AFX Evanston EVNP2532LAJUDSN Manual de Usario
Lee a continuación 📖 el manual en español para AFX Evanston EVNP2532LAJUDSN (2 páginas) en la categoría Lámpara. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/2
Indoor Luminaire
Evanston Pendant
120~277VAC / 60Hz
Page 1 of 2 8061256 R0
Model EVNP2532LAJUDSN #
Safety Precautions
Read all safety precautions and installation instructions carefully before installing or servicing this xture. Failure to comply with these instructions could result in
potentially fatal electric shock and/or property damage.
It is recommended that a qualied electrician perform all wiring. This fixture must be wired in accordance with all national and local electrical codes.
Do not handle any energized xture or attempt to energize any xture with wet hands or while standing on a wet or damp surface or in water.
This xture is designed for use in a 120-277VAC, 60Hz fused circuit. The xture is compatible with Triac (forward-phase or leading edge) / ELV (reverse phase or trailing
edge) and 0-10 V dimmers. Make sure that the power source conforms to the requirements of the xture. (See labels on the xture housing).
To reduce the risk of electrical shock, and to assure proper operation, this xture must be adequately grounded. To accomplish proper grounding, there must be a
separate ground wire (green) contact between this xture and the ground connection of your main power supply panel.
This xture is intended to be used for general indoor lighting in dry or damp wet locations.
Disclaimer
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and Canadian ICES-005 (B) / NMB-005
(B). These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modications to this xture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Assembly Instructions
1. Preparing for installation-
A. before installing or servicing any part of this xture. Disconnect electrical power
B. Remove xture from box. Separate contents of parts bag.
2. Fixture Assembly.
A. Attach xture shade (1) to xture LED pan (2) using 6 provided screws (3). Hand
tighten to make sure they are secured tightly. Do not over tighten and strip threads.
B. Choose desired height for xture stems using any , stems of the 6” 12” & 18”
provided to achieve your preferred hang length to the top of the shade.
C. Feed xture wiring from top of shade up through both stems that are going to be
used all the way through the Hang Straight into the canopy.
D. Starting with the bottom stem thread each stem together one at a time until the
Canopy is securely tightened to the stems.
E. Tighten the stems to the canopy at the three locations with the desired stem lengths
to get the look wanted.
3. Wiring- all wiring must take place inside junction box.
Caution: Make sure power is o at fuse or circuit breaker box. Check power wires for any damage or scrapes. Use wire suitable for at least 90C (194F).
Note: Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualied electrician before installing.
A. ical shock, overheating, low or no light output, and This unit will not operate properly unless connected to a “grounded” electrical circuit. Electr
shortened LED life can result if proper grounding is not done. Securely attach power source ground wire and xture ground wire to green ground
screw on circular mounting bracket.
B. r NEC (National Electrical Code) requirements, cut the co Then remove the ends of the three wires for Fo rd about 7” above the canopy. 3/8” from
connection purposes.
C. . Fixture will operate normally w/o connection to any dimmers. Connect white xture lead to white (N) wire from supply For none-dimming xture
power source. Connect black xture lead to black (L) wire from supply power source. Gray and purple wires are not to be used and must be
individually capped to prevent shorting.
D. Connect white xture lead to (N) wire from dimming source per dimmer wiring instructions. Connect black xture lead to For TRIAC dimming.
black (L) wire from dimmer supply power source. Gray and purple wires are not to be used and must be individually capped to prevent shorting.
E. . Connect gray wire from the xture to the dimmer source gray wire. Connect purple wire from the xture to the For (0-10V) dimming xture
dimmer source purple wire. Connect white xture lead to white (N) wire from supply power source. Connect black xture lead to black (L) wire from
dimmer supply power source.
F. . Pull on each wire lead to make sure connections are secure. Make certain no bare wires are exposed outside of wire Do not mix wires
connectors. Tuck all connections neatly into junction box.
Limited Factory Warranty
AFX Inc. hereby warranty that this xture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from the date of shipment from the factory. This warranty covers all component parts and extends only to
replacement of defective xture or components: it does not cover failure due to improper installation, misuse, mishandling or damage
incurred in transit.
Indoor Luminaire
Evanston Pendant
120~277VAC / 60Hz
Page 2 of 2 8061256 R0
Model # EVNP2532LAJUDSN
4. Color Changing Temperature Adjustment, CCT (if desired).
A. Adjust the two switches on each board accordingly to the desired color temperature as seen below. All boards must be set the same way. Fixture is preset Note:
to 3500K from factory.
5. Ceiling Mounting.
A. Align mounting gem bar ) over tapped holes in the junction box (Not Included) Secure mounting cross bar to the junction box with two provided screws (5), (4 .
making sure the gem bar ) is tight up against the ceiling. (4
B. Lift xture ) with stem and canopy ) ush up to ceiling aligning two threaded stems (7) with clearance holes in the canopy (6 (1 (6 ).
C. Secure the xture canopy (6) ush to ceiling with the two decorative thumb nuts (8) provided.
D. Place diuser (9) inside shade resting on bottom ring to give the nished look.
6. Restore power at the fuse or breaker box.
Limited Factory Warranty
AFX Inc. hereby warranty that this xture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from the date of shipment from the factory. This warranty covers all component parts and extends only to
replacement of defective xture or components: it does not cover failure due to improper installation, misuse, mishandling or damage
incurred in transit.
Especificaciones del producto
| Marca: | AFX |
| Categoría: | Lámpara |
| Modelo: | Evanston EVNP2532LAJUDSN |
¿Necesitas ayuda?
Si necesitas ayuda con AFX Evanston EVNP2532LAJUDSN haz una pregunta a continuación y otros usuarios te responderán
Lámpara AFX Manuales
12 Octubre 2024
12 Octubre 2024
12 Octubre 2024
12 Octubre 2024
Lámpara Manuales
- Lámpara Sony
- Lámpara Samsung
- Lámpara IKEA
- Lámpara Philips
- Lámpara Honeywell
- Lámpara Canon
- Lámpara Alecto
- Lámpara Ansmann
- Lámpara Akasa
- Lámpara Silverline
- Lámpara Brennenstuhl
- Lámpara Workzone
- Lámpara BenQ
- Lámpara Ozito
- Lámpara Klarstein
- Lámpara Silvercrest
- Lámpara Nedis
- Lámpara Gembird
- Lámpara Innoliving
- Lámpara Livoo
- Lámpara Stanley
- Lámpara Crivit
- Lámpara Eglo
- Lámpara Lucide
- Lámpara OK
- Lámpara Hilti
- Lámpara Westinghouse
- Lámpara Kodak
- Lámpara Blaupunkt
- Lámpara Metabo
- Lámpara BeamZ
- Lámpara Logik
- Lámpara Trust
- Lámpara Carson
- Lámpara Elro
- Lámpara EMOS
- Lámpara Mesko
- Lámpara Hähnel
- Lámpara Silva
- Lámpara Hazet
- Lámpara Hama
- Lámpara Fenix
- Lámpara Theben
- Lámpara Velleman
- Lámpara Smartwares
- Lámpara Easymaxx
- Lámpara Steren
- Lámpara Hansa
- Lámpara Steinel
- Lámpara Livarno
- Lámpara Sanitas
- Lámpara Petzl
- Lámpara Black Diamond
- Lámpara Craftsman
- Lámpara Digitus
- Lámpara Nitecore
- Lámpara In Lite
- Lámpara Barco
- Lámpara Näve
- Lámpara Godox
- Lámpara Luceplan
- Lámpara Bresser
- Lámpara Olight
- Lámpara Elation
- Lámpara Sygonix
- Lámpara Runtastic
- Lámpara Steinhauer
- Lámpara Topeak
- Lámpara Zuiver
- Lámpara Konig
- Lámpara Chauvet
- Lámpara Flex
- Lámpara X4-Tech
- Lámpara HQ
- Lámpara Nanlite
- Lámpara Profoto
- Lámpara Trio Lighting
- Lámpara Ranex
- Lámpara Globo
- Lámpara Eurolite
- Lámpara August
- Lámpara Paul Neuhaus
- Lámpara Revo
- Lámpara Ibiza Sound
- Lámpara Impact
- Lámpara Avidsen
- Lámpara Lume Cube
- Lámpara Konig & Meyer
- Lámpara Ozone
- Lámpara ORNO
- Lámpara Toolcraft
- Lámpara Unilux
- Lámpara Aputure
- Lámpara Brandson
- Lámpara ARRI
- Lámpara Martin
- Lámpara Osram
- Lámpara Bolt
- Lámpara Duronic
- Lámpara Dorr
- Lámpara Ledlenser
- Lámpara Honeycomb
- Lámpara Elinchrom
- Lámpara Mission
- Lámpara Paulmann
- Lámpara Vimar
- Lámpara Dedra
- Lámpara Cameo
- Lámpara Kanlux
- Lámpara XQ-Lite
- Lámpara Wetelux
- Lámpara SLV
- Lámpara Sagitter
- Lámpara Elgato
- Lámpara Schwaiger
- Lámpara V-Tac
- Lámpara Neo
- Lámpara Gravity
- Lámpara Berger & Schröter
- Lámpara Apa
- Lámpara Prixton
- Lámpara Hatco
- Lámpara Goal Zero
- Lámpara Lutec
- Lámpara Karma
- Lámpara Livarno Lux
- Lámpara Neewer
- Lámpara Zafferano
- Lámpara Lightway
- Lámpara NUVO
- Lámpara Omnilux
- Lámpara Brilliant
- Lámpara Heitronic
- Lámpara NEO Tools
- Lámpara Angler
- Lámpara AccuLux
- Lámpara Luxform
- Lámpara Adviti
- Lámpara ArmyTek
- Lámpara Lalumi
- Lámpara Raya
- Lámpara Lupine
- Lámpara Rotolight
- Lámpara SIGOR
- Lámpara Maxim
- Lámpara Oecolux
- Lámpara Megatron
- Lámpara Integral LED
- Lámpara Casalux
- Lámpara Lowel
- Lámpara Airam
- Lámpara Sonoff
- Lámpara Lirio By Philips
- Lámpara Westcott
- Lámpara Gewiss
- Lámpara SecoRüt
- Lámpara Meross
- Lámpara Fabas Luce
- Lámpara Dainolite
- Lámpara Signature Design By Ashley
- Lámpara NightStick
- Lámpara Videx
- Lámpara Kartell
- Lámpara Louis Poulsen
- Lámpara Artecta
- Lámpara Fixpoint
- Lámpara Zadro
- Lámpara Kind LED
- Lámpara Waldmann
- Lámpara Hensel
- Lámpara Altman
- Lámpara Setti+
- Lámpara Jinbei
- Lámpara XCell
- Lámpara Perfect Christmans
- Lámpara Xline
- Lámpara ET2
- Lámpara Quoizel
- Lámpara Golden Lighting
- Lámpara Ridem
- Lámpara Fredrick Ramond
- Lámpara Crystorama
- Lámpara Sonneman
Últimos Lámpara Manuales
26 Octubre 2024
26 Octubre 2024
25 Octubre 2024
24 Octubre 2024
24 Octubre 2024
24 Octubre 2024
23 Octubre 2024
23 Octubre 2024
23 Octubre 2024
23 Octubre 2024