Cateye Volt1600 Manual de Usario

Cateye Flash Volt1600

Lee a continuación 📖 el manual en español para Cateye Volt1600 (4 páginas) en la categoría Flash. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
HL-EL1010RC
RECHARGEABLE HEADLIGHT
Manual
1. Connect the light unit to your PC or a
commercial USB battery charger using
the USB cable. (Fig 1 1 2).
The switch lights up, and charging
starts.
Switch
button light
On Charging
Slow fl ash Fast charging
Off Charging is
completed
Fast fl ash Charging error
* When your PC is in sleep state, the
unit cannot be charged.
* Use a USB battery charger of 500mAh
(USB2.0) or more. The cartridge can
be fast-charged with high capacity
USB battery charger.
2. After charging is completed, remove
the USB cable, and install the charge
jack cover.
* The battery charges to about 80% after
approximately 12 hours.
* Charging and lighting times are ap-
proximate values, and will vary by
environmental and user conditions.
Before using the light, please read this manual and
the included separate sheet LITHIUM-ION / LITH-
IUM-ION POLYMER BATTERIESthoroughly, and
keep them for future reference.
Rubber pad
Bracket
HOW TO CHARGE1
WARNING!!! / CAUTION!
This light emits an extremely powerful beam equivalent to automo-
bile headlight so it may cause a hazardous situation depending on
the beam angle used. Be sure to direct the light beam downward
so the driver approaching does not get dazzled.
Do not use high mode on public roads.
Before your trip, please make sure the light is fi rmly mounted to the
bracket, it lights up, and the light is not blocked by baggage, etc.
Do not stare at the light when it is illuminating.
Otherwise it may damage your eyesight.
Do not place it within children’s reach.
In preparation for unexpected battery shutoff, we recommend you
carry a spare light.
Mounting the light unit too close to a wireless computer may ad-
versely affect the reading of the computer.
This product is water-resistant under normal daily use and can be
used in the rain. However, do not intentionally submerge it in water.
If the light unit or parts become dirty with mud, etc., clean with a
soft cloth which is moistened with mild soap. Never apply paint
thinner, benzine or alcohol; damage will result.
Dispose of used cartridge batteries appropriately according to lo-
cal regulations.
Before Initial Use
This unit is shipped with a small charge to check the light.
Be sure to charge it before use, according to the instructions
“HOW TO CHARGE”.
1. Mount the bracket to the handlebar.
(Fig 2 1 3)
2.
Insert the light unit into the bracket until
it clicks, and adjust the beam angle. (
4
)
Beam angle adjustment
Turn on the light on a smooth road at
night, and loosen the dial slightly to
move the bracket. Adjust the beam an-
gle so it does not direct to a driver ap-
proaching and
then tighten the
dial rmly to x
the bracket.
3. To remove the light unit, pull out it
forward while pressing down on the
release button ( 5).
CAUTION!:
Be sure to tighten the dial by hand. When
you tighten it too hard with a tool, the
screw thread may be stripped.
Check the dial and screw (*1) on the
bracket periodically, and use them without
any loosening.
Round off the cut edge of the bracket strap
to prevent injury.
OK
NO!
HOW TO MOUNT TO A BICYCLE2
Standard charging time Approx. 9 – 16 h
Strap
Dial
Design Pat. Pending
Copyright© 2015 CATEYE Co., Ltd.
EL101RC-150313
1
Cartridge battery
(BA-6.8)
FlexTight™ bracket
(H-34N)
USB cable
(MICRO USB)
Light unit
To PC or USB
battery charger
Charge jack cover USB cable
*1
Screw
Release button
ENG
12
1
2
3
4 5
Lighting Mode
Remove the cartridge battery according to the procedure.
(See Fig 4 1 4)
To install the cartridge, reverse the procedure.
CAUTION!:
When the operating time decreases signifi cantly, the battery life
is close to an end. Replace the cartridge battery with a new one.
When you store the cartridge battery alone, be sure to install the
cap. Otherwise, damage or a fi re may be caused by short circuit.
WARNING!!!:
Do not use this light on a public road.
The ON/OFF and lighting modes are selected using a switch.
*2 When you turn the light on, it lights up in the last
lighting mode you used. (Mode memory function)
* The light unit may get hot depending on the condition
the light is used in but it is not a malfunction. When it
gets hot, protection circuit activates and it automati-
cally lowers brightness level. One it is cooled down,
the light recovers the previous brightness level.
Remaining battery capacity
When the switch lights up, there is little remaining bat-
tery power.
Light source High-intensity LED x 2
Cartridge battery Li-ion 3.6v 6800 mAH
Charge Micro USB plug
Operating time
Hi : Approx. 2 hours
Middle : Approx. 5 hours
Low : Approx. 15 hours
HyperConstant : Approx. 12 hours
Flash : Approx. 100 hours
* Average runtime at 20˚C.
Standard charging time Approx. 9 – 16 hours
Temperature range Charging : 41˚F – 104˚F (5˚C – 40˚C)
Operating : 14˚F – 104˚F (-10˚C – 40˚C)
Recharge/discharge
number of times
About 300 times
(until the rated capacity drops to 70%)
Dimensions/weight
4-17/32” x 1-47/64” x 2-11/32”
(114.9 x 44.2 x 59.6 mm) / 9.17 oz (260 g)
(Including the cartridge battery)
* The specifi cations and design are subject to change without notice.
SWITCH OPERATION (SWITCHING THE LIGHTING MODE)3
HOW TO REPLACE THE CARTRIDGE BATTERY
4SPECIFICATIONS LIMITED WARRANTY
2-year Warranty: Light unit only
(Deterioration of the cartridge battery is out of warranty)
CatEye products are warranted to be free of defects from materials and
workmanship for a period of 2 years from original purchase. If the product
fails to work during normal use, CatEye will repair or replace the defect at no
charge. Service must be performed by CatEye or an authorized retailer. To
return the product, pack it carefully and enclose the warranty certifi cate (proof
of purchase) with instruction for repair. Please write or type your name and
address clearly on the warranty certifi cate. Insurance, handling and trans-
portation charges to CatEye shall be borne by person desiring service. For
UK and REPUBLIC OF IRELAND consumers, please return to the place of
purchase. This does not affect your statutory rights.
Please register your CatEye product on the website.
http://www.cateye.com/en/support/regist/
SPARE/OPTIONAL PARTS
CO .,LTD.
2-8-25, Kuwazu, Higashi Sumiyoshi-ku,
Osaka 546-0041 Japan
Attn: CATEYE Customer Service Section
Phone: (06)6719-6863
Fax: (06)6719-6033
E-mail: support@cateye.co.jp
URL: http://www.cateye.com
[For US Customers]
CATEYE AMERICA, INC.
2825 Wilderness Place Suite 1200,
Boulder CO 80301-5494 USA
Phone: 303.443.4595
Toll Free: 800.5.CATEYE
Fax: 303.473.0006
E-mail: service@cateye.com
*2
2
.
5
mm
5338827N
FlexTight™ bracket
(H-34N)
5341831N
Helmet mount
5342730
USB cable
(MICRO USB)
5342440
Center fork bracket
(CFB-100)
5342611
Cartridge battery
(Li-ion 3.6v 6800mAH: BA-6.8)
Cartridge battery
Press and hold
Double-click
Click
*2
Press
and hold
Flash
OFF
Switch
ON
Middle HyperConstant
Click Click
Click
ClickClick
Hi Hi
Low
Approx.
2 h
Approx.
5 h
Approx.
15 h
Approx.
12 h
Approx.
100 h
2
3
1
4

Especificaciones del producto

Marca: Cateye
Categoría: Flash
Modelo: Volt1600

¿Necesitas ayuda?

Si necesitas ayuda con Cateye Volt1600 haz una pregunta a continuación y otros usuarios te responderán




Flash Cateye Manuales

Flash Manuales

Últimos Flash Manuales