Black Wolf Turbo Lite Plus 240 Manual de Usario

Black Wolf Carpa Turbo Lite Plus 240

Lee a continuación 📖 el manual en español para Black Wolf Turbo Lite Plus 240 (4 páginas) en la categoría Carpa. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/4

TURBO LITE

PLUS TENT

www.blackwolf.com.au

Congratulations on choosing a BlackWolf Turbo

tent, please read through this instruction booklet

thoroughly before using your new tent.

BEFORE YOUR FIRST CAMPING TRIP

We strongly recommend you pitch your tent before

you take it away for the ﬁrst time to familiarise

yourself with the process and to double check that

all the components are included.

We recommend you weather your tent by hosing it

thoroughly, the stitching in the bound seams will

swell and this will help seal the stitching holes.

Please note and fully understand that no tent can be

guaranteed 100% waterproof. Whilst the fabric your

tent is made from is waterproof in certain weather

conditions such as strong wind and driven rain can

cause some leakage through seams and zippers.

USING YOUR TENT

Always peg out all guy ropes at all times. In cool

weather or high humidity condensation can form

inside your tent. This is not coming through the

fabric but is water vapour that is inside the tent

(created when you breathe and perspire and also

from evaporation o wet items inside your tent).

The best way to minimise condensation is to

maximise ventilation by opening gusseted

windows, vents and doors to allow air to ﬂow

through.

AFTER USE CARE

Where possible clean and dry your tent before

packing it away, if the weather is bad and you have

to pack your tent wet it is important to get it out and

thoroughly dry it as soon as possible. NEVER store

your tent wet, mildew can form on the fabric, pegs

and other components can corrode. After coastal

camping trips it is a good idea to rinse your gear in

fresh water.

Store your tent in a dry, well ventilated place.

COMPONENT LIST

1 x Turbo Lite Plus tent with frame attached

1 x Turbo Lite Plus ﬂy

11 x Guy ropes (already attached to your tent and

packed in ﬁn pockets)

6 x Loose guy ropes for windows

3 x Awning poles & 1 x Awning ridge pole

1 x U-pole (2 x 2 segments, 2 curved poles)

28 x steel pegs in peg bag

1 x Turbo tent bag

TURBO PLUS TENT PITCHING INSTRUCTIONS LITE

STRAPS

WATCH AN ONLINE VIDEO DEMONSTRATION

OF TURBO PITCHING AT www.blackwolf.com.au

1. Choose a ﬂat site, clear away

any sharp sticks or stones that

may damage your tent ﬂoor.

Remove your tent from the

carry bag and unclip the strap

around the tent (put the strap

back in the bag for packing up

the tent). Then unclip the strap

around the top of the frame

that holds the pole bundle

together.

2. Unroll the tent, pull the

corners into position so the

ﬂoor is taught and peg the

corners and the peg out d-rings

at the feet of the Turbo frame.

3. Straighten the legs, the

lower knuckles will lock into

place

4. Un-zip the door and step

inside the tent, push the centre

hub up from underneath, it will

“pop” into position.

5. Take the two, two section

poles and unfold. Thread the

two curved sections through

the pole sleeve on the top of

the rear room from each side

and join them to each other

within the pole sleeve. Attach a

two section pole to one end

with the other end on the

ground towards the Turbo

frame of the tent, then do the

same on the other side. The

pole ends should sit just next

to the tent ﬂoor, pull them

back to increase tension on the

back room until the walls and

roof are taught, the inner is

pitched.

TURBO PLUS TENT PITCHING INSTRUCTIONS LITE - continued

PHOENIX LEISURE GROUP

PO Box 1, Pyrm nt, NS 20 58 o W 09

T : 6 a 9 9622 el 02 9552 900 F x: 02 552

6. Un-fold the ﬂy and lay it over the

tent, the awning is at the front over

the door. Clip the ﬂy in place at the

feet of the Turbo frame and peg out

the rear of the ﬂy using the elastic

loops attached to the ﬂy. Secure the

Velcro loops on the inside of the ﬂy

to the frame. Extend the awning

roof pole and place the curved

spigot into the hole at the front of

the hub.

7. Extend the 3 part awning pole to

approximately the height of the

centre hub and thread the spigot

through the hole in the awning roof

pole and the centre front of the

awning. Extend the roof pole until

the ﬂy fabric is taught then tighten

the black collar to set the length.

8. Extend the 2 part awning poles to

approximately the height of the

upper knuckles and thread the

spigots through the corner eyelets.

Unravel the guy ropes stored in the

zippered ﬁn pockets and peg out at

approximately 45 degrees to the

tent. The centre awning guy rope

should be pegged directly in front of

the tent

Short guy ropes are supplied for

pegging out the gussetted window

ﬂaps for ventilation.

NOTE: IT IS ESSENTIAL THAT THE GUY ROPE FOR THE REAR ROOM IS KEPT

TAUGHT TO STOP WATER POOLING ON THE ROOF. BREAKAGE CAUSED BY NOT

KEEPING THIS GUY ROPE TIGHT WILL NOT BE COVERED BY WARRANTY.

TWIST

Especificaciones del producto

Marca:	Black Wolf
Categoría:	Carpa
Modelo:	Turbo Lite Plus 240
Color del producto:	Zwart
Ancho:	609.6 mm
Profundidad:	81.3 mm
Altura:	57.9 mm
Ancho del embalaje:	680.7 mm
Empaquetadura en profundidad:	142.2 mm
Altura del embalaje:	124.5 mm
Bluetooth:	Ja
Versión Bluetooth:	4.1
Formato de audio soportado:	WAV
Puerto USB:	Ja
Tecnología de conectividad:	Bedraad en draadloos
Número de puertos HDMI:	1
Energía promedio:	- W
Número de hablantes:	2
Salidas de auriculares:	1
Certificados de sostenibilidad:	RoHS
Decodificadores de audio incorporados:	DTS Digital Surround, DTS TruVolume, DTS Virtual:X
Canal de retorno de audio (ARC):	Ja
Servicios de transmisión en red compatibles:	Pandora, Spotify
Canales de salida de audio:	2.0 kanalen
Modo ecualizador:	Movie, Music, Standard
Entrada auxiliar:	Ja
Potencia RMS del altavoz de la barra de sonido:	- W
Entrada óptica de audio digital:	1
Peso de la barra de sonido:	1700 g
Mando a distancia incluido:	Ja
voltaje-de-entrada-de-CA:	100-240 V
Frecuencia-de-entrada-de-CA:	50/60 Hz
Consumo de energía (típico):	60 W