Conair CS43N Manual de Usario

Lee a continuación 📖 el manual en español para Conair CS43N (2 páginas) en la categoría plancha de pelo. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety pre-
cautions should always be followed, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
- Any appliance is electrically
live even when the switch is off. To reduce
the risk of death by electric shock:
1. Always unplug appliance immediately after
using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquid.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING
- To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Do not pull, twist, or wrap line cord around
appliance.
3. This appliance should not be used by, on
or near children or individuals with certain
disabilities.
4. Use this appliance only for its intended use,
as described in this manual. Do not use attach-
ments not recommended by the manufacturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped or damaged,
or dropped into water. Return the appliance to
an authorized service center for examination
and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Unit is hot when in use. Do not let heated
surface touch eyes or bare skin.
11. Do not place the heated unit directly on
any surface while it is hot or plugged in.
12. Never block the air openings of the appli-
ance or place on a soft surface such as a bed
or couch, where the air openings may be
blocked. Keep the air opening free of lint and
other debris.
13. Do not use an extension cord with this
appliance.
14. Do not touch hot surfaces of the appli-
ance. Use handles or knobs.
15. Do not attempt to touch the housing of
your appliance near the straightening plates,
as it is hot when in use.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron is intended for house-
hold use. Use on Alternating Current (60 hertz)
only. This unit is designed to be operated at
120 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat
this safety feature.
TO STRAIGHTEN HAIR
Hair should be clean and completely dried
before using the straightening iron. Plug the
iron into an electrical outlet. Turn on unit. The
Power/Low 285ºF and Ion On settings will
become illuminated.
To turn off, press Off button (lights will go off).
Never leave your straightening iron on and
unattended. However, should you fail to turn
the unit off it will shut itself off automatically
within 60 minutes.
WARNING: The straightening iron's nano
silver tourmaline ceramic-coated plates
will get very hot within a few seconds
and should not be placed in contact with
the skin after the straightening iron has
been turned on.
STYLING WITH THE NANO SILVER
TOURMALINE CERAMIC COATED PLATES
Your new straightening iron features nano
technology – micro particles that create
stronger bonds to plate surfaces, for smoother
glide, maximum manageability and more
professional results.
NANO SILVER TECHNOLOGY combines the
technology of micro particles of ceramic
and silver for clean, beautiful, healthy
looking results.
The Nano Silver Tourmaline Ceramic™
Technology combines all that is best for your
hair. Nano silver’s unique properties leave
hair cleaner, shinier and healthier looking.
Tourmaline emits infrared heat for gentle styl-
ing, and natural ions that reduce frizz, help
smooth down flyaways and renew the vitality
of your hair. And ceramic generates gentle
infrared energy and evenly distributes heat to
protect hair from damage. Whatever style you
create, this trio of technologies leaves your
hair with a salon-perfect, silky smooth finish.
USING INSTANT HEAT, THE 5 ULTRA-
HIGH HEAT TEMPERATURE SETTINGS
& UNIFORM HEAT RECOVERY SYSTEM
This styling iron features a ceramic heater
that maintains high temperatures during use
for precision styling. It heats up quickly to the
temperature you’ve selected for your hair type.
This Instant Heat technology has 5 ultra-high
temperature settings. There is a temperature
range thats gentle and safe for every type of
hair, from the finest to the curliest and most
resistant, and helps you create the look you
want. And thats not all. Conair’s professional
salon standards of engineering provide you
with a uniform and improved heat recovery
system that maintains the iron at constant
temperatures. There is a constant surge of
power to ensure that heat is continuously and
quickly delivered for optimal styling results,
unlike other units, which lose heat during
use. This provides consistent styling power so
that every strand of your hair is set with the
same level of heat and comes out the same
way for a perfect finish.
THE IONIZING FUNCTION generates a cloud of
negative ions that can:
• neutralize the generally positive charge on
flyaway, frizzy hair
• eliminate static electricity
• contribute to shine
The new Nano Silver Tourmaline Ceramic™
Technology makes this straightener a pleasure
to use – styling has never been easier! Get
ready to experience salon results without
the salon!
INSTANT HEAT TECHNOLOGY
The iron’s unique high temperature settings and
Instant Heat technology provide styling versatil-
ity for all hair types. If you have fine hair, a low
temperature will provide the best results. If you
have thick, wavy or hard-to-straighten hair,
keep the heat setting on high. You can vary the
iron’s temperature according to your particular
need by scrolling the
temperature settings using the +/– buttons.
For best results, use a light styling product
before blow-drying hair. Start with a hair
section that is 1 ½" wide and no more than
½" thick. Open the iron and place a hair
section between the two hot plates, close
to the scalp. Trap hair between the plates by
firmly squeezing the handles together. While
maintaining the tension, slowly pull the unit
down along the hair section toward the end
of hair. At the end of hair section, release
the pressure on the handle and allow the
hair section to slide out. Repeat process on
additional sections of hair until you achieve
the hair style you desire. It may be necessary
to repeat process on certain areas, depending
on the texture of your hair.
As you straighten your hair, you’ll find that
it glides more easily over the micro-bonded
plate surfaces, and any residue from styling
products is easy to remove.
Some experience is necessary when learning
to use this straightening iron. After using the
iron several times, you will learn the ideal
way to straighten and style your hair.
Temperature Setting Guide
LED TEMP. CONTROL HAIR TYPE
Power/Low 285ºF-310ºF
Delicate, thin, easy-to-straighten hair
Medium 330 Fº Average-to-thick or treated hair
Med-High 360ºF Thick or wavy hair
High/Max 395ºF Hard-to-
straighten
hair
WARNING:
IF YOU THINK THE
POWER IS OFF WHEN
THE SWITCH IS OFF
YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are
a dangerous combination. But did you know
that an electric appliance is still electrically
live even if the switch is off? If the plug is in,
the power is on. So when you are not using
your appliances, keep them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
USER
MAINTENANCE
Your straightening iron is virtually maintenance-
free. No lubrication is needed. Keep all vents
and openings clear of dirt and dust. If cleaning
becomes necessary, disconnect the unit from
the power source, allow to cool and wipe
exterior with a cloth. If any abnormal condition
occurs, unplug the unit, allow it to cool, and
return it for repair to an authorized service
representative only. No repairs should be
attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be
pulled, twisted, or severely bent. Never wrap
the cord tightly around the appliance. Damage
will occur at the high flex point of entry into
the appliance, causing it to rupture and short
circuit. Inspect the cord frequently for damage.
Stop use immediately if damage is visible or if
unit stops or operates intermittently.
STORAGE
When not in use, your appliance is easy to
store. Allow appliance to cool, then simply
store in heat-resistant pouch out of reach of
children in a safe, dry location. Do not jerk
or strain cord at plug connections. Do not
wrap the line cord around the appliance. Allow
the cord to hang or lie loose and straight at
the point of entry into the appliance.
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair
® or Infiniti by Conair®
product call 1-800-3-CONAIR or visit us on the web
at: www.conair.com/infiniti
©2007 Conair Corporation
150 Milford Road, East Windsor, NJ 08520
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
Patent Pending
LIMITED FIVE-YEAR WARRANTY
Conair will repair or replace (at our option)
your unit free of charge for 60 months from
the date of purchase if the appliance is
defective in workmanship or materials.
To obtain service under this warranty, return
the defective product to the service center
listed below, together with your purchase
receipt and $5.00 for postage and handling.
California residents need only provide proof
of purchase and should call 1-800-3-CONAIR
for shipping instructions. In the absence of a
purchase receipt, the warranty period shall
be 60 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED
IN DURATION TO THE 60-MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how
long an implied warranty lasts, so the above
limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH
OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some
states do not allow the exclusion or limitation
of special, incidental, or consequential dam-
ages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights,
and you may also have other rights, which
vary from state to state.
GET TO KNOW YOUR STRAIGHTENING IRON
07NP144 IB-7770
1" (25 mm)
Nano Silver
Tourmaline Ceramic
straightening plates
Temperature
and ion on
LED
5 ultra-high
heat settings
395°F/202°C
Extra-long
swivel line cord
Ionic technology
25% longer
plates for
faster styling*
Auto off
1" Straightener
Nano Silver
Tourmaline
Ceramic
Styler
Instruction
& Styling
Guide
For your safety
and continued
enjoyment of this
product, always
read the instruction
book carefully
before using.
Model CS43
Fold and snap closed to store hot styling
iron safely.
Iron on One Side
Cord on Other Side
2 In 1 Heat-Resistant
Storage Pouch and Counter Mat
Open mat to protect counters from heat
while styling.
Divider separates power cord from iron
for immediate, safe storage.
Power On
button
* When compared to other Conair
® straighteners

Especificaciones del producto

Marca: Conair
Categoría: plancha de pelo
Modelo: CS43N

¿Necesitas ayuda?

Si necesitas ayuda con Conair CS43N haz una pregunta a continuación y otros usuarios te responderán




plancha de pelo Conair Manuales

plancha de pelo Manuales

Últimos plancha de pelo Manuales