Fujitsu B2711 TE FHD Manual de Usario

Fujitsu Monitor B2711 TE FHD

Lee a continuación 📖 el manual en español para Fujitsu B2711 TE FHD (13 páginas) en la categoría Monitor. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/13
Page 1 of 13
Disassembly and Repair 2
Information on the installation and removal of components 3
Tools 4
Disassembly 5
Monitor Exploded Drawing 10
Replaceable Components and Services 11
Disposal information for recycling companies 12
Disassembly and repairs
Display B2 TE F711 HD
Display B2711 TS FHD
Version date
20.12.2022
Category
Disassembly and repairs
Contents
Page 2 of 13
Disassembly and Repair
We recommend printing out the relevant sections of this chapter prior to installation
as the device for installing/removing hardware components needs to be switched off.
In order to repair the display, please follow the disassembly instructions to remove the defect part, replace it with spare part, then follow the
instructions in reverse order.
If you have received any further documents with your device, you should read these through carefully.
Please note the following instructions before installing/removing system components:
The device must be switched off when installing/removing components and it must
not be in power-saving mode.
Disconnect the mains plug before opening the device.
After unplugging the mains plug, discharge the remaining voltage by pressing the
activation button.
Remove all externally connected cables.
Take care not to pinch any cables when installing/removing components.
Please ensure that the installed components that might heat up intensely during
operation do not exceed the permitted operating temperature.
!
Page 3 of 13
Information on the installation and removal of components
Please pay attention to the locking mechanism (indentations and centring pins) when installing hardware components.
Note that some components on the mainboard may be very hot if the device was in use shortly before the case was removed.
Utmost care is required during installation and removal to avoid damaging components.
Never use items with sharp edges (screwdrivers) to lever them out.
Parts with Electrostatic Sensitive Devices (ESD) can be identified by a corresponding label.
When dealing with boards with ESDs, the following points must always be observed:
Always ensure there is a static discharge (e.g. by touching a grounded object) prior to commencing with the
work.
The devices and tools being used must not be statically charged.
Only touch the components along the edges or on the areas marked in green (contact points).
Contacts and electronic components must not touch when handling components equipped with ESD
protection.

Especificaciones del producto

Marca: Fujitsu
Categoría: Monitor
Modelo: B2711 TE FHD

¿Necesitas ayuda?

Si necesitas ayuda con Fujitsu B2711 TE FHD haz una pregunta a continuación y otros usuarios te responderán




Monitor Fujitsu Manuales

Monitor Manuales

Últimos Monitor Manuales