EMOS P57002 Manual de Usario

Lee a continuación 📖 el manual en español para EMOS P57002 (36 páginas) en la categoría Timbre de la puerta. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/36
3401000020_31-P57002_00_01_WEB 80 × 120 mm
P57002
GB Wired Doorbell
CZ Drátový zvonek
SK Drôtový zvoek
PL Dzwonek przewodowy
HU Vezetékes csen
SI Žični zvonec
RS|HR|BA|ME Ožičeno zvono na vratima
DE Draht-Türklingel
UA Дротовий дверний дзвоник
RO|MD Sonerie cur
LT Laidinis durų skambutis
LV Pie vadiem pievienojams durvju zvans
EE Juhtmega uksekell
BG Звънец с кабел
FR Carillon laire
IT Campanello a lo
ES Timbre con cable
NL Bedrade deurbel
www.emos.eu
2
3
3
1a
1b
2
4
1 2
1
2
4
3
3Button switch
N
N
L
L
3
GB | Wired Doorbell
The chime is designed for constant connection to a 230 V AC/50 Hz
power grid.
Read the instruction manual carefully to make sure you use the doorbell
correctly.
Technical Specications
Enclosure: IP20
Number of ringtones: 1
Chime power supply: 230 V AC/50 Hz
Chime Description (see g. 1)
1a – mounting hole/opening for
hanginge
1b – mounting hole
2 – opening for wiring
3 – hole to open the cover
4 – front cover
Mounting the Doorbell (see g. 2)
Connection diagram (see g. 3)
Button switch
Installing the Doorbell
The chime is designed for indoor use only.
The installation may only be performed by an appropriately qualied
person.
During installation, follow applicable standards.
The electrical wiring should use a wire suitable for the specic installa-
tion conditions, with a cross-section of between 0.5 mm and 2.5 mm.
The phase conductor of the electrical wiring must be secured against
short circuits and overload by an appropriate circuit breaker or fuse.
1. Disconnect the source of 230 V AC power supply before installation.
Use a measuring instrument to make sure the wiring is not live.
2. Remove the front cover by inserting a screwdriver through the
openings on the sides.
3. Choose a spot for the doorbell, drill 2 holes matching the spacing of
the mounting holes on the doorbell and insert wall plugs into the wall.
4. Insert cables into the doorbell‘s opening for wiring and mount the
doorbell to the wall with screws.
5. Remove an approximately 1 cm long stretch of insulation from the
end of the cables.
6. Place the cables into the doorbell‘s supply terminals and fasten
them with screws.
7. Replace the front cover.

Especificaciones del producto

Marca: EMOS
Categoría: Timbre de la puerta
Modelo: P57002

¿Necesitas ayuda?

Si necesitas ayuda con EMOS P57002 haz una pregunta a continuación y otros usuarios te responderán




Timbre de la puerta EMOS Manuales

Timbre de la puerta Manuales

Últimos Timbre de la puerta Manuales