Bogen TBL1S Manual de Usario

Lee a continuación 📖 el manual en español para Bogen TBL1S (3 páginas) en la categoría No categorizado. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/3
TBL S1
Transformer Balanced
Line Input Module
Features
Transformer-isolated line level input
Gain/Trim control
Bass and treble
Audio Gating
Gating with threshold and duration adjustments
• Variable signal ducking when muted
Fade back from mute
4 levels of available priority
Can be muted from higher priority modules
Can mute lower priority modules
Pluggable screw terminal strip
Printed in Taiwan.
© 2007 Bogen Communications, Inc.
54-2084-01D 0704
Specifications subject to change without notice.
Gain
Provides control over the level of input signal that can be applied to the
internal signal buses of the main unit. Allows a way to balance the input
levels of various devices so that the main unit controls can be set to
relatively uniform or optimum levels.
Gate - Threshold (Thresh)
Controls the amount of input signal level necessary to turn the module’s
signal output on and mute lower priority modules. Clockwise rotation
increases the necessary input signal level required to produce audio output
and mute lower priority modules.
Ducking (Duck)
Controls the module’s output level when the module is muted or gated.
The range is adjustable from no reduction in level to full muting of the out-
put signal.
Module Installation
1. Turn off all power to the unit.
2. Make all necessary jumper selections.
3. Position module in front of any desired module
bay opening, making sure that the module is
right-side up.
4. Slide module on to card guide rails. Make sure
that both the top and bottom guides are
engaged.
5. Push the module in to the bay until the faceplate
contacts the unit’s chassis.
6. Use the two screws included to secure the mod-
ule to the unit.
WARNING:
Turn off power to unit and make all jumper
selections before installing module in unit.
Jumper Se
Priority Level*
This module can
priority. Priority 1
modules with low
Priority 2 can be
can mute module
Priority 3 can be
modules and can
4 modules are m
ules. Remove all j
*The number of pr
by the amplifier the
Gating
Gating (turning o
insufficient audio
disabled. Detectio
muting lower pr
regardless of this
Bus Assignmen
This module can
mono signal can
B bus, or both bu
600/10K
GATE
ENABLE/
DISABLE
BUS
ASSIGNMENT
BUS A
BUS B
50 Spring Street, Ramsey, NJ 07446, U.S.A.
201-934-8500; Fax: 201-934-9832
www.bogen.com
Block Diagram
Input Wiring
Balanced Connection
Use this wiring when the source equipment
supplies a balanced, 3-wire output signal.
Connect the shield wire of the source signal
to the “G” terminal of the input. If the “+”
signal lead of the source can be identified,
connect it to the plus “+” terminal of the input. If the source lead polarity cannot be identified,
connect either of the hot leads to the plus “+” terminal. Connect the remaining lead to the minus
“-” terminal of the input.
Note: If polarity of the output signal versus the input signal is important, it may be necessary to
reverse input lead connections.
Unbalanced Connection
When the source device provides only an
unbalanced output (signal and ground), the
input module should be wired with the "-"
input shorted to ground (G). The unbal-
anced signal's shield wire is connected to
the input module’s ground and the signal
hot wire is connected to the "+" terminal. Since unbalanced connections do not provide the same
amount of noise immunity that a balanced connection does, the connection distances should be
made as short as possible.

Especificaciones del producto

Marca: Bogen
Categoría: No categorizado
Modelo: TBL1S

¿Necesitas ayuda?

Si necesitas ayuda con Bogen TBL1S haz una pregunta a continuación y otros usuarios te responderán




No categorizado Bogen Manuales

Bogen

Bogen BCIRS Manual de Usario

24 Septiembre 2024
Bogen

Bogen SAX1R Manual de Usario

23 Septiembre 2024
Bogen

Bogen PVMC Manual de Usario

18 Septiembre 2024
Bogen

Bogen VAR1 Manual de Usario

17 Septiembre 2024
Bogen

Bogen AH5A Manual de Usario

17 Septiembre 2024
Bogen

Bogen ADP1 Manual de Usario

17 Septiembre 2024
Bogen

Bogen SPT5A Manual de Usario

17 Septiembre 2024
Bogen

Bogen SPT15A Manual de Usario

17 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales