Elite Screens M71NWS1 Manual de Usario

Lee a continuación 📖 el manual en español para Elite Screens M71NWS1 (7 páginas) en la categoría pantalla de proyección. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/7
www.elitescreens.com info@elitescreens.com
Manual Pull-Down Projection Screen
Elite Manual Series
USER’S GUIDE
Ver. 1.2
www.elitescreens.com info@elitescreens.com
Pre-installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
INSTALLATION
Flush Wall Mounting
1. Mark the location of where the screen is to be installed for the pre-drilled hole.
2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave
about 1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of screen’s left and right end cap.
Ceiling Mounting (additional hardware required)
Optional installation using a chain to hang the screen from the ceiling.
1. You can also hang the screen on a ceiling by using a chain (not included) and hang it by the two loops
(models 71-120) located on each end of the case or by the end cap’s ears (models 135-170).
Back of end cap
Front view
Side view
www.elitescreens.com info@elitescreens.com
SCREEN OPERATION
Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.
1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull
the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at
intervals.
2. If you want to the screen to retract back, simply pull the screen down more than 2 inches and retract the
screen back by quickly and smoothly releasing it up gently.
Note: Always release at a 90-degree angle and do not let go until the screen is entirely inside the case
If ever the screen feels stuck, keep in mind that the screen’s mechanism is new and needs to be run
up/down a few times to loosen up. If this happens, carefully with a little force yank the screen straight
down to unlock the screen.
Note: Improperly bringing the screen up/down will damage the screen material or rolling system.

Especificaciones del producto

Marca: Elite Screens
Categoría: pantalla de proyección
Modelo: M71NWS1

¿Necesitas ayuda?

Si necesitas ayuda con Elite Screens M71NWS1 haz una pregunta a continuación y otros usuarios te responderán




pantalla de proyección Elite Screens Manuales

pantalla de proyección Manuales

Últimos pantalla de proyección Manuales