Hoover HOD 6615BL Vision One Manual de Usario

Hoover lavavajillas HOD 6615BL Vision One

Lee a continuación 📖 el manual en español para Hoover HOD 6615BL Vision One (17 páginas) en la categoría lavavajillas. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/17
HOD 6615 BL
HOD 6615 BL
DISHWASHER
User instructions
EN
®
3
SAFETY INSTRUCTIONS
There are certain basic safety rules
which are valid for any domestic
appliance.
Installation
Make sure that the plug fitted to the
machine is compatible with the power
supply socket. If it is not, get a suitably
qualified person to fit the correct type,
and to make sure that the cables to the
mains socket are able to cope with the
power rating of the appliance.
Ensure that the dishwasher does not
crush power cables.
In general it is not advisable to use
adaptors, multiple plugs and/or extension
cables.
Should it be necessary to replace the
supply cord, call the After Sales Service
Centre.
Safety
Never touch the appliance when your
hands or feet are wet or damp.
Do not use when your feet are bare.
Do not remove the plug from the mains
supply socket by pulling the mains cable
or the machine itself.
Do not leave the appliance exposed to
the elements (rain, sun etc).
Do not let children (or others incapable
of operating it) use the machine without
supervision.
Water left in the machine or on the
dishes at the end of the wash programme
should not be swallowed.
The door should not be left in the open
position since this could present a potential
hazard ( es. tripping ).
Leaning or sitting on the open door of
the dishwasher could cause it to tip over.
WARNING !
Knives and other utensils with sharp
points must be loaded in the basket
with their points down or placed in a
horizontal position.
Daily use
This appliance is be designed for domestic
use only.
The dishwasher is designed for normal
kitchen utensils.
Objects that have been contamined by
petrol, paint, traces of steel or iron,
corrosive chemicals, acids or alkalis
must not be washed in the dishwasher.
If there is a water softening device installed
in the home there is no need to add
salt to the water softener fitted in the
dishwasher.
Cutlery is washed best if it is placed in
the basket with the handles downwards.
If the appliance breaks down or stops
working properly, switch it off, turn off the
water supply and do not tamper with it.
Repair work should only be carried out
by an approved service agent and only
genuine spare parts should be fitted. Any
failure to follow the above advice may
have serious consequences for the safety
of the appliance.
Disposal
The dishwasher has been made from
materials which can be recycled so that it
can be disposed of in an environmentally
friendly way.
If you wish to dispose of an old dishwasher
be careful to remove the door to
eliminate the risk of children becoming
trapped inside it.
2
CONTENTS
Safety advice
Setting up, installation
Water softener unit
Loading the salt
Adjusting the upper basket
Loading the dishes
Information for test laboratories
Loading the detergent
Types of detergent
Loading the rinse aid
Cleaning the filters
Some practical hints
Routine cleaning and maintenance
Description of the control panel
Technical data
Programme selection and special functions
Programme guide
Identifying minor faults
Your guarantee
pag. 3
pag. 4
pag. 8
pag. 9
pag. 10
pag. 11
pag. 13
pag. 14
pag. 15
pag. 16
pag. 17
pag. 18
pag. 19
pag. 20
pag. 20
pag. 21
pag. 24
pag. 26
pag. 28
Please read the instructions in this booklet carefully because they contain important
information on how to install, use and maintain your dishwasher safely as well as
containing useful tips on how to make the most of it.
Keep this booklet safe for future reference.
Fig. A
32
1
4
5
Water connection
IMPORTANT
The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be reused.
The inlet and drain hoses can be directed
to left or right.
IMPORTANT
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60 °C.
Water pressure must be between
0,08 MPa and 0,8 MPa. If the pressure is
below the minimum consult our service
department for advice.
The inlet hose must be connected to a
tap so that the water supply can be cut
off when the machine is not in use
(fig. 1 B).
The dishwasher is fitted with 3/4" threaded
connector (fig. 2).
Connect inlet hose “A” “B”to water tap
with a 3/4" attachment making sure that
it has been properly tightened.
If it is necessary, the inlet pipe can be
lengthened up to 2,5 m. The extension
pipe is available from the After Sales
Service Centre.
If limescale deposits or sand are present
in the water, it is advisable to obtain the
appropriate filter, art. 9226085, from the
After Sales Service Centre (fig. 3). The
filter “Dmust be inserted between the tap
B” “Aand the inlet hose , remembering
to fit the washer “C”.
If the dishwasher is connected to new
pipes or to pipes which have not been in
use for a long time run water through for
a few minutes before connecting the
inlet hose. In this way no deposits of
sand or rust will clog up the water inflow
filter.
1
2
3
5
Electrical connection
Plug your dishwasher into the power
socket.
If the plug we supply does not fit :
CUT IT OFF AND DESTROY IT!
You can't use it on other appliances, and
the exposed wires could be dangerous if
anyone plugged it in.
Fit a suitable plug, as follows:
WARNING!
THIS APPLIANCE MUST BE EARTHED.
Fuses and plugs
This appliance should be used only on a
socket with a minimum rating of 13 Amp.
Our ready-fitted plug is already equipped
with a 13 amp fuse which is BS 1362 ASTA
approved.
Any replacement should be exactly the
same.
If the fuse cover is lost, do not use the plug
until it is replaced.
A correct replacement fuse cover (obtainable
from your dealer or Electricity board) must be
the same colour as shown or named on the
insert on the base of the plug.
Manufacturer declines all responsibility
for any damage due to non-earthing of
the machine.
Appliance complies with
European Directives 73/23/EEC
and 89/336/EEC, replaced by
2006/95/EC and 2004/108/EC, and
subsequent amendments.
Green and
yellow wire
Marked with the letter E,
OR marked with the Earth
symbol,
OR coloured green,
OR coloured green and
yellow.
Blue wire
Brown wire
Marked N,
OR coloured black.
Marked L,
OR coloured red.
Connect to the terminal in the plug
4
INSTALLATION
(Technical notes)
After unpacking, adjust the height of the
dishwasher. For the dishwasher to work
correctly it must be level. Adjust the feet
so that the machine does not tilt by more
than 2 degrees.
If it you need to move the machine after
removing the packaging, do not try to lift
it by the bottom of the door. Follow the
instructions in the figure. Open the door
slightly and lift the machine by holding
on the top.
IMPORTANT
When the appliance is located on a
carpet floor, attention must be paid to
ensure that there is no obstruction to
the bottom vents.
Make sure that the plug on the
appliance remains accessible after
installation.

Especificaciones del producto

Marca: Hoover
Categoría: lavavajillas
Modelo: HOD 6615BL Vision One

¿Necesitas ayuda?

Si necesitas ayuda con Hoover HOD 6615BL Vision One haz una pregunta a continuación y otros usuarios te responderán




lavavajillas Hoover Manuales

lavavajillas Manuales

Últimos lavavajillas Manuales