Audio-Technica AT8035 Manual de Usario

Lee a continuación 📖 el manual en español para Audio-Technica AT8035 (2 páginas) en la categoría micrófono. Esta guía fue útil para 13 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
broadcast & production microphones
AT8035
Line + Gradient Condenser Microphone
Features
Designed for video production and broadcast (ENG/EFP) audio
acquisition
Provides the narrow acceptance angle desirable for long-distance
sound pickup
Smooth, natural-sounding on-axis audio quality
Offers the convenience of battery or phantom power operation
Rugged design and construction for reliable performance
Switchable 80 Hz high-pass lter minimizes pickup of undesired
low-frequency sounds
Description
The AT8035 is a xed-charge condenser microphone with a line +
gradient polar pattern. It is designed for video production, broadcast
(ENG/EFP) audio acquisition, wildlife recording and high-quality sound
reinforcement.
The microphone requires 11V to 52V phantom power or a 1.5V AA
battery for operation. A battery need not be in place for phantom power
operation.
The microphone's highly directional polar pattern provides a narrow
acceptance angle along with crisp, intelligible audio reproduction
desirable for long-distance sound pickup.
The output of the microphone is a 3-pin XLRM-type connector.
A switch permits choice of at response or low-frequency roll-off (via
integral 80 Hz high-pass lter) to help control undesired ambient noise.
The microphone is enclosed in a rugged housing. The included AT8405a
stand clamp permits mounting on any microphone stand with 5/8"-27
threads. A windscreen, two o-rings, a battery and a protective carrying
case are also included.
Operation and Maintenance
The AT8035 requires 11V to 52V phantom power or a 1.5V AA battery for
operation. A battery need not be in place for phantom power operation.
To install the battery, unscrew the lower section of the microphone body,
just below the nameplate. Insert a fresh 1.5V AA battery in the handle
compartment (“+” end up), then reassemble the microphone. Alkaline
batteries are recommended for longest life. Remove the battery during
long-term storage.
Output is low impedance (Lo-Z) balanced. The signal appears across Pins
2 and 3; Pin 1 is ground (shield). Output phase is Pin 2 hot”— positive
acoustic pressure produces positive voltage at Pin 2.
To avoid phase cancellation and poor sound, all mic cables must be wired
consistently: Pin 1-to-Pin 1, etc.
An integral 80 Hz high-pass lter provides easy switching from a at
frequency response to a low-end roll-off. The roll-off position reduces
the pickup of low-frequency ambient noise (such as trafc, air-handling
systems, etc.), room reverberation and mechanically coupled vibrations.
To engage the high-pass lter, use the end tip of a paperclip or other
small pointed instrument to slide the switch toward the “bent” line.
Avoid leaving the microphone in the open sun or in areas where
temperatures exceed 110° F (43° C) for extended periods. Extremely high
humidity should also be avoided.
Note: To use the microphone with a camera-mount microphone holder
whose diameter is too large to secure the microphone, slide the two
supplied o-rings onto the microphone handle, spaced so that one ts
just in front of, and the other ts just behind, the rubber nubs inside the
microphone holder. When the top of the microphone holder is closed and
tightened down, the o-rings should hold the microphone securely in place.
Audio-Technica Corporation
audio-technica.com ©2016 Audio-Technica P51963-01
AT8035
LEGEND
200 Hz
1 kHz
5 kHz
8 kHzSCALE IS 5 DECIBELS PER DIVISION
240˚
180˚
210˚
270˚
300˚
330˚
150˚
120˚
90˚
30˚
60˚
12" or more on axisLEGEND
Frequency in Hertz
Response in dB
10 dB
100
50 200 10k5k1k500 2k 20k
Roll-off
frequency response: 4020,000 Hz
polar pattern
Specications
Fixed-charge back plate, permanently
polarized condenser
Line + gradient
40-20,000 Hz
80 Hz, 18 dB/octave
Phantom: –38 dB (12.5 mV) re 1V at 1 Pa
Battery: –39 dB (11.2 mV) re 1V at 1 Pa
Phantom: 250 ohms
Battery: 300 ohms
Phantom: 132 dB SPL, 1 kHz at 1% T.H.D.
Battery: 120 dB SPL, 1 kHz at 1% T.H.D.
Phantom: 110 dB, 1 kHz at Max SPL
Battery: 98 dB, 1 kHz at Max SPL
72 dB, 1 kHz at 1 Pa
11-52V DC, 2 mA typical
1.5V AA/UM3
0.4 mA / 1200 hours typical (alkaline)
Flat, roll-off
170 g (6.0 oz)
369.0 mm (14.53") long,
21.0 mm (0.83") diameter
Integral 3-pin XLRM-type
SG1
AT8405a stand clamp for 5/8"-27 threaded
stands; 5/8"-27 to 3/8"-16 threaded adapter;
AT8132 windscreen; battery; two o-rings;
protective carrying case
Element
Polar pattern
Frequency response
Low frequency roll-off
Open circuit sensitivity
Impedance
Maximum input sound level
Dynamic range (typical)
Signal-to-noise ratio1
Phantom power requirements
Battery type
Battery current / life
Switch
Weight
Dimensions
Output connector
Audio-Technica case style
Accessories furnished
In the interest of standards development, A.T.U.S.
offers full details on its test methods to other industry
professionals on request.
1 Pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL
1 Typical, A-weighted, using Audio Precision System One.
Specications are subject to change without notice.
To reduce the environmental impact of a multi-language printed document, product information
is available online at www.audio-technica.com in a selection of languages.
An de réduire l’impact sur l’environnement de l’impression de plusieurs langues, les
informations concernant les produits sont disponibles sur le site www.audio-technica.com dans
une large sélection de langue.
Para reducir el impacto al medioambiente, y reducir la producción de documentos en varios
leguajes, información de nuestros productos están disponibles en nuestra página del Internet:
www.audio-technica.com.
Para reduzir o impacto ecológico de um documento impresso de várias linguas, a Audio-Technica
providência as informações dos seus produtos em diversas linguas na www.audio-technica.com.
Per evitare l’impatto ambientale che la stampa di questo documento determinerebbe, le
informazioni sui prodotti sono disponibili online in diverse lingue sul sito www.audio-technica.com.
Der Umwelt zuliebe nden Sie die Produktinformationen in deutscher Sprache und weiteren
Sprachen auf unserer Homepage: www.audio-technica.com.
Om de gevolgen van een gedrukte meertalige handleiding op het milieu te verkleinen, is
productinformatie in verschillende talen “on-line” beschikbaar op: www.audio-technica.com.
www.audio-technica.com
本公司基于减少对环境的影响,将不作多语言文檔的印刷,有关产品信息可在
www.audio-technica.com的官方网页上选择所属语言和浏览。

Especificaciones del producto

Marca: Audio-Technica
Categoría: micrófono
Modelo: AT8035

¿Necesitas ayuda?

Si necesitas ayuda con Audio-Technica AT8035 haz una pregunta a continuación y otros usuarios te responderán




micrófono Audio-Technica Manuales

micrófono Manuales

Últimos micrófono Manuales