Imarflex IWD-1130W Manual de Usario

Lee a continuación 📖 el manual en español para Imarflex IWD-1130W (4 páginas) en la categoría Dispensador de agua. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
SPECIFICATION:
MODEL NO. : IWD- 1130W
POWER CONSUMPTION : Hot 420W
Cold 100W
RATED VOLTAGE : 230Va.c. 60Hz
IMPORTANT SAFEGUARDS:
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read all instructions thoroughly.
2. Before using the Water Dispenser, check if the voltage indicated corresponds with the convenience
outlet (230Va.c.).
3. Do not use two-way socket with another appliance.
4. Do not use any appliance with a damaged cord or plug. If the cord is damaged, it must be replaced
with the same type and size of a qualied person or bring the unit to the manufacturer or to the
nearest Imarex Authorized Service Center to avoid hazard.
5. To avoid a hazard due to instability of the appliance, it must be xed in accordance with the
instructions.
6. Do not place the Water Dispenser near gas stove, electric burner or heated oven.
7. Children should be supervised to ensure that they do not play with the appliance.
8. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a person responsible for their safety.
9. Keep the water dispenser in a dry and cool place and avoid direct sunlight. Rearward of the
machine should be at least 20cm far from the wall. Never put the machine on the paper or foam,
which may cause unstable condition, such as store water or cause creepage. Never put anything
ammable beside this machine.
10. To avoid damage, do not plug the power cord or turn on the heating switch until 3 minutes after
you put the lled water gallon.
11. This water dispenser must be used with third-prong grounding plug and creepage protection switch.
If two at plugs will use, the grounding wire must be properly grounded before use.
12. In case the unit will not use for a long time, turn o the switch and pull the plug out from the socket
then drain the remaining water through drain hole.
13. Never use organic liquid to clean the machine. Splashing of water to the body is strictly prohibited.
14. You should use the ON/OFF switch to turn on or othe unit. It is prohibited to turn on or o the unit
through plugging or unplugging the power cord. Never extend the length of the power supply cord
to avoid re.
15. Never turn the machine upside down or lean it more than 45°.
16. Do not adjust the thermostat of the unit by yourself.
17. Power cord or other parts of the unit must be replaced by authorized service center personnel.
18. The cooling time of the unit might take longer when the environment temperature is higher than the
normal.
19. Save this instruction for future reference.
DESCRIPTION OF PARTS:
NO.
PART NAME
NO.
PART NAME
1
Heat Light Indicator
8
Door
2
Cold Light Indicator
9
Container Stand with Rollers
3
Rell Water Light Indicator
10
Cold Switch
4
Cold Water Tap
11
Hot Switch
5
Normal Water Tap
12
Power Cord
6
Hot Water Tap
13
Hot Tank Drain Valve
7
Water
HOW TO USE:
1. Tear the label from the water gallon.
2. Put the water pump rod inside the gallon and place slowly inside the unit.
3. Insert the plug to the socket and wait for about 5 minutes before you turn ON the power switch.
4. Press the Hot, Cold and Room Temp Water button. Once, there is water ows out in every water
tap you may now turn ON the hot & cold power switch located at the back portion of the unit. The
indicator lights up accordingly once the machine works.
5. The rel water light indicator will be ashing once the water gallon needs to be rell. l
For Initial Use:
1. Clean the unit.
a. Put the water pump rod inside the gallon and place slowly inside the unit.
b. Press the cold, room temp and hot tap until the water ows out of the faucet for about 20
minutes.
c. Pull o the water pump rod into the gallon and turn on the drain valve to empty the water inside
the unit.
CLEANING AND MAINTENANCE:
1. Turn o and unplug the unit.
2. Wait until the hot water in the water tank cools down.
3. Open the hot tank drain valve until the water tank gets empty.
4. Cleaning of the unit should be done regularly.

Especificaciones del producto

Marca: Imarflex
Categoría: Dispensador de agua
Modelo: IWD-1130W

¿Necesitas ayuda?

Si necesitas ayuda con Imarflex IWD-1130W haz una pregunta a continuación y otros usuarios te responderán




Dispensador de agua Imarflex Manuales

Dispensador de agua Manuales

Últimos Dispensador de agua Manuales