Chapin 61808 Manual de Usario

Chapin pulverizador de pintura 61808

Lee a continuación 📖 el manual en español para Chapin 61808 (36 páginas) en la categoría pulverizador de pintura. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/36

Model 61808 • 4G/ 15L

011553 R0713

Carefully Read These Instructions Before Use

Chapin International, Inc

P.O. Box 549

700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458

www.chapinmfg.com

WARNING

DO NOT RETURN THIS

SPRAYER TO STORE

Call: 1-800-950-4458

www.chapinmfg.com

WARNING

WARNING: Handling the brass parts of this product will expose you to lead, a chemical

known to the State of California to cause birth defects and other reproductive harm.

Wash hands after handling.

CAUTION

WARNING: Improper use or failure to follow instructions can result in explosive

failure causing serious eye or other injury. For safe use of this product you must read

and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause

pressure build-up resulting in possible explosion. Do not store or leave solution in tank after

use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when

spraying. Never use any tool to remove pump if there is pressure in the pressure chamber.

Never pressurize sprayer by any means other than the original pump. Do not attempt to

modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray

ammable, caustic, acidic, chlorine, bleach or other corrosive solutions or

heat, pressure, or gas producing chemicals. Always read and follow chemical

manufacturer’s instructions before use with this sprayer as some chemicals may

be hazardous when used with this sprayer.

• PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is

securely attached to the shut-off assembly. Insure hose is securely attached to the

pump outlet by tightening hose nut. Insure that all nozzle and wand connections

are tight. Insure the three bolts (underside of base) used to attach the piston

cylinder are tight.

• Do Not exceed a tank solution temperature of 120º F/ 49º C.

NOTE: The tank and hose may have residual water in it due to quality testing

performed on the sprayer.

SK 1158-1

1. Poly

Nozzle Cap

2. Retaining

Nut

3. Nozzle

Body

4. Nozzle

Gasket

5. Elbow

Figure 2Figure 1

Nozzle

Gasket

Retaining Nut

Elbow

Fan Nozzle Tip

APPLICATIONS & USE FOR YOUR SPRAYER

Avoid using a sprayer for general cleaning purposes if plant protection or herbicide chemicals have

already been used in the sprayer. If a sprayer has been used for plant protection or as an herbicide, clean

the sprayer completely (see cleaning section) before using.

Plant Food: Use different spray patterns for optimum foliage feeding or for fungicide and pesticide

application.

Herbicides: Reduce weeds and unwanted plants but avoid using the same sprayer for plant feeding or

protection without thoroughly cleaning (see cleaning section) the sprayer ﬁrst.

General Household Use: Apply detergents, cleaning solutions, warm water (do not exceed

120°F/49°C) or nontoxic household cleaning chemicals for carpets, ﬂoors, walls, glass, counter tops and

ceilings. DO NOT use sprayer that has been used with herbicides, pesticides or other toxic chemicals for

household applications.

General Outdoor Use: Use the sprayer for cleaning windows or with a detergent for general purpose

cleaning.

SPRAYER COMPONENTS & USE INFORMATION

NOZZLE ASSEMBLY

Figure 1

Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the

elbow (5). Unscrew the retaining nut . Push the nozzle body (2) (3) (4) with the nozzle gasket out of

the retaining nut . To reinstall the nozzle, reverse the above instructions.(2)

Figure 2

Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining

nut. To reinstall the nozzle, reverse the above instructions.

Especificaciones del producto

Marca:	Chapin
Categoría:	pulverizador de pintura
Modelo:	61808
Color del producto:	Zwart
Pantalla incorporada:	Ja
Peso.:	4400 g
Ancho:	320 mm
Profundidad:	75 mm
Altura:	190 mm
Interruptor encendido / apagado:	Ja
Tecnología de conectividad:	Bedraad
Audio-ingan (L, R):	1
Energía promedio:	30 W
Entrada de voltaje CC:	24 V
Destinado a:	Thuis
Salida de audio (izquierdo, derecho):	1
Canales de salida de audio:	- kanalen
Relación señal-ruido:	- dB
Distorsión Armónica Total (THD):	- procent
XLR en:	Ja
salida XLR:	1
voltaje-de-entrada-de-CA:	220 V
Potencia máxima por canal:	60 W
Sincronización de impedancia de entrada:	4 Ohm
Tipo de conectividad de los altavoces:	3.5mm
Entradas de línea (RCA):	1
Salidas de línea (RCA):	1
Impedancia de salida:	8 Ohm
Salida de potencia RMS por canal (1 ohmio):	30 W