Audiovox XM Direct2 Manual de Usario

Audiovox Cables para PC y periféricos XM Direct2

Lee a continuación 📖 el manual en español para Audiovox XM Direct2 (14 páginas) en la categoría Cables para PC y periféricos. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/14
Interface CableInterface Cable
Interface CableInterface Cable
Interface Cable
Installation GuideInstallation Guide
Installation GuideInstallation Guide
Installation Guide
2
Step 1:
Remove the head unit from your dashboard.
Important: Depending on how your head unit was installed you may have to remove
part or all of your dash board before the head unit can be pulled out. You may also have
to remove screws to complete this step.
Note: Before proceeding, make sure that the PIA Adapter has been pro-
grammed. Refer to the PIA Installation Manual. Professional installation
is recommended.
Step 2:
Connect the 34-pin cable connector to the Programmable Interface Adapter (PIA) mating
connector as shown in Figure 1. Slide the rubber strain relief onto the PIA case. Attach the
Car Dock USB connector into the USB receptacle on the PIA. Make sure the connectors are
secure, and slide the top cover onto the bottom housing. (Refer to Figure 2.)
InstallationInstallation
InstallationInstallation
Installation
Figure 1. PIA Cable Interface
Antenna
Pass-Through
Connector
Note: Make sure all cables
are securely connected.
Mating
Connector
Connector
To Head Unit
Mini-Tuner and
Car Dock
Ground Wire
Yellow Wire, 12V Battery
Yellow and
black wire are
optional based
on model.
Left/Right
Audio Cable
Fuse
Left/Right Audio
Cables (Model Specific)
Connector
Installation (Continued)Installation (Continued)Installation (Continued)Installation (Continued)Installation (Continued)
Figure 2. Typical Head Unit, Rear View
Note: The location of the connections on the head unit may vary depending on the
model.
Step 4:
Start your car and turn on your head unit to confirm that the XM Direct system is
properly connected. Please refer to your stereo owners manual on how to access XM
mode. When you tune to XM channel 1, you should see “XM Preview” on your head unit
LCD, and hear that channel through your car speakers. If not, check to make sure all
connections are correct or refer to the troubleshooting section of this installation guide.
Step 5:
Mount and secure the interface cable in a suitable location that will not interfere with
the radio and will not vibrate or rattle after installation.
Step 3:
Connect the end of the cable with the right angle DIN connector and audio cables to
the back of the head unit as shown in Figure 2. The shorter end of the cable coming
from the PIA is a pass-through cable that can be used to connect other products to your
head unit, i.e., CD changer.
3

Especificaciones del producto

Marca: Audiovox
Categoría: Cables para PC y periféricos
Modelo: XM Direct2

¿Necesitas ayuda?

Si necesitas ayuda con Audiovox XM Direct2 haz una pregunta a continuación y otros usuarios te responderán


Cables para PC y periféricos Audiovox Manuales

Audiovox

Audiovox XM Direct2 Manual de Usario

11 Septiembre 2024

Cables para PC y periféricos Manuales

Últimos Cables para PC y periféricos Manuales

Eaton

Eaton SUB-PWRCORD-908 Manual de Usario

18 Octubre 2024
Apc

Apc AR7586 Manual de Usario

8 Octubre 2024
Energy Sistem

Energy Sistem H100 Manual de Usario

2 Octubre 2024
Goobay

Goobay 68874 Manual de Usario

1 Octubre 2024
Goobay

Goobay 61259 Manual de Usario

1 Octubre 2024
Kogan

Kogan KAHBCSPLT4A Manual de Usario

1 Octubre 2024
Digitus

Digitus HD15/HD15 1.8m Manual de Usario

30 Septiembre 2024
Netgear

Netgear AGM731F Manual de Usario

29 Septiembre 2024
Laserliner

Laserliner PersonalCable Manual de Usario

24 Septiembre 2024
Hama

Hama 00200334 Manual de Usario

23 Septiembre 2024