Baumr-AG Hercules HPS2600E Manual de Usario

Baumr-AG partidor de madera Hercules HPS2600E

Lee a continuación 📖 el manual en español para Baumr-AG Hercules HPS2600E (19 páginas) en la categoría partidor de madera. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/19
User Manual
[Revision 6 ].0 July 2022
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY
DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by
this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
Electric Log Splitter - HPS2600E
E&OE © -AG 2 2022 Baumr
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or equipment
d amage may occur.
It is vital that you read and understand this
user manual before using the product,
including safety warnings, and any assembly
and operating instructions. Keep the manual
for future reference.
Safety precautions and recommendations
detailed here must be fully understood and
followed to reduce the risk of injury, fire,
explosion, electrical hazard, and/or property
damage.
Safety information presented here is generic
in nature some advice may not be
applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered or
combustion engine powered.
- Before Use If you are not familiar with the
safe operation/handling of the equipment or
are in any way unsure of any aspect of
suitability or correct use for your
application, you should complete training
conducted by a person or organization
qualified in safe use and operation of this
equipment, including fuel/electrical handling
and safety.
Do NOT operate the equipment in
flammable or explosive environments, such
as in the presence of flammable liquids,
gases or dust. The equipment may create
sparks or heat that may ignite flammable
substances.
Keep clear of moving parts.
Equipment may be a potential source of
electric shock or injury if misused.
Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
Do NOT allow others to use the equipment
unless they have read this manual and are
adequately trained.
- risk Keep packaging away from children
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
General Work Area Safety
Work areas should be clean and well it.
Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
If devices are provided for connecting dust
extraction / collection facilities, ensure
these are connected and used properly.
Dust collection can reduce dust-related
hazards.
General Personal Safety
Wear appropriate protective equipment
when operating, servicing, or when in the
operating area of the equipment to help
protect from eye and ear injury, poisoning,
burns, cutting and crush injuries. Protective
equipment such as safety goggles,
respirators, non slip safety footwear, hard -
hat, hearing protection etc should be used
for appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective equipment.
Do not wear loose clothing or jewellery,
which can be caught in moving parts. Keep
hair and clothing away from the equipment.
Stay alert and use common sense when
operating the equipment. Do not over-
reach. Always maintain secure footing and
balance.
Do not use the equipment if tired or under
the influence of drugs, alcohol or
medication.
This equipment is not intended for use by
persons with reduced physical, sensory or
mental capabilities.
General Fuel Safety
Petrol/fuel/gasoline is extremely flammable
– keep clear of naked flames or other
ignition sources.
Do not spill fuel. If you spill fuel, wipe it off
the equipment immediately if fuel gets on
your clothing, change clothing.
Do NOT smoke near fuel or when
refuelling.
Always shut off the engine before
refuelling.
Do NOT refuel a hot engine.
Open the fuel cap carefully to allow any
pressure build up in the tank to release -
slowly.
Always refuel in well ventilated areas.
Always check for fuel leakage. If fuel
leakage is found, do not start or run the
engine until all leaks are fixed.
General Carbon Monoxide Safety-
Using a combustion engine indoors CAN
KILL IN MINUTES. Engine exhaust
contains carbon monoxide - – a poison you
cannot smell or see.
Use combustion engines OUTSIDE only,
and far away from windows, doors and
vents.
General Equipment Use and Care
The equipment is designed for domestic
use only.
Handle the equipment safely and carefully.
Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorised service centre or technician
before use.
Prevent unintentional starting of the
equipment - ensure equipment and power
switches are in the OFF position before
connecting or moving equipment. Do not
carry equipment with hands or fingers
touching any controls. Remove any tools or
other items that are not a part of the
equipment from it before starting or
switching on.
Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be safer
when used within its design and usage
parameters.
Use the equipment and accessories etc. in
accordance with these instructions,
considering working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
Always keep equipment components
(engines, hoses, handles, controls, frames,
housings, guards etc) and accessories
(cutting tools, nozzles, bits etc) properly
maintained. Keep the equipment clean and,
where applicable, properly lubricated.
Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the equipment
near flammable materials, combustible
gases or liquids etc.
-The equipment is not weather proof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations that
are damp or humid.
Do not clean equipment with solvents,
flammable liquids or harsh abrasives.
For specific equipment safety use and care,
see Equipment Safety.
Electric Log Splitter - HPS2600E
E&OE © -AG 3 2022 Baumr
General Electrical Safety
Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
When wiring electrically powered
equipment, follow all electrical and safety
codes.
Wherever possible, use a residual current
device (RCD).
High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
Do NOT use electrical equipment in wet
conditions or in damp locations.
Do NOT use electrical cords to lift, move or
carry equipment.
Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
Do NOT attempt any maintenance or repair
work not described in this manual.
After use, the equipment and components
may still be hot allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before , changing adjusting
accessories or performing repair or
maintenance.
Do NOT adjust while the equipment is
r unning.
Perform service related activities in suitable
conditions, such as a workshop.
Replace worn, damaged or missing
warning/safety labels immediately.
LOG SPLITTER SAFETY
UNDERSTAND YOUR LOG SPLITTER. Read and understand the owner's manual and labels affixed to the log splitter. Learn its application and
limitations as well as the specific potential hazards peculiar to it
DRUGS, ALCOHOL AND MEDICATION. Do not operate the log splitter while under the influence of drugs, alcohol, or any medication that could
affect your ability to use it properly.
AVOID DANGEROUS CONDITIONS. Put the log splitter on a 60 75cm high, stable, flat, and level work bench where there is plenty of room for -
handling, and help the operator stay alert. Bolt the log splitter to the work surface if it tends to slip, walk, or slide. Keep your work area clean and
well lighted. Cluttered areas invites injuries. Do not use the log splitter in wet or damp areas or expose it to rain. Do not use it in areas where fumes
from paint, solvents or flammable liquids pose a potential hazard.
INSPECT YOUR LOG SPLITTER. Check your log splitter before turning it on. Keep guards in place and in working order. Form a habit of checking
to see that keys and adjusting wrenches are removed from tool area before turning it on. Replace damaged, missing or failed parts before using it.
DRESS PROPERLY. Do not wear loose clothing, gloves, neckties or jewellery (rings, wristwatches). They can be caught in moving parts. Protective
electrically nonconductive gloves and non skid footwear are recommended when working. Wear protective hair covering to contain long hair, -
preventing it from get caught in machinery.
PROTECT YOUR EYES AND FACE. Any log splitter may throw foreign objects into the eyes. This can cause permanent eye damage. Always wear
safety goggles. Everyday eyeglasses have only impact resistant lenses. They are not safety glasses. Do not put the log splitter on the ground for
operations. This is awkward operating position that the operator has to bring his face close to the machine, and thus risks being struck by wood
chips or debris.
EXTENSION CORDS. Improper use of extension cords may cause inefficient operation of the log splitter which can result in overheating. Be sure
the extension cord is no longer than 1 Om and its section is no less than 2.5mm2 to allow enough current flow to the motor. Avoid use of free and
inadequately insulated connections. Connections must be made with protected material suitable for outdoor use.
AVOID ELECTRICAL SHOCK. Check that the electric circuit is adequately protected and that it corresponds with the power, voltage and frequency
of the motor. Check that there is a ground connection, and a regulation differential switch upstream. Ground the log splitter Prevent body contact .
with grounded surfaces: pipes, radiators, ranges, and refrigerator enclosures. Never open the pushbutton box on the motor. Should this be
necessary, contact a qualified electrician. Mark sure your fingers do not touch the plug's metal prongs when plugging or unplugging the log splitter.
KEEP VISITORS AND CHILDREN AWAY. The log splitter must always be operated by one person only. Other people should keep a safe distance
from the work area, especially when the log splitter is operating. Never ask other people to help you with freeing a jammed log.
INSPECT YOUR LOG. Make sure there are no nails or foreign objects in the logs to be split. The ends of the logs must be cut square. Branches
must be cut of flush with the trunk.
DON’T OVERREACH. Floor must not be slippery. Keep proper footing and balance at all times. Never stand on log splitter. Serious injury could
occur if the tool is tipped or if the cutting tools is unintentionally contacted. Do not store anything above or near the log splitter where anyone might
stand on the tool to reach them.
AVOID INJURY FROM UNEXPECTED ACCIDENT. Always pay full attention to the movement of the log pusher. Do not attempt to load the log on
until the log pusher has stopped. Keep hands out of the way of all moving parts.
PROTECT YOUR HANDS. Keep your hands away from splits and cracks which open in the log. They may close suddenly and crush or amputate
your hands. Do not remove jammed logs with your hands.
DON'T FORCE THE TOOL. It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in the specifications
table. This could be dangerous and may damage the machine. Don’t use log splitter for a purpose for which it was not intended.
NEVER LEAVE TOOL RUNNING UNATTENDED. Don't leave tool until it has come to a complete stop.
DISCONNECT POWER. Unplug when not in use, before making adjustments, changing parts, cleaning, or working on the log splitter; Consult
technical manual before servicing.

Especificaciones del producto

Marca: Baumr-AG
Categoría: partidor de madera
Modelo: Hercules HPS2600E

¿Necesitas ayuda?

Si necesitas ayuda con Baumr-AG Hercules HPS2600E haz una pregunta a continuación y otros usuarios te responderán