ILive IKBC384S Manual de Usario

Lee a continuación 📖 el manual en español para ILive IKBC384S (2 páginas) en la categoría No categorizado. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS AND PRECAUTIONS
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
Mains plug is used as disconnect device and it should remain readily operable during intended use. In
order to disconnect the apparatus from the mains completely, the mains plug should be disconnected
form the mains socket outlet completely.
WARNING: Shock hazard - Do Not Open.
Caution and marking information is located at the rear or bottom of the apparatus.
Objects lled with liquids, such as vases, shall not be placed on the apparatus.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain, moisture,
dripping, or splashing.
CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
WARNING: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
WARNING: Use of this unit near uorescent lighting may cause interference regarding use of the
remote. If the unit is displaying erratic behavior move away from any uorescent lighting, as it may be
the cause.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
WARNING: The remote control’s button cell battery contains mercury. Do not put in the trash, instead
recycle or dispose of as hazardous waste.
This product is supplied with a coin/button cell battery. If the coin/button cell battery is swallowed, it
can cause severe internal burns and can lead to death.
Battery shall not be exposed to excessive heat such as sunshine, re or the like.
Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate
medical attention.
Do not mix old and new batteries.
Completely replace all old batteries with new ones.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
Batteries should be recycled or disposed of as per state and local guidelines.
WARNING: This product may contain chemicals known to the State of California to cause birth defects,
or other reproductive harm (California Prop 65). Wash hands after handling.
This product meets and complies with all Federal regulations.
Orientation
Wireless Under Cabinet Bluetooth / CD / Radio Music System
Users Guide for Model IKBC384S v1582-01
Open/Close CD Tray
Display Mode
Remote Sensor
Mounting Peg (x4) Line In (Side)
Microphone
Volume +/-
Random/Memory Preset Up
Repeat/Memory Preset Down
Pair/Play/Pause/
Speakerphone
CD Tray
Display
Power
Skip/Tune
Program/Clock Set/Memory
Timer
Stop/End Call
Source
AC Power (Rear View)
To power the unit, plug the built-in AC Power cord into a
standard wall outlet.
When mounting unit under a cabinet, allow enough
room to t the 90° adapter plug in the space.
Remote Battery
Requires 1 CR2025 button cell battery (included)
All of the above controls are duplicated
on the unit’s remote control.
Battery Backup (Bottom View)
Requires 2, AA-size, batteries (not included).
The battery backup is intended for short power
outages only. The unit’s primary functions
cannot run on the battery backup alone.
AA
AA
LITHIUM BAT TERY
CR 2025
3V
Out
Slide
Push here
LITHIUM BATTERY
CR 2025
3V
CR2025
PUSH
OPEN
To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit
the support section at: www.iLiveElectronics.com
Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas
frecuentes, visite la sección de apoyo en: www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des
questions fréquemment posées, consultez la rubrique d’assistance sur: www.iLiveElectronics.com
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com
Customer Service: | Email Support: | Email Parts: 1-888-999-4215 prodinfo@dpiinc.com partsinfo@dpiinc.com
Copyright © 2016 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property
of their respective owners. Specications are subject to change without notice.
International Support
Protect for Today
Sustain for Tomorrow
Made
Green
Tuning the FM Radio
1. Press the button to turn the under cabinet music system on.Power
2. Press the Source button to switch to FM Radio Mode.
3. Press the Tune +/- button to tune the radio manually.
4. Hold down the Tune +/- button to scan for available stations.
Radio
Radio
Saving and Playing a Station as a Preset
1. Tune to the desired station.
2. Press the button. Clk Set/Mem
Preset number will appear on the display.
3. Press the buttons to adjust to the desired preset number.M +/-
4. Press the button to save the current radio station to Clk Set/Mem
the selected preset.
5. Press the buttons to cycle through preset radio stations. M +/-
Radio Reception
An FM Antenna is built into the unit. To improve FM radio reception, adjust the
position of the unit.
Loading and Playing a CD
1. Open the .CD Door
2. Place a CD into the tray, label side facing up.
3. Close the .CD Door
4. Press the Source button to switch to CD mode.
5. Press the Play/Pause button to begin playing the loaded CD.
6. Press the Skip/Tune buttons to cycle through tracks.
CD
Programming a CD
1. Press the button to stop the CD during play.Stop
2. Press the button.Prog
3. will begin to blink on the display.“PROG
4. Press the Tune +/- buttons to select a track.
5. Press the Program button to save the selected track to the program.
6. Repeat steps 4 and 5 to program up to 20 tracks.
Using the Audio Input
Requires a 3.5mm audio cable (not included).
1. Connect a 3.5mm audio cable to the on the side of the Line In Input
unit and the on an audio device.audio output
2. Press the button to turn the unit on. Power
3. Press the Source Line In modebutton to switch to .
4. Use the native controls on the connected device to play your audio
through the unit.
Note: This unit is not compatible with MP3 CDs.
Setting the Clock
1. With the power o, press and hold the button. Clk Set/Mem
The hour on the display will begin ashing.
2. Press the Tune +/- buttons to adjust the hour.
3. Press the button again to adjust the minutes. Clk Set
The minutes on the display will begin ashing.
4. Press the Tune +/- buttons to adjust the minutes.
5. Press the button to nish setting the time, or wait for Clk Set
the display to stop ashing.
Clock & Timer
Disabling the Timer
To cancel the alarm after it has sounded, press the button.Power
To cancel the timer before the alarm has sounded, press the button until Timer
the display reads 000 and the timer light is no longer lit.
Bluetooth & Line In
Pairing a Bluetooth Device for the First Time
1. Power on the unit by pressing the button. Power
2. Press and hold the Pair button. The Pairing Indicator will begin ashing
quickly. When pairing, remain within 3 feet of the unit.
3. Using the native controls on your Bluetooth device, select the in IKBC384
your Bluetooth settings to pair.
4. If your device requests a password, enter the default password . 0 0 0 0
5. Refer to the user’s manual for your specic device for instructions on pairing
and connecting Bluetooth devices.
6. When successfully paired and connected, the Pairing Indicator will be solid.
7. After initial pairing, the unit will stay paired unless unpaired manually by the
user or erased due to a reset of the device.
8. If your device should become unpaired or you nd it is unable to connect,
repeat the above steps or press the Pair button to start the pairing process
pairing again.
Playing Audio through Bluetooth
1. After successfully pairing to a device, use the native controls on the
connected Bluetooth Device to select a track.
2. To play or pause the selected track, use the native controls on the
connected Bluetooth Device, or the Play/Pause button on the unit.
3. To skip forward or back on the selected track, use the native controls
on the connected Bluetooth Device, or the Skip/Tune +/- buttons
on the unit.
4. Audio played through the connected Bluetooth device will now be heard
through the speakers.
Setting the Timer
1. With the power o, press the button. Timer The display will ash.
2. Press the Timer buttons to adjust the timer in increments of 10 min.
3. Press the Tune +/- buttons to adjust the timer in increments of 1 min.
4. Wait for the display to stop ashing.
5. After the set time has expired, the under cabinet music system will
sound an alarm.
Using the Speakerphone
1. When a call is received, a ringtone will sound through the unit.
2. Press the button to accept the call, or accept the call using the
controls on the connected phone.
3. The incoming call received through the device will now be heard through
the headphones.
4. To end the call, press the button or end the call using the controls on
the connected device.

Especificaciones del producto

Marca: ILive
Categoría: No categorizado
Modelo: IKBC384S

¿Necesitas ayuda?

Si necesitas ayuda con ILive IKBC384S haz una pregunta a continuación y otros usuarios te responderán




No categorizado ILive Manuales

ILive

ILive ISBW104B Manual de Usario

16 Septiembre 2024
ILive

ILive INL252 Manual de Usario

14 Septiembre 2024
ILive

ILive ISB103 Manual de Usario

14 Septiembre 2024
ILive

ILive IAWP28 Manual de Usario

14 Septiembre 2024
ILive

ILive IAB13 Manual de Usario

14 Septiembre 2024
ILive

ILive ISB301 Manual de Usario

14 Septiembre 2024
ILive

ILive ISB13 Manual de Usario

14 Septiembre 2024
ILive

ILive IAA400 Manual de Usario

14 Septiembre 2024
ILive

ILive IFB290 Manual de Usario

14 Septiembre 2024
ILive

ILive IKBC384S Manual de Usario

14 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales