Conair GlideLite GI305 Manual de Usario

Conair Strijkijzer GlideLite GI305

Lee a continuación 📖 el manual en español para Conair GlideLite GI305 (2 páginas) en la categoría Strijkijzer. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
11. We recommend you do not use an extension
cord to operate this appliance. If an
extension cord is absolutely necessary, a 15
ampere-rated cord should be used. A cord
rated for less amperage can result in a risk
of fire or electric shock due to overheating.
Care should be taken to arrange the cord so
that it cannot be pulled or tripped over.
12. Surfaces of this appliance are hot when in
use. Do not let heated surfaces touch eyes
or skin.
13. Do not place the soleplate directly on any
surface or on the appliance power cord
while the iron is hot or plugged in.
14. The plug must be removed from the
electrical outlet before the water reservoir is
filled with water.
15. Do not operate steam or spray function
without properly filling the water tank with
water.
16. The iron should always be turned off
before plugging in or unplugging from
an outlet. Never yank cord to disconnect
from outlet; instead, grasp plug and pull to
disconnect.
17. Burns could occur from touching hot metal
parts, hot water, or steam. Use caution
when turning a steam iron upside down to
empty water, as there may be hot water in
the reservoir.
18. If you need to clean the iron, unplug and
allow to cool. Use a slightly damp cloth and
wipe down the outside of the iron. DO NOT
use cleaning agents or place the iron in
water or cleaning fluids.
19. Do not hold hand in front of steam.
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, especially when children
are present, basic precautions should always be
taken, including the following:
READ ALL
INSTRUCTIONS
BEFORE USING
DANGER Any appliance is electrically
live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after use and before cleaning.
2. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
3. Do not place in or drop into water or other
liquids.
4. Do not reach for an appliance that has fallen
into water. Unplug immediately.
5. Use only in a dry area.
WARNING To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. Children should be supervised to ensure
that they do not play with the appliance.
2. This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
3. The iron must not be left unattended while it
is connected to an electrical outlet.
4. Use this appliance only for its intended use
as described in this manual. Do not use
attachments not recommended by Conair.
5. The iron must be used and rested on a
stable surface.
6. Do not operate the iron with a damaged
cord or in the event the iron has been
dropped or damaged. To avoid the risk
of electric shock, do not disassemble
the iron. Instead, take it to a qualified
Service Center for examination and
repair. Incorrect assembly might result
in the risk of electric shock when the
iron is used after reassembly. If the
supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
7. Do not allow cord to touch heated surfaces.
Do not pull or twist cord. Let appliance cool
completely before emptying or putting away.
Wrap the cord loosely around the iron base
when storing.
8. This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
9. Never drop or insert any object into any
opening.
10. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
20. To reduce likelihood of circuit overload, do
not operate another high-wattage appliance
on the same circuit.
21. Never steam or iron clothes that are
being worn.
22. When emitting steam, this appliance may
cause burns if it is used too close to the
skin or eyes or if it is used incorrectly.
To reduce the risk of contact with hot
water emitting from the steam vents, test
appliance before use by holding it away
from the body.
23. When placing the iron on its base, ensure
that the surface on which the base is
placed is stable.
24. The iron is not to be used if it has been
dropped, if there are visible signs of
damage or if it is leaking.
25. Always disconnect the iron from the
electrical outlet before filling the reservoir
with water, before emptying the water from
the reservoir, and when the iron is not in
use.
26. Close supervision is required for any
appliance used by or near children. Do not
leave the iron unattended while the iron is
plugged in or on an ironing board.
SAVE THESE
INSTRUCTIONS
IMPORTANT
FOR HOUSEHOLD USE ONLY
DO NOT let children use the appliance.
DO NOT let untrained persons use the
appliance without supervision.
NEVER immerse the iron, cord or plug in any
liquids.
DO NOT leave the hot iron touching fabrics or
inflammable surfaces.
DO NOT leave the appliance unnecessarily
plugged in. Disconnect the plug from the outlet
when the appliance is not being used.
NEVER touch the appliance with wet or damp
hands.
DO NOT use the power cord or the appliance to
pull the plug out of the outlet.
DO NOT leave the appliance exposed to the
weather (rain, sun, etc.).
DO NOT leave the iron without supervision when
it is connected to the power supply.
DO NOT fill the reservoir with water before
removing the plug from the outlet.
PLEASE NOTE!
Do not use chemical additives, scented
substances or decalcifiers in the reservoir.
Failure to comply with the above-mentioned
regulations will lead to the loss of warranty.
OPERATING
INSTRUCTIONS
PREPARING FOR FIRST USE
Before first use, remove all labels from the
soleplate and housing. Plug iron in. Turn the
iron on, allow to heat up, then turn the iron off.
Unplug iron.
When using the iron for the first time, you may
notice a slight emission of smoke and hear some
sounds made by the expanding plastics. This
is quite normal and will stop after a short time.
We also recommend passing the iron over an
ordinary cloth before using it for the first time.
This GlideLite Iron features advanced One-Temp
Technology. No settings are needed. The iron is
safe and effective on all fabric types.
FILLING THE RESERVOIR
1. The reservoir can be filled with ordinary tap
water. But distilled or demineralized water
is preferred.
a. Open the water reservoir door.
b. Using a clean measuring cup, slowly fill
the reservoir until the water reaches the
max fill indicator. DO NOT OVERFILL.
c. Close water reservoir door.
d. Wipe off any water that may have spilled
on the outside of the iron with a soft clean
cloth.
Please Note:
DO NOT use chemical additives, scented
substances or decalcifiers in the water
reservoir. Failure to comply with this
regulation will lead to the loss of warranty.
2. Set the iron on a stable, flat surface. We
recommend using a quality ironing board
as the pressing surface. Be sure to give
yourself enough room to maneuver the
iron when pressing.
3. Plug in the iron. Make sure that no other high-
wattage appliances are plugged into the same
circuit.
4. Press the Power button. A blue light will
blink for 30 seconds while heating. The iron
is ready to use when blue light turns solid.
5. There are no temperature or fabric-type
settings to select. One-Temp Technology
safely removes wrinkles with one setting
thanks to powerful steam.
6. If steam is desired, press the One-Touch
Steam button. For stubborn wrinkles,
press the Turbo Steam button to get a
turbocharged amount of steam. The iron
will only release steam when it’s in the
horizontal position.
7. After use, turn iron off, unplug, and let it cool
for 10 minutes before putting it away.
3-WAY AUTO OFF
As a safety feature, your iron will turn off
automatically if left in the upright position and
not moved for 8 minutes. It will also turn off
automatically if left in the horizontal position or
left or right side positions and not moved for
30 seconds. In these instances, the blue light
will flash.
STEAM FUNCTIONS
For steam, press the One-Touch Steam button.
For stubborn wrinkles, press the Turbo Steam
button. Steam can be released only when the
iron is in a horizontal position. When the iron
is in a vertical position, the steam function will
LIMITED ONE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 12 months from the date
of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return the
defective product to the service center listed
on back, together with your purchase receipt.
California residents need only provide proof of
purchase and should call 1-800-3-CONAIR for
shipping instructions. In the absence of a
purchase receipt, the warranty period shall be
12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS,
OR LIABILITIES, INCLUDING BUT NOT LIMITED
TO THE IMPLIED WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN
DURATION TO THE 12-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY. Some
states do not allow limitations on how long an
implied warranty lasts, so the above limitations
may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
23PA088283 IB-18085
Service Center
Conair LLC
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair® product, call
1-800-3-CONAIR or visit us on the web at
www.conair.com
Please register this product at
register.conair.com
©2024 Conair LLC
Glendale, AZ 85307
Made in China
Instruction
Booklet
For your safety and
continued enjoyment
of this product, always
read the instruction
book carefully
before using.
All GI305 Models
Spray Nozzle
Easy-to-fill
Water
Reservoir
Power
indicator
Power
button
Flexible
Cord
Base
Water
Spray
button
Ceramic-Coated
Aluminum Soleplate
Turbo
Steam
button
Self-Clean
button
GET TO KNOW YOUR GLIDELITE PROFESSIONAL SERIES
1450-WATT IRON (MODEL GI305)
SELF-CLEANING DIRECTIONS:
Fill the reservoir up to the maximum level
indicated and hold the iron horizontally over
the sink.
Plug in the iron and press the Power button.
A blue light will blink for 30 seconds and then
turn solid. Make sure the Steam button is off
and remains off.
Hold Self-Clean button for 3 seconds to enter
the self-clean mode.
Blue light will flash for approximately 2
minutes while in self-cleaning mode.
When blue light is solid, cleaning has finished
and the unit has entered normal mode.
Turn iron off, unplug from outlet. When
soleplate has cooled, you may clean it with
a damp cloth.
HOW TO STORE
Disconnect the plug of the iron from
the outlet.
Let the iron cool down completely.
Empty the water reservoir by turning the
iron upside down over a sink and gently
shaking it.
Always put the iron away in a vertical
position with the cord wrapped loosely
around the base.
One-Touch
Steam
button
IRON
GLIDELITE
TM
Ironing Made Effortless
shut off automatically, and the white steam
light will flash.
ANTI-DRIP SYSTEM
With the Anti-Drip System, you can perfectly
iron even the most delicate fabrics. It prevents
water from dripping out of the soleplate when
the temperature is too low.
DRY IRONING
To iron without steam, do not press the
One-Touch Steam button.
SPRAY FUNCTION
Make sure that there is water in the reservoir.
(See Filling the Reservoir.) Press the Water
Spray button slowly for a dense spray or
quickly for a vaporized spray.
WARNING: For delicate fabrics, we recommend
moistening the fabric beforehand using the
spray function or putting a damp cloth between
the iron and the fabric.
To avoid staining, do not use the spray on silk
or synthetic fabrics.
CLEANING
Please Note: Before cleaning the iron in any
way, make sure that the appliance plug is not
connected to the outlet.
Any deposits or starch residue left on the
soleplate can be removed using a damp cloth
or a nonabrasive liquid detergent after the iron
has cooled.
Avoid scratching the soleplate with steel wool
or metallic objects.
The plastic parts can be cleaned with a damp
cloth, then wiped with a dry cloth.
SELF CLEANING
The self-cleaning feature cleans inside the
soleplate, removing impurities. We recommend
using this function every 1015 days.

Especificaciones del producto

Marca: Conair
Categoría: Strijkijzer
Modelo: GlideLite GI305

¿Necesitas ayuda?

Si necesitas ayuda con Conair GlideLite GI305 haz una pregunta a continuación y otros usuarios te responderán




Strijkijzer Conair Manuales

Strijkijzer Manuales

Últimos Strijkijzer Manuales