JANDY Hi-E2 Manual de Usario

JANDY Calentador Hi-E2

Lee a continuación 📖 el manual en español para JANDY Hi-E2 (40 páginas) en la categoría Calentador. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/40

H0205000_REVM

WARNING

IF THESE INSTRUCTIONS ARE NOT FOLLOWED EXACTLY,

A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY

DAMAGE, PERSONAL INJURY, OR DEATH.

FOR YOUR SAFETY: This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in

which the product will be installed where such state or local requirements exists. In the event no such state or local requirement exists, the installer or

maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual

can be followed exactly. Before installing this product, read and follow all warning notices and instructions that accompany this product. Failure to follow

warning notices and instructions may result in property damage, personal injury, or death. Improper installation and/or operation can create carbon

monoxide gas and flue gases which can cause serious injury, property damage, or death. For indoor installations, as an additional measure of safety,

Zodiac Pool Systems, Inc. strongly recommends installation of suitable carbon monoxide detectors in the vicinity of this appliance and in any adjacent

occupied spaces. Improper installation and/or operation will void the warranty.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Immediately switch off main gas supply.

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

Jandy Pro Series Hi-E2® and Hi-E2®R

Gas-Fired Pool and Spa Heater

EHE

INSTALLATION AND

OPERATION MANUAL

Page 3

ENGLISH

Jandy® Pro Series, Hi-E2® and Hi-E2R Gas-Fired Heater | Installation & Operation Manual

Table of Contents

Section 1. General Information 4 .......................

1.1 Introduction ......................................................... 4

1.2 Description ......................................................... 4

1.3 Warranty ............................................................. 4

Section 2. Installation Instructions 4 .................

2.1 General Requirements 4 .......................................

2.2 Heater Assembly and Preparation 5 ......................

2.3 Heater Location 5 ..................................................

2.4 Installation Clearances 5 .......................................

2.5 Outdoor Installation 5 ............................................

2.6 Outdoor Shelter Installation (Canada) 6 ................

2.7 Indoor Installation 6 ...............................................

2.7.1 Preparation of Heater For Indoor

Installation 6 ....................................................

2.7.2 Combustion Air Requirements for

One-Pipe Installation 7 ....................................

2.7.3 Two-Pipe Installation (Direct Vent) 7 ...............

2.8 Condensate Disposal 10 .......................................

2.9 Gas Supply and Piping ......................................11

2.9.1 Special Precautions for LP Gas 12 .................

2.10 Electric Wiring 12 ..................................................

2.10.1. Electrical Power 12 ..........................................

2.10.2 Bonding ...................................................... 13

2.10.3 Auxiliary Time Clock Wiring 14 ........................

2.10.4 Remote Operation 14 ......................................

2.11 Water Piping 14 .....................................................

2.11.1 Reversal of Water Connections 14 ..................

2.11.2 Pool/Spa Piping Systems 15 ...........................

2.11.3 Connections at Heater................................ 16

2.11.4 Pressure Relief Valve and

Temperature Relief Valve 16 ...........................

2.11.5 Automatic Chlorinators

(Chemical Feeders) 16 ....................................

2.12 Start-up and Adjustment ................................... 17

2.12.1 Normal Operation 17 .......................................

2.12.2 Start-up ....................................................... 17

2.12.3 Condensate ................................................ 17

2.12.4 Gas Pressure 18 .............................................

2.12.5 Adjustment of Water Pressure Switch 18 .......

2.12.6 Water Temperature Rise............................. 19

Section 3. Operating Instructions 19 .................

3.1 Start-Up Procedure 20 ..........................................

3.2 Temperature Controls 20 .......................................

3.3 Lighting and Shutdown 21 .....................................

3.3.1 Lighting the Heater 21 .....................................

3.3.2 Shutdown ................................................... 21

3.4 Water Chemistry 21 ...............................................

3.4.1 Pools .......................................................... 21

3.4.2 Spas ........................................................... 21

3.5 Spa/Hot Tub Safety Rules 22 ................................

3.6 Swimming Pool Energy Savings Tips 22 ...............

3.7 Seasonal Care 23 ..................................................

3.7.1 Spring and Fall Operation 23 ..........................

3.7.2 Winterizing .................................................. 23

3.8 Periodic Inspection 23 ...........................................

3.8.1 Owner Inspection 23 .......................................

3.8.2 Professional Inspection 24 ..............................

Section 4. Maintenance and Service 24 .............

4.1 General ............................................................. 25

4.2 Induced-Draft Combustion System 25 ..................

4.3 Heater Components and Their Operation 26 ........

4.4 Combustion Air Filter ........................................ 26

4.5 Electrical Trouble Shooting ............................... 27

4.5.1 115V Electrical Power Supply 28 ....................

4.5.2 Control Circuit Trouble Shooting 28 ................

4.6 Venturi Combustion Flow System 30 ....................

4.6.1 Pressure Measurement Ports..................... 30

4.6.2 Venturi System Checkout 30 ...........................

4.6.3 Air Flow Investigation 32 .................................

4.6.4 FuelGasTypeandGasOriceSize .......... 33

4.6.5 High Elevation Operation 33 ...........................

4.7 Combustion Condensate 33 ..................................

4.8 Major Component Service 34 ................................

Section 5. Capacities and Dimensions 34 .........

5.1 General Information 34 ..........................................

Section 6. Replacement Parts 35 .......................

6.1 Ordering Information 35 ........................................

6.2 Parts List 35 ..........................................................

6.3 Exploded View 37 ..................................................

Especificaciones del producto

Marca:	JANDY
Categoría:	Calentador
Modelo:	Hi-E2
Color del producto:	Grijs
Peso.:	826 g
Altura:	51 mm
Amable:	IP-beveiligingscamera
Material de la carcasa:	Aluminium
Código de seguridad internacional (IP):	IP66
Bluetooth:	Nee
Formatos de vídeo soportados:	H.264, M-JPEG, MPEG4
Stemcodecs:	G.711
factor vorm:	Bolvormig
Soporte de colocación:	Buiten
Tecnología de conectividad:	Bedraad
red LAN:	Nee
Método de montaje:	Plafond
Resolución Máxima:	2992 x 2992 Pixels
Número total de megapíxeles:	12 MP
Diámetro:	160 mm
Tipo de fuente de energía:	Battery, DC, PoE
Salida de corriente (voltios):	12
Iluminación mínima:	0.49 Lux
Campo de visión (FOV):	360 °
Número de cámaras:	1
Lector de tarjetas de memoria integrado:	Ja
Tarjetas de memoria compatibles:	MicroSDHC, MicroSDXC
Disco duro incorporado:	Nee
Vision nocturna:	Nee
Detección de movimiento por vídeo:	Ja
Cifrado HTTPS:	Ja
Número de puertos Ethernet LAN (RJ-45):	1
Protección de contraseña:	Ja
Consumo de energía (máx.):	25.5 W
Salidas de auriculares:	1
Certificación:	UL, cUL, CE, WEEE, RCM, EAC, KC
Tamaño del sensor óptico:	1/2.3 "
Conexión para adaptador de red:	Ja
Tipo de sensor de imagen:	CMOS
Velocidad de obturación de la cámara:	1/7 - 1/8000 s
balance de blancos:	Auto, Manual
Tipo cámarasluiter:	Elektronisch
Protección-de-contraseña:	Gebruiker
Certificados de sostenibilidad:	RoHS
Reducción de ruido:	Ja
Estándar de red:	IEEE 802.1x
Temperatura de almacenamiento:	-25 - 50 °C
Máximo 30 cuadros por segundo:	20 fps
Protocolos de red compatibles:	IPv6, IPv4, HTTP, HTTPS, SOAP, DNS, NTP, RTSP, RTCP, RTP, TCP, UDP, IGMP, ICMP, DHCP, Zeroconf, ARP
filtro de dirección IP:	Ja
Exploración progresiva:	Ja
Tipo de interfaz Ethernet:	Fast Ethernet
yo codifico:	IK10
Frecuencia de muestreo:	8 kHz
rango de panorámica:	0 - 360 °
Modo día/noche:	Ja
Número de lentes:	1
Número mínimo de apertura:	2.2
Control de cámara panorámica:	Ja
Función de inclinación de la cámara:	Nee
Número de sensores:	1
Vídeo transmitido en vivo:	Ja
Número de píxeles efectivos (H x V):	2992 x 2992 Pixels
Entrada/salida de alarma:	Ja
Protección de la privacidad:	Ja
Wifi.:	Nee
Temperatura de funcionamiento (TT):	-20 - 50 °C
Humedad relativa de funcionamiento (VV):	0 - 95 procent
Tecnología de batería:	Lithium
Código del Sistema Armonizado (SA):	85258900
Ajuste de la velocidad de obturación:	Automatisch/handmatig
Máscara zona privada:	Ja
Ángulo de visión de la lente, horizontal:	180 °
Tecnología de reducción de ruido:	3D-ruisonderdrukking
Alarma activa de desmontaje no autorizado:	Ja
Codificación de región de interés (ROI):	Ja