Andrews ASF50 Manual de Usario

Andrews Ventilador ASF50

Lee a continuación 📖 el manual en español para Andrews ASF50 (3 páginas) en la categoría Ventilador. Esta guía fue útil para 14 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/3

Click www.andrews-sykes.com

or Call Us Free 0800 211 611

ASF21/50

Cooling & Ventilation Fans

Operating Instructions

& Safety Guide

Set up & operation

Set the unit up on a ﬁrm, level surface and do not site the unit close to

any personnel wearing contact lenses, sensitive to any dust movement,

hay fever sufferers etc. This unit moves air only, but minute particles

of dust / pollen etc will also be moved, especially on highest fan

setting, so careful location / fan angle / use of speed control will require

consideration.

The body of the fan is held in position via the side-mounted hand-

wheels. To adjust, slacken the wheels to allow the fan body to be

moved. Once the desired angel is reached, ensure the hand-wheels are

turned hand tight to prevent movement (ﬁg. 1).

The air-ﬂow from the fan exits from the side with the speed controller on

it (the front), the intake side is where the power supply cable enters the

rear of the unit.

General Safety

Never place anything of top of the unit and never obstruct the air inlet

/ outlet grills. Leave a 300 mm gap all around the unit to let the air

circulate. Always switch OFF and unplug the equipment when not in use.

Electrical Safety

This fan unit plugs into either a standard 230v 13 amp or a 110v

power supply, depending on model (see data plate for voltage type).

The plug (230v models only) is ﬁtted with a 13 amp fuse.

Extension leads should be: correctly rated for the inductive load

fully unwound, loosely coiled and never run through water or over

sharp edges.

To reduce the risk of electric shock, use a suitable RCD (residual

current device).

Never pull the equipment by its power cord.

Ensure the machine and power socket are switched OFF before

plugging into the power supply.

Warnings

Do not use in wet or damp conditions.

Please ensure you read and understand the operating instructions

before using the unit.

If you are in any doubt regarding the electrical supply, please

contact your supplier.

All electrical installations must comply withe IEE regulations.

Do not use fan if there is damage to the power cord, plug or guard.

Do not attempt to modify or repair this unit.

Earth fans (class 1)

Plugs must be wired to the following code

Brown - Live

Blue - Neutral

Gree/Yellow - Earth

Fig. 1

Equipment care & storage

Never use an air mover except for its intended purpose.

Keep the equipment clean & especially the grill faces. Blow out the

grills with compressed air if ‘clogged’ up.

Never move the unit whilst in operation!

Switch the unit OFF and unplug from its power supply, wrap the

cable round the storage ears.

Operating Instructions - ASF21/50

Click www.andrews-sykes.com 0800 211 611or Call Us Free

Troubleshooting

Below is a trouble shooting guide, which will help should any difﬁculties

be experienced.

Always consult this guide before ringing your supplier. The majority of

reported problems are simply solved in this manner.

If none of the above solves the problem, please contact your supplier

for advice

Problem Likely Cause Solution

Unit fails to operate Power failure Check unit is plugged in to power supply

Check plug fuse (230v only) for failure &

correct 13 amp rating

110v Models, check power supply

Check building ring circuit is not overloaded

Poor airﬂow Speed control on low

setting

Grills dirty

Air inlet grills obstructed

Turn speed control knob clockwise to

increase airﬂow

Blow compressed air through grills to clean

Remove obstruction

Operation

To start

Plug the unit into the relevant power supply and switch the supply ON

(ﬁg. 2).

Press the red ‘rocker’ switch on the front of the unit to ON, which will

then illuminate.

The fan blade should immediately start to turn & the speed can be

controlled with the knob on the control panel. Do not force the knob

past the stop point; you will damage the switchgear.

To stop

Move the on/off switch to the off position. Isolate from electrical supply

when not in use.

Fig. 2

On indicator

On/Off switch

Off indicator

Fan speed controller

10 being maximum

Especificaciones del producto

Marca:	Andrews
Categoría:	Ventilador
Modelo:	ASF50
Color del producto:	Wit
Ancho:	50 mm
Profundidad:	50 mm
Altura:	70 mm
Clase-de-eficiencia-energética:	F
Ancho del embalaje:	80 mm
Empaquetadura en profundidad:	50 mm
Altura del embalaje:	130 mm
Amable:	Intelligente verlichting
Tipo de lámpara:	LED
Lámpara de encendido:	4.5 W
Tipo de embalaje:	Doos
Consumo de energía (en espera):	0.5 W
Soporte remoto para teléfonos inteligentes:	Ja
Interfaz:	Wi-Fi
Conecta y reproduce:	Ja
Cantidad por paquete:	1 stuk(s)
frecuencia wifi:	2.4 GHz
Tipo de ajuste/pie:	GU10
Flujo-luminoso:	380 lm
Vida útil de la lámpara:	25000 uur
Potencia equivalente de una lámpara incandescente:	35 W
luz de color:	Wit
Cambiando de color:	Ja
Temperatura de color (máx.):	6500 K
voltaje-de-entrada-de-CA:	220-240 V
Frecuencia-de-entrada-de-CA:	50/60 Hz
Control de voz:	Ja
Clase de eficiencia energética incluida lámpara (antigua):	A+
Temperatura de color (mín.):	2700 K