Akuvox A01S Manual de Usario

Lee a continuación 📖 el manual en español para Akuvox A01S (6 páginas) en la categoría No categorizado. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/6
Quick Guide
A01X/A02X
Before you begin using the device, please check the version you got and ensure
that the following items are included in the shipped box:
Unpacking
Universal Accessories:
A01/A02 x 1
M2.5X4 Screw x 4
Plastic wall anchor x 4
Rope x 1
ST4X20 screw x 4
M4X30 screw x 2
Pry tool x 1
M3X4 Set screw x 1
Allen wrench x 1 Rubber Plug(S,M,L) x 3
Silicone Foam Seal Strip x 1
RJ45 Coupler Ethernet Extension Connector x 1
RJ45 Ethernet Patch Cable x 1
Embedded Junction Box Mounting Bracket x 1
Cable Locking Plate x 1
Product Overview
Card Reader
Keypad
Card Reader
A01 A02
Quick Guide
A01X/A02X
The 86 junction box is a standard purchased item for the installation and
is not included in the packing list, please prepare it before the installation.
Installaon Warning
Step1: Bracket Installaon
Wall-mounng Installaon
Mark the positions of the four holes of
the Junction box at the hole center.
Note: The junction box shall be at least
50 mm in height.
Installaon
Drill the four marked holes using 5mm
drill bit hand drill. The drilled hole depth
should be 30m m.
Junction box installation is completed
Fix the the junction box on to the wall
using 4 ST4x20 screws, then fix the
junction box component on to the
junction box using 2 M4x30 screws.
Inserting the plastic wall anchors into
the drilled holes.
2
Quick Guide
A01X/A02X
Cut out a square hole with the dimension
(height*width*depth = 86*86*50mm).
And lead a cable from the square hole
in to the junction box .
Note: Skip this step is the junction box
is already embedded in the wall .
Fill in the gap between the square hole
and the junction box with cement or other
non-corrosive construction adhesive.
Wait until the cement or the adhesive
become hardened before proceeding
to the next step.
Note: Skip this step is the junction box
is already embedded in the wall .
Fix the junction box component on to
the junction box using 2 M4x30 Screws.
The junction box installation is completed.
3
Flush Mounng Installaon
GROUND
1100 mm
86mm
86 mm

Especificaciones del producto

Marca: Akuvox
Categoría: No categorizado
Modelo: A01S

¿Necesitas ayuda?

Si necesitas ayuda con Akuvox A01S haz una pregunta a continuación y otros usuarios te responderán




No categorizado Akuvox Manuales

No categorizado Manuales

Últimos No categorizado Manuales