Hifonics HFEQ-2 Manual de Usario

Lee a continuación 📖 el manual en español para Hifonics HFEQ-2 (8 páginas) en la categoría No categorizado. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/8
Operator’s Guide
HFEQ-2
Thank you for purchasing the HIFONICS HFEQ-2 4-Band Equalizer/
two-way crossover. This unit has both a pre-amp equalizer and
crossover to provide the multi-speaker system of your vehicle with
improved sound performance. Please read the entire manual to
ensure proper connections and application.
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Features
TWO COLOR (RED/BLUE) CONTROL KNOB LEDS
2-CHANNEL UNBALANCED LINE INPUT
DESIGNATED SUBWOOFER UNBALANCED OUTPUT
SUBWOOFER X-OVER FREQUENCY CONTROL
INPUT LEVEL CONTROL ADJUSTMENT
MONO/STEREO SELECTION
FADER CONTROL
HALF DIN CHASSIS SIZE
MOUNTING HARDWARE (INCLUDED)
MID BASS/SUB BASS/MID RANGE/TREBLE CONTROL
Mounting and Hardware
Prior to mounting, connect the wires
to ensure proper operation.
MOUNTING
1. Select the desired mounting location, either under the dash or
in the dash. Make sure that there is adequate depth for the HFEQ-2.
2. Use the mounting brackets and hardware provided. Make sure
there is proper clearance for the mounting bracket screws when
attaching under the dash. Use caution to ensure there are no wiring
harnesses behind the dash panel (where the mounting
screws are fastened).
3. Route the power, ground, and remote wires away from moving
parts to prevent pinching or shortened wires.
WIRING
1. : The power wire should connect to a constant or Power Wire
switched +12 volt source with a (1 Amp) provided in-line fuse. We
recommend that you use the radio constant or switch +12 volt source.
2. : Connect the ground wire to a clean chassis ground Gound Wire
point. Be sure to remove all paint and primer to expose clean metal.
Use a ring terminal and lock or star washer to secure the ground wire.
3. : The remote wire should be connected to the source Remote Wire
until remote or antenna wire that provides +12 volts when the
source unit is “on” and 0 volts when the source unit is turned “off.”

Especificaciones del producto

Marca: Hifonics
Categoría: No categorizado
Modelo: HFEQ-2

¿Necesitas ayuda?

Si necesitas ayuda con Hifonics HFEQ-2 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Hifonics Manuales

No categorizado Manuales

Últimos No categorizado Manuales