Ignis AKL 429 Manual de Usario

Ignis horno AKL 429

Lee a continuación 📖 el manual en español para Ignis AKL 429 (24 páginas) en la categoría horno. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/24
12
GB TABLE OF CONTENTS
w
INSTALLATION PAGE 13
ELECTRICAL CONNECTION PAGE 14
BEFORE USING THE OVEN PAGE 15
PROTECTING THE ENVIRONMENT PAGE 15
PRECAUTIONS AND GENERAL
RECOMMENDATIONS PAGE 15
OVEN ACCESSORIES PAGE 16
COOKING CHART PAGE 17
CLEANING THE OVEN AND ACCESSORIES PAGE 18
TROUBLESHOOTING GUIDE PAGE 19
AFTER-SALES SERVICE PAGE 20
DECLARATION OF CONFORMITY CE PAGE 20
53932-gb.fm5 Page 12 Wednesday, April 4, 2001 3:38 PM
13
Technical information for the installer
After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure (see
arrow).
Check that the appliance has not been
damaged in transit.
Oven dimensions and kitchen unit
dimensions are shown in the opposite figure.
Kitchen units in contact with the oven must
be heat resistant (80° C min).
Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm
inside the cabinet).
Secure the oven to the kitchen unit with
screws (A) as shown.
The oven has also been designed for
building-in under a cooktop.
NOTE: To allow for proper ventilation, we
recommend that you left an opening of at least
500 x 80 mm or an equivalent area in the lower
section of the housing.
An additional opening of 5 mm is required
between the oven top rim and the cooktop lower
rim: this opening must not be closed by strips or
housing crosspieces.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
INSTALLATION
No contacts
53932-gb.fm5 Page 13 Wednesday, April 4, 2001 3:38 PM
14
Warning: Do not connect to the power
supply before you have finished
connecting the oven.
Make sure the oven is installed and
connected to the electricity supply by a
qualified technician in accordance with
the manufacturers instructions and in
compliance with local regulations.
The installer is responsible for the correct
electrical connection of the oven and the
observance of the relative safety
regulations.
The oven must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
The oven must be earthed by law.
Do not use multiple plug adapters or
extension leads.
After the oven has been installed, the
electrical components must be
inaccessible.
Make sure that the voltage shown on the
rating plate is the same as the power
supply voltage in your home. The rating
plate is on the front edge of the oven
cavity (visible with oven door open).
ELECTRICAL CONNECTION
53932-gb.fm5 Page 14 Wednesday, April 4, 2001 3:38 PM

Especificaciones del producto

Marca: Ignis
Categoría: horno
Modelo: AKL 429

¿Necesitas ayuda?

Si necesitas ayuda con Ignis AKL 429 haz una pregunta a continuación y otros usuarios te responderán




horno Ignis Manuales

horno Manuales

Últimos horno Manuales