Electrolux RM 123E Manual de Usario
Electrolux
Enfriamiento congelación
RM 123E
Lee a continuación 📖 el manual en español para Electrolux RM 123E (16 páginas) en la categoría Enfriamiento congelación. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/16
OPERATING AND INSTALLATION INSTRUCTIONS
FOR ELECTROLUX REFRIGERATORS
TYPE A310 K
MODEL RM 123E
(Bottled Gas and 12 / 230 Volt Operation)
MODEL RM 122F
(Bottled Gas and 12 Volt Operation)
IMPORTANT USER INFORMATION
It most important that this instruction book should be retained with the appliance for future
reference. Should the appliance be sold or transferred to another owner, always ensure that the
book is supplied with the appliance in order that the new owner can be acquainted with the
functioning of the appliance and the relevant warnings.
These warnings are provided in the interest of safety. You must read them carefully
before installing or using the appliance.
• This product is designed to be operated by adults. Children should not be allowed to tamper with the controls or
play with the product.
• Any electrical work required to install this appliance should be carried out by a qualified electrician.
• This product should be serviced by an authorised Electrolux Service Engineer, and only genuine Electrolux spare
parts should be used.
• It is dangerous to alter the specifications or modify this product in any way.
• Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
• Electrolux refrigerators are designed to be used specifically for the storage of edible foodstuffs only.
• There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure
to do this will result in component failure and possible food loss. See installation instruction.
• Parts which heat up should not be exposed, Wherever possible the back of the product should be close to a wall
but leaving the required distance for ventilation as stated in the installation instructions.
• Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it.
• The ice box in this appliance contains tubes through which the refrigerant passes. If these are punctured this would
cause substantial damage and result in food toss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice.
Under no circumstances should solid ice be forced off the ice box. Solid Ice should be allowed to thaw when
defrosting the appliance. See defrost instructions.
• The appliance should be left fort hours after installation before it is turned on in order to allow refrigerant to settle,
unless it is of the absorption type in which case it can be turned on immediately.
• This appliance is heavy. Care should be taken when moving it.
• Ice lollies can cause frost burns if consumed straight from the freezer.
• Frozen food must not be refrozen once it has thawed out.
• Manufacturers' food storage recommendations should. be strictly adhered to. Refer to relevant instructions.
• Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container which may cause it to
explode resulting in damage to the appliance.
• Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced
persons may cause injury or more serious malfunctioning. Refer to your local Electrolux Service Centre and always
insist on genuine Electrolux spare parts.
GENERAL GUIDE TO FITTING ANY PLUG
• Ensure the lengths of wire inside the plug are prepared correctly.
• Connections should be firmly made after all conductor strands are entered into the terminal posts.
• When preparing the cable ends take care not to damage the outer sheath, or the insulation surrounding the inner
conductors.
• Tighten all screws.
• Replace the top cover of the plug and secure.
INSTRUCTIONS FOR INSTALLATION
1. INTRODUCTION
Before starting to install the refrigerator, please read these instructions carefully in order to obtain a thorough
understanding of what is required.
When operating, heat is emitted from parts of the cooling unit at the rear and this has to be carried away by air
circulating freely over the back of the refrigerator. To ensure sufficient air circulation for satisfactory operation, it Is
essential that the clearances called for in these instructions are not reduced in any way otherwise cooling performace
will be impaired. Providing the refrigerator is Installed in accordance with these instructions, it should operate
satisfactorily in ambient temperatures up to $2°C (90°F), with some measure of cooling up to about 35°C (95'F).
It is recommended that the refrigerator is installed by the caravan manufacturer, the supplier or another qualified
person. Owners who are competent to carry out the work themselves can do so, but, for the sake of safety, they must
take particular care in making the gas connections, checking for leaks, and installing the electrical wiring and fittings. All
relevant regulations concerning such installations must be complied with.
Many caravans are already provided with a recess, usually in the form of a cupboard which has been specially designed
so that it can be adapted, by removal of its door and shelves, to house a refrigerator. Some caravan manufacturers
have also devised kits of parts to aid installation of refrigerators in their particular caravans.
A ventilator for fitting above the door as shown in fig. 4 is supplied with the refrigerator. The connection pipe, gas cock,
and connectors are not supplied by Electrolux as the sizes of these may vary to suit particular installations. The
appropriate parts should, however, be readily available from the refrigerator supplier or an Agent dealing in gas fittings
{see note in item 11).
The refrigerator weighs approximately 14.5 kg (321b) and the surface on which it is installed must be capable of
carrying this weight, plus that of the food, satisfactorily.
All surfaces above and adjacent to the flue outlet, and beside and below the burner housing should be of, or covered
with, metal or other non-flammable material -
IMPORTANT: On motorised vehicles, the refrigerator must be installed well away from fuel tanks, fuel filling inlets, pipes
leading from inlets to fuel tanks, and fuel tank breathers.
WARNING:
Because of the hazards associated with the use of continuous operating bottled-gas appliances with openflame burners
in difficult-to-ventilate confined spaces, and other considerations, Electrolux do not recommend the installation of their
bottled-gas caravan refrigerators on boats, and refrigerators so installed will not be covered by the Company's guarantee.
if however, a boat installation is planned for the refrigerator, reference should be made to British Standard 5482
Part 3, 1979 and to the Thames Water Authority 'Launch Digest’ and 'Launch- Specification’
Also, current Guide Lines published by local Water Authorities, or the $hip and Boat Builders' National
Federation.
It should be noted that special Marine Refrigerators are available from Electrolux for use on boats.
2. VENTILATION
The refrigerator will always be built into a recess but to enable the unit to operate efficiently, it is essential that air is
allowed to circulate freely over the cooling unit at the back to carry away the heat generated during the cooling process
(see fig. 1). The minimum free spaces called for under, behind and over. the cabinet must not, therefore, be reduced in
any way. The more space provided, particularly behind and over the cabinet, the better the performance you can expect
from the cooling unit.
3. IMPORTANCE OF LEVELLING
The downward circulation of refrigerant within the cooling unit is by gravity and the refrigerator has lobe reasonably
level, when it is stationary, for the cooling' unit to operate properly. If the refrigerator is left operating with a sustained list
in excess of about 3' in any direction, pockets of liquid refrigerant can collect at various points within the unit impairing
or preventing normal circulation of the refrigerant vapour until level conditions return. It is essential, therefore, that the
refrigerator is installed so that the ice-tray shelf inside the refrigerator is level in relation to the caravan, in both
directions, so that when the caravan is level, the ice-tray shelf is level.
Especificaciones del producto
| Marca: | Electrolux |
| Categoría: | Enfriamiento congelación |
| Modelo: | RM 123E |
¿Necesitas ayuda?
Si necesitas ayuda con Electrolux RM 123E haz una pregunta a continuación y otros usuarios te responderán
Enfriamiento congelación Electrolux Manuales
22 Octubre 2024
21 Octubre 2024
16 Julio 2024
15 Julio 2024
15 Julio 2024
15 Julio 2024
15 Julio 2024
15 Julio 2024
15 Julio 2024
14 Julio 2024
Enfriamiento congelación Manuales
- Enfriamiento congelación Candy
- Enfriamiento congelación Samsung
- Enfriamiento congelación ATAG
- Enfriamiento congelación Bosch
- Enfriamiento congelación AEG
- Enfriamiento congelación Bauknecht
- Enfriamiento congelación BEKO
- Enfriamiento congelación Daewoo
- Enfriamiento congelación Etna
- Enfriamiento congelación Grundig
- Enfriamiento congelación Indesit
- Enfriamiento congelación Inventum
- Enfriamiento congelación Liebherr
- Enfriamiento congelación Miele
- Enfriamiento congelación Medion
- Enfriamiento congelación Quigg
- Enfriamiento congelación Siemens
- Enfriamiento congelación Whirlpool
- Enfriamiento congelación Zanussi
- Enfriamiento congelación Zanker
- Enfriamiento congelación Acec
- Enfriamiento congelación Amica
- Enfriamiento congelación Alno
- Enfriamiento congelación Amana
- Enfriamiento congelación Aga
- Enfriamiento congelación Ardo
- Enfriamiento congelación La Sommeliere
- Enfriamiento congelación Techwood
- Enfriamiento congelación Teka
- Enfriamiento congelación Zanussi-electrolux
- Enfriamiento congelación Ignis
- Enfriamiento congelación OK
- Enfriamiento congelación Hisense
- Enfriamiento congelación Hanseatic
- Enfriamiento congelación Blomberg
- Enfriamiento congelación Junker
- Enfriamiento congelación Gram
- Enfriamiento congelación Frigidaire
- Enfriamiento congelación Iberna
- Enfriamiento congelación PKM
- Enfriamiento congelación Frilec
- Enfriamiento congelación Dometic
- Enfriamiento congelación Igloo
- Enfriamiento congelación Trebs
- Enfriamiento congelación Inventor
- Enfriamiento congelación Koenic
- Enfriamiento congelación Haier
- Enfriamiento congelación H.Koenig
- Enfriamiento congelación WLA
- Enfriamiento congelación Everglades
- Enfriamiento congelación Qlima
- Enfriamiento congelación WhiteLine
- Enfriamiento congelación Respekta
- Enfriamiento congelación M-System
- Enfriamiento congelación Atlantic
- Enfriamiento congelación Saro
- Enfriamiento congelación Scandomestic
- Enfriamiento congelación V-Zug
- Enfriamiento congelación Stoves
- Enfriamiento congelación Avintage
- Enfriamiento congelación Vestfrost
- Enfriamiento congelación Rocktrail
- Enfriamiento congelación Sub-Zero
- Enfriamiento congelación Teco
- Enfriamiento congelación Kalamera
- Enfriamiento congelación Marynen
- Enfriamiento congelación Klima1stKlaas
- Enfriamiento congelación Frigor
- Enfriamiento congelación Gastro-Cool
- Enfriamiento congelación Linetech
- Enfriamiento congelación Domest
- Enfriamiento congelación Temptech
- Enfriamiento congelación Novamatic
Últimos Enfriamiento congelación Manuales
24 Octubre 2024
24 Octubre 2024
24 Octubre 2024
24 Octubre 2024
23 Octubre 2024
23 Octubre 2024
23 Octubre 2024
23 Octubre 2024
22 Octubre 2024
22 Octubre 2024