Bogen MPS1 Manual de Usario

Bogen Vocero MPS1

Lee a continuación 📖 el manual en español para Bogen MPS1 (4 páginas) en la categoría Vocero. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/4
© 2010 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2194-01A 1010
MPS1
Mini Pendant Speaker
Models MPS1B /MPS1W
Installation and Use Manual
Power Tap Selection
16-ohm or 70V
The Power Tap selector switch is used to set the
appropriate power level or impedance for your
system. Rotate the switch until the power level
you require lines up with arrow.
IMPORTANT: When connecting to a 70V amplifier,
make sure that the MPS1 Tap Selector switch
IS NOT set in the “16Ω” position.
Speaker Connection and Polarity
Speaker wiring is terminated at a snap-lock input
connector, with a positive and negative terminal.
All wiring should be done prior to installation and
then plugged into the rear of the MPS1. Wire all
speaker polarities the same way.
70V System Configurations
When designing a 70V system, the total of all power tap settings of all the connected
speakers CANNOT EXCEED the output power of the 70V amplifier (amplifier power
can exceed the sum of the speaker loads).
Low-Impedance System Configurations
When wiring together multiple MPS1 speakers that are set to 16 ohms, it is important to
calculate (using Ohmʼs Law) the total load that these speakers present to the amplifier.
The total load impedance of the interconnected speakers cannot be lower than the
minimum load impedance rating of the low-impedance amplifier. Also, care must be
taken to ensure the amplifier cannot overdrive the speakerʼs maximum power rating.
POWER TAP
SELECTOR SWITCH
SNAP-LOCK
WIRING TERMINAL
MPS1
(Top View)
EXAMPLE: 16 + 32 + 8 + 8 + 16 = 80 Watts minimum amplifier output rating.
EXAMPLE: Four 16 -ohm speakers in parallel = 4 ohms. Also in this example,
the maximum amplifier output power rating should not exceed 200W (4 X 50W,
the MPS1 max. power is 50W).
_
_
_
__ +
IMPORTANT:
The MPS1 Mini Pendant is not an outdoor speaker. DO NOT expose the
speaker to rain or moisture. The MPS1 should be installed by qualified personnel.
ALONG WITH THE MAIN DROP CABLE, YOU MUST ALSO USE A
SAFETY CABLE WHEN SUSPENDING AN MPS1 PENDANT SPEAKER.
BE SURE TO SECURE
ALL RIGGING POINTS AND FOLLOW ALL
THE CABLE MANUFACTURER’S
MATERIAL RECOMMENDATIONS
& INSTALLATION INSTRUCTIONS. FAILURE TO DO SO MAY RESULT
IN PROPERTY DAMAGE, INJURY
OR DEATH, AND LEGAL LIABILITY
FOR YOU AND/OR YOUR COM
PANY.
Attach the main drop cable to the MPS1 Main Drop Cable hole in the Suspension
Attachment located on the top of the speaker. This Main Drop Cable will be the primary
connection that will hold all the suspended speakerʼs weight to the anchor point.
Likewise, attach the Safety Cable to the Safety Cable hole in the Suspension Attachment.
This Safety Cable is meant to be a safeguard only, so when attaching to an anchor point
allow for a small amount of slack in the wire, as the Safety Cable should not bear any of
the speakerʼs direct supension weight to keep the speaker hanging level.
MPS1 Speaker Cable Connections
and Suspension Instructions
In addition to the Main suspension Drop Cable,
a backup Safety Cable is required for proper
installation. Use wire rope or other drop line rated
for at least 100 lbs. to ensure a safety
margin.
The attachment point on the structure from which
the speaker is to be anchored also must be able
to handle 100 lbs.
NOTE:
If using suspension cables with a cladding,
be sure to strip away coating where any clamping
device is being used so that bare wire cores of the
cable are being clamped.
MAIN DROP
CABLE HOLE
MPS1
MINI PENDANT
SPEAKER
MPS1 SUSPENSION
ATTACHMENT
SAFETY
CABLE HOLE
MAIN
DROP
CABLE
SAFETY
CABLE
TO SPEAKER
ANCHOR
POINT

Especificaciones del producto

Marca: Bogen
Categoría: Vocero
Modelo: MPS1

¿Necesitas ayuda?

Si necesitas ayuda con Bogen MPS1 haz una pregunta a continuación y otros usuarios te responderán


Vocero Bogen Manuales

Bogen

Bogen AE-2s2 Manual de Usario

29 Septiembre 2024
Bogen

Bogen NEAR S5T Manual de Usario

23 Septiembre 2024
Bogen

Bogen G8G Manual de Usario

20 Septiembre 2024
Bogen

Bogen R8 Manual de Usario

18 Septiembre 2024
Bogen

Bogen MPS1 Manual de Usario

18 Septiembre 2024
Bogen

Bogen OCS1 Manual de Usario

18 Septiembre 2024
Bogen

Bogen NQ-SMS1810-SCG Manual de Usario

14 Septiembre 2024
Bogen

Bogen AFI-8 Manual de Usario

14 Septiembre 2024
Bogen

Bogen CSD1X2 Manual de Usario

10 Septiembre 2024
Bogen

Bogen CSD2X2 Manual de Usario

31 Agosto 2024

Vocero Manuales

Últimos Vocero Manuales

Continental Edison

Continental Edison CELED53HP20V2B4 Manual de Usario

27 Octubre 2024
Canton

Canton Vento 830.2 Manual de Usario

27 Octubre 2024
Jamo

Jamo S7-25C Manual de Usario

27 Octubre 2024
Bowers Wilkins

Bowers Wilkins 707 S2 Manual de Usario

27 Octubre 2024
Monacor

Monacor GLS-301/GR Manual de Usario

27 Octubre 2024
Monitor Audio

Monitor Audio Silver C150 Manual de Usario

26 Octubre 2024
FBT

FBT MITUS 210M Manual de Usario

26 Octubre 2024
CyberData Systems

CyberData Systems SIP 011398 Manual de Usario

26 Octubre 2024
Lamax

Lamax PartyGo1 Play Manual de Usario

26 Octubre 2024
IKEA

IKEA SYMFONISK 405.847.50 Manual de Usario

26 Octubre 2024