JANDY AquaSwitch Manual de Usario

JANDY No categorizado AquaSwitch

Lee a continuación 📖 el manual en español para JANDY AquaSwitch (12 páginas) en la categoría No categorizado. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/12
INSTALLATION MANUAL
HIGH
OFF
LOW
ON ON
SPA
POOL HEATER AUX 1 AUX 2
S
wi cht ®
®
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. DANGER - to reduce the risk of injury, do not permit children to use this product unless they are
closelysupervised at all times.
3. All electrical work must be performed by a licensed electrician and must conform to all national, state, and local
codes.
4. WARNING: Water temperature in excess of 100°F/38°C may be injurious to your health.
AVERTISSEMENT: Il peut être dangereux pour la santé de se plonger dans de l'eau à plus de 38°C/100°F.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature of
the body reaches a level several degrees above the normal body temperature of 98.6° F. The symptoms of hyper-
thermia include dizziness, fainting, drowsiness, lethargy, and an increase in the internal temperature of the body.
The effects of hyperthermia include: 1) unawareness of impending danger; 2) failure to perceive heat; 3) failure to
recognize the need to exit spa; 4) physical inability to exit spa; 5) fetal damage in pregnant women;
6) unconsciousness resulting in a danger of drowning.
WARNING - The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia in
hot tubs and spas. La consommation d'alcool ou de drogue augmente considérablement les risques
d'hyperthermie mortelle dans une cuve de relaxation.
5. Install to provide drainage of compartment for electrical components.
6. Install at least five (5) feet from the inside wall of the pool and tub.
Canadian installations must be at least three (3) meters from the water.
Les installations canadiennes doivent se trouver à au moins trois (3) mètres de l'eau.
7. A ground-fault circuit-interrupter must be provided if this device is used to control underwater lighting fixtures.
The conductors on the load side of the ground-fault circuit-interrupter shall not occupy conduit, boxes or enclosures
containing other conductors unless the additional conductors are also protected by a ground-fault circuit-interrupter.
Refer to local codes for complete details.
8. A terminal bar marked GROUND is provided within the Power Center. To reduce the risk of electrical shock, connect
this terminal bar to the grounding terminal of your electric service or supply panel with a continuous green insulated
copper wire equivalent in size to the circuit conductors supplying this equipment, but no smaller than No. 12 AWG
(3.3 mm2). In addition, a second wire connector should be bonded with a No. 6 AWG (4.115 mm) copper wire to
any metal ladders, water pipes, or other metal within 5 feet (1.52 m) of the tub.
9. CONTROL SYSTEM IS INTENDED TO CONTROL HEATERS WITH BUILT-IN HIGH LIMIT CIRCUITS ONLY.
10. PLEASE SAVE THESE INSTRUCTIONS.
SPECIFICATIONS:
POWER SUPPLY: 120 Volts A.C.; 60 Hz.; 3 amps.
CONTACT RATING: (High Volt.) 25 amp; 3 h.p. @ 240 Volts A.C., h.p. @ 120 Volts A.C.; 1500 Watts Incandescent
CONTACT RATING: (Low Volt.) Class Two, 1 amp at 24 Volts A.C.
EMERGENCY SERVICE SWITCHES: All circuits.
FUSE: 3.15A GMA
DIMENSIONS:
Power Center: Height - 13 3/4"; Width - 14 1/2"; Depth - 5".
Wall Unit Control Panel: Height - 5 1/2"; Width - 5 1/2"; Depth - 3/8".
LIRE LA NOTICE TECHNIQUE.
Important Safety Precautions
1

Especificaciones del producto

Marca: JANDY
Categoría: No categorizado
Modelo: AquaSwitch

¿Necesitas ayuda?

Si necesitas ayuda con JANDY AquaSwitch haz una pregunta a continuación y otros usuarios te responderán




No categorizado JANDY Manuales

No categorizado Manuales

Últimos No categorizado Manuales