the locknut using a wrench.

3. Adjust the height of the foot, turning it by hand.

4. Tighten the locknut by turning it anti-clockwise

towards the appliance casing.

IMPORTANT: Do not run the appliance while the

mobility lever is pulled and the appliance is standing

on the trolleys.

INSTALLATION INSTRUCTIONS

Especificaciones del producto

Marca:	Whirlpool
Categoría:	lavadora
Modelo:	AWT 2055
Color del producto:	Black, Red
Peso.:	2000 g
Fuente-de-alimentación:	Batterij/Accu
Filtración de aire de aspiradora:	Cyclonisch
Método de separación de la suciedad:	Cyclonisch
tipo de limpieza:	Droog
Capacidad de polvo:	0.4 l
Potencia máxima de entrada:	150 W
Tiempo de carga:	5.5 uur
Tipo de contenedor de aspiradora:	Zakloos
Ladrón removible:	Ja
tierra seca:	0.4 l
Duración:	0.5 min
Batería/Voltaje de la batería:	21.6 V
Zuigstang:	Ja
Limpia superficies:	Carpet, Hard floor
cepillo turbo:	Ja
Posición de estacionamiento:	Ja
Sistema de suspensión para la pared.:	Ja
Tecnología de batería:	Lithium-Ion (Li-Ion)