Bullet SX-3000 Series III Manual de Usario

Bullet Scooter SX-3000 Series III

Lee a continuación 📖 el manual en español para Bullet SX-3000 Series III (21 páginas) en la categoría Scooter. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/21
THE BATTERY MAY A H VE SOME CHARGE ON ARRIVAL, IT IS IMPORTANT
HOWEVER THAT THE BATTERY T IS CHARGED PRIOR O USE.
Colours and designs may vary
User Manual
[Revision 20236 April .0 ]
READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY
VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance,
assembly, inclusions, specifications, description, and packaging.
SX- 3000 Series III Hoverboards
E&OE © 2 2023 Bullet
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or equipment
damage may occur.
It is vital that you read and understand this
user manual before using the product,
including safety warnings, and any assembly
and operating instructions. Keep the manual
for future reference.
Safety precautions and recommendations
detailed here must be fully understood and
followed to reduce the risk of injury, fire,
explosion, electrical hazard, and/or property
damage.
Safety information presented here is generic
in nature – some advice may not be
applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered or
combustion engine powered.
- If you are not familiar with the Before Use
safe operation/handling of the equipment or
are in any way unsure of any aspect of
suitability or correct use for your
application, you should complete training
conducted by a person or organization
qualified in safe use and operation of this
equipment, including fuel/electrical handling
and safety.
Do NOT operate the equipment in
flammable or explosive environments, such
as in the presence of flammable liquids,
gases, or dust. The equipment may create
sparks or heat that may ignite flammable
substances.
Keep clear of moving parts.
Equipment may be a potential source of
electric shock or injury if misused.
Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
Do NOT allow others to use the equipment
unless they have read this manual and are
adequately trained.
Keep packaging away from children - risk
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
General Work Area Safety
Work areas should be clean and well it.
Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
If devices are provided for connecting dust
extraction / collection facilities, ensure
these are connected and used properly.
Dust collection can reduce dust-related
hazards.
General Personal Safety
Wear appropriate protective equipment
when operating, servicing, or when in the
operating area of the equipment to help
protect from eye and ear injury, poisoning,
burns, cutting and crush injuries. Protective
equipment such as safety goggles,
respirators, non-slip safety footwear, hard
hat, hearing protection etc should be used
for appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective equipment.
Do not wear loose clothing or jewellery,
which can be caught in moving parts. Keep
hair and clothing away from the equipment.
Stay alert and use common sense when
operating the equipment. Do not over-
reach. Always maintain secure footing and
balance.
Do not use the equipment if tired or under
the influence of drugs, alcohol, or
medication.
This equipment is not intended for use by
persons with reduced physical, sensory, or
mental capabilities.
General Fuel Safety
Petrol/fuel/gasoline is extremely flammable
– keep clear of naked flames or other
ignition sources.
Do not spill fuel. If you spill fuel, wipe it off
the equipment immediately – if fuel gets on
your clothing, change clothing.
Do NOT smoke near fuel or when
refuelling.
ways shut off the engine before Al
refuelling.
Do NOT refuel a hot engine.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly.
Always refuel in well ventilated areas.
Always check for fuel leakage. If fuel
leakage is found, do not start, or run the
engine until all leaks are fixed.
General Carbon-Monoxide Safety
Using a combustion engine indoors CAN
KILL IN MINUTES. Engine exhaust
contains carbon-monoxide – a poison you
cannot smell or see.
Use combustion engines OUTSIDE only,
and far away from windows, doors, and
vents.
General Equipment Use and Care
The equipment is designed for domestic
use only.
Handle the equipment safely and carefully.
Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage, or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorised service centre or technician
before use.
Prevent unintentional starting of the
equipment - ensure equipment and power
switches are in the OFF position before
connecting or moving equipment. Do not
carry equipment with hands or fingers
touching any controls. Remove any tools or
other items that are not a part of the
equipment from it before starting or
switching on.
Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be safer
when used within its design and usage
parameters.
Use the equipment and accessories etc. in
accordance with these instructions,
considering working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
Always keep equipment components
(engines, hoses, handles, controls, frames,
housings, guards etc) and accessories
(cutting tools, nozzles, bits etc) properly
maintained. Keep the equipment clean and,
where applicable, properly lubricated.
Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the equipment
near flammable materials, combustible
gases, or liquids etc.
The equipment is not weather-proof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations that
are damp or humid.
Do not clean equipment with solvents,
flammable or harsh abrasives. liquids,
For specific equipment safety use and care,
see Equipment Safety.
SX- 3000 Series III Hoverboards
E&OE © 3 2023 Bullet
General Electrical Safety
Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
When wiring electrically powered
equipment, follow all electrical and safety
codes.
Wherever possible, use a residual current
device (RCD).
High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
Do NOT use electrical equipment in wet
conditions or in damp locations.
Do NOT use electrical cords to lift, move or
carry equipment.
Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
Do NOT attempt any maintenance or repair
work not described in this manual.
After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories, or performing repair or
maintenance.
Do NOT adjust while the equipment is
running.
Perform -related service activities in suitable
conditions, such as a workshop.
Replace worn, damaged or missing
warning/safety labels immediately.
Hoverboard Safety
Riding can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. The product can and is
intended to move, and it is therefore possible to lose control, fall-off and/or get into dangerous situations that no amount of care, instruction or
expertise can eliminate. If such things occur, you can be seriously injured or die, even when using safety equipment and other precautions. RIDE
AT YOUR OWN RISK AND USE COMMON- -SENSE AND HEED ALL SAFETY WARNINGS AND SENSE. FAILURE TO USE COMMON
RECOMMENDATIONS INCREASES RISK OF INJURY. USE THE PRODUCT ONLY WITH APPROPRIATE CAUTION AND SERIOUS
ATTENTION TO SAFE OPERATION.
- The recommended minimum rider age of 8 years is an estimate only, and can APPROPRIATE RIDER USE AND PARENTAL SUPERVISION
be affected by the rider’s size, weight or skills. Any rider unable to adequately understand the controls or techniques required to ride the product
should not attempt to ride it. A parent’s decision to allow his or her child to ride this product should be based on the child’s maturity, skill and
ability to follow rule s.
- Rider weight does not necessarily mean a person’s size is MINIMUM RIDER WEIGHT = 20KG / MAXIMUM RIDER WEIGHT = 100KG
appropriate to fit or control of the product, moreover the ability of the product to safely support the loads placed on it due to ride r weight.
MAXIMUM SPEED = 10km/hr.
Acceptable Riding Practices and Conditions
Handle your control, posture, speed etc so that you are able to maintain stability & stopping ability in the event of, loss of traction, loss of power
from any condition such as battery exhaustion, control disruption, disruption of balance, moisture, overload cut-out, protection cut-outs etc. As
with any vehicle or mechanical product, there is always a chance of failure.
Always check and obey any local laws or regulations which may affect the locations where the product may be used. Ride defensively. Watch out
for potential obstacles that could catch the rubber wheels or force you to swerve suddenly or lose control. Avoid pedestrians etc who may enter
your path and respect the rights and property of others.
The product is meant to be used on private property and on closed courses and not on public streets or pavements. Do not ride in any areas
where pedestrian or vehicle traffic is present.
Do not activate the product unless you are in a suitable environment for safe riding.
The product is not for indoor use.
The product is only for recreational use only. Do not use it as a means of transportation.
Do not use the product while under the influence of drugs and/or alcohol.
Do not use the product to carry objects or loads.
This product is manufactured for performance and durability but is not impervious to damage. Stunts or other aggressive riding can over-stress
and damage the product, and the rider assumes all risks associated with how the product is cared for.
Be careful and know your limitations. Risk of injury increases as the degree of riding difficulty increases. The rider assumes all risk associated
with aggressive riding activity.
Never carry passengers or allow more than one person at a time to ride the product.
Never use near steps, drops or bodies of water, such as swimming pools.
Do not use the product on steep inclines, slippery, uneven or rough surfaces.
Keep your fingers and other body parts away from the rubber wheels and all other moving components.
Never use headphones or a phone when riding.
Never hitch the product to another vehicle or person.
Do not ride the product in rain or wet conditions and never immerse the product in water – electrical components may be damaged by water or
create other possible unsafe conditions.

Especificaciones del producto

Marca: Bullet
Categoría: Scooter
Modelo: SX-3000 Series III

¿Necesitas ayuda?

Si necesitas ayuda con Bullet SX-3000 Series III haz una pregunta a continuación y otros usuarios te responderán




Scooter Bullet Manuales

Scooter Manuales

Últimos Scooter Manuales