JennAir MKC4157ES Manual de Usario

JennAir Magnetron MKC4157ES

Lee a continuación 📖 el manual en español para JennAir MKC4157ES (20 páginas) en la categoría Magnetron. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/20

INSTALLATION INSTRUCTIONS

BUILT-IN MICROWAVE OVEN KIT

INSTRUCTIONS D’INSTALLATION

ENSEMBLE FOUR À MICRO-ONDES

ENCASTRÉ

This product is suitable for use above electric built-in ovens or warming drawers. This product is not suitable for use below cooktops.

This Built-In Kit is designed for use with Jenn-Air Microwave Oven model specifying JMC3415ES Built-In Kit on the serial tag on the

front of the microwave oven.

These Installation Instructions cover different models. The appearance of your particular model may differ slightly from the illustrations

in these Installation Instructions.

Please read these instructions thoroughly before beginning installation.

Ce produit est conçu pour être installé au-dessus d’un four électrique encastré ou d’un tiroir-réchaud. Ce produit n’est pas conçu

pour être installé sous une table de cuisson. L’ensemble four à micro-ondes encastré est conçu pour être utilisé avec les modèles

de fours à micro-ondes Jenn-Air dont la plaque avant avec numéro de série indique le numéro d’ensemble encastré JMC3415ES.

Ces instructions d’installation couvrent plusieurs modèles. L’apparence de votre modèle peut différer légèrement des illustrations

présentes dans ce manuel.

Lire ces instructions attentivement avant de commencer l’installation.

IMPORTANT:

Save for local electrical inspector’s use.

IMPORTANT :

À conserver pour consultation par l’inspecteur

local des installations électriques.

NOTE: Do not remove protective ﬁlm from trim kit frame before

installing ducts and other mounting hardware. Only remove ﬁlm

just before installing trim on cabinet.

REMARQUE : Ne pas retirer le ﬁlm de protection du cadre de

la trousse de garniture avant l’installation des conduits et de la

quincaillerie de ﬁxation. Enlever le ﬁlm juste avant l’installation

du cadre sur le placard.

W10781779A

Table of Contents/Table des matières

BUILT-IN MICROWAVE OVEN SAFETY ........................................2

INSTALLATION REQUIREMENTS .................................................2

Tools and Parts .............................................................................2

Location Requirements ................................................................3

Minimum Dimensions...................................................................3

Product Dimensions .....................................................................5

Electrical Requirements ...............................................................5

INSTALLATION INSTRUCTIONS ...................................................6

Install Rear and Top Ducts ...........................................................6

Install Rails and Bottom Duct ......................................................7

Install Microwave Oven and Trim Kit Frame ................................8

Complete Installation ...................................................................9

To Remove Trim Kit Frame ...........................................................9

ASSISTANCE ..................................................................................9

SÉCURITÉ DU FOUR À MICRO-ONDES ENCASTRÉ ..............10

EXIGENCES D’INSTALLATION ...................................................10

Outils et pièces ...........................................................................10

Exigences d’emplacement .........................................................11

Dimensions minimales ...............................................................11

Dimensions du produit ...............................................................13

Spéciﬁcations électriques ..........................................................13

INSTRUCTIONS D’INSTALLATION .............................................14

Installer les conduits arrière et supérieur ...................................14

Installer les rails et le conduit inférieur .......................................15

Installer le four à micro-ondes et le cadre

de la trousse de garniture ..........................................................16

Terminer l’installation ..................................................................17

Enlever le cadre de la trousse de garniture ...............................17

ASSISTANCE 17 ................................................................................

BUILT-IN MICROWAVE OVEN SAFETY

You can be killed or seriously injured if you don't immediately

You can be killed or seriously injured if you don't follow

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

follow instructions.

instructions.

DANGER

WARNING

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting

installation. Read and follow the instructions provided

with any tools listed here.

Tools Needed

■Phillips #2 screwdriver

■Measuring tape

■Combination square/straight edge

■Pencil

■Drill (for wall cabinet installations)

■■Z\zn" (0.16 cm) drill bit (for wall cabinet installations)

■6" (15.2 cm) level

Parts Supplied

Check that all parts are included.

#8-14 x " screws (20)Z\x

Duct 1 (1) Duct 2 (1)

Duct 3 (1) Duct 4 (1)

Duct 5 (1)

Mounting Rails (2)

Trim Kit Frame (1)

Shims (1 pack)

#10- " x " self-drilling screw (2)C\v B\zn

Bottom Duct Attachment

Bracket (2)

Bottom Duct (1)

NOTE: #8-14 x " screws will come in 2 separate packages.Z\x

The microwave oven may be located in a cabinet and/or above

a built-in oven or warming drawer. Check the opening where

the microwave oven will be installed. The bottom surface of the

cutout must be a minimum of 36" (91.4 cm) above the ﬂoor.

The location must provide:

■Wood cabinetry.

■Cutout opening that is plumb and square. See “Minimum

Installation Clearances” in the “Minimum Dimensions” section.

■Cutout ﬂoor that is solid, level, and ﬂush with bottom of

cabinet cutout.

■Support for weight of at least 150 lbs (68 kg) which includes

microwave oven and items placed inside.

■Grounded electrical outlet. See the “Electrical Requirements”

section.

■Minimum installation clearances for installation location.

See the “Minimum Dimensions” section.

■Complete enclosure around the recessed portion

of the microwave oven, including a solid, full ceiling.

■A level ﬂoor – front to back and left to right.

Minimum Dimensions

Minimum Installation Clearances

For proper installation, the following minimum clearances must exist above and below the cutout opening.

Above Cabinet/Storage Drawer Installation Above Oven/Warming Drawer Installation

)

(25 mm)

11⁄ " 2

(38 mm)

(25 mm)

(76 mm)

A. Upper cabinet

B. Lower cabinet or storage drawer

C. Lower oven or warming drawer

NOTE: The bottom surface of the cutout must be a minimum of 36" (91.4 cm) above the ﬂoor.

Location Requirements

Especificaciones del producto

Marca:	JennAir
Categoría:	Magnetron
Modelo:	MKC4157ES
Color del producto:	Wit
Manual de usuario:	Ja
Diagonal de la pantalla:	15.1 "
Resolución:	1024 x 768 Pixels
Pantalla táctil:	Ja
Frecuencia del procesador:	2 GHz
Familia de procesadores:	Intel® Celeron®
Modelo de procesador:	J1900
Número de núcleos de procesador:	4
Adaptador gráfico:	HD Graphics
red LAN:	Ja
Brillo:	250 cd/m²
Número de puertos USB 2.0:	5
Puerto(s) VGA (D-Sub):	1
Número de puertos HDMI:	1
Número de puertos Ethernet LAN (RJ-45):	1
Pantalla, número de colores.:	16,2 miljoen kleuren
Conexión para adaptador de red:	Ja
Memoria interna:	4 GB
Puerto RS-232:	1
Tipo de memoria interna:	DDR3L-SDRAM
Tipo de medio de almacenamiento:	SSD
Montaje VESA:	Ja
Interfaz de montaje en panel:	75 x 75 mm
Ancho del dispositivo (con soporte):	380 mm
Dispositivo de profundidad (con soporte):	230 mm
Altura del dispositivo (con soporte):	360 mm
Peso (con soporte):	5500 g
LAN Ethernet, velocidades de transferencia de datos:	10,100,1000 Mbit/s
Soporta Windows:	Windows 10, Windows 7, Windows 8, Windows 8.1
Número de puertos USB 3.2 Gen 1 (3.1 Gen 1) Tipo A:	1
Hilos internos del procesador:	4
Caché del procesador:	2 MB
Capacidad total de almacenamiento:	64 GB
Capacidad SSD:	64 GB
Adaptador de CA, voltaje de salida:	12 V
Adaptador de CA, potencia de salida:	5 A
Tipo de vivienda:	Alles-in-een
Memoria de velocidad de reloj:	1600 MHz
interfaces SSD:	Micro Serial ATA
Salida de línea:	Ja
Entrada de línea:	Ja
Tecnología de pantalla táctil:	Capacitief
Procesador de bus frontal:	2.42 MHz
Tipo de ranura de memoria:	SO-DIMM
Adaptador gráfico, fabricante:	Intel
Adaptador de corriente incluido:	Ja
Temperatura de funcionamiento (TT):	0 - 40 °C
Tipo-de-visualización:	TFT