Jung 247EB Manual de Usario

Jung receptor 247EB

Lee a continuación 📖 el manual en español para Jung 247EB (4 páginas) en la categoría receptor. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/4

TRONIC amplifier, built-in

Light Management

TRONIC amplifier, built-in

Art.-No.: 247 EB

Operationsmanual

1 Safety instructions

Electrical equipment may only be installed and fitted by electrically skilled persons.

Failure to observe the instructions may cause damage to the device and result in fire and

other hazards.

Danger of electric shock. Always disconnect before carrying out work on the devise or

load. At the same time, take into account all circuit breakers that supply dangerous

voltage to the device or load.

Danger of electric shock. Device is not suitable for disconnection from supply voltage.

The load is not electrically isolated from the mains even when the device is switched off.

Do not connect any electronic lamps, e.g. switchable or dimmable compact fluorescent

lamps or LED lamps. Device can be damaged.

These instructions are an integral part of the product, and must remain with the end

customer.

2 Device components

picture 1

(1) Power extension

(2) Load connection

(3) Dimmer connection

3 Function

Intended use

- Output extension of TRONIC dimmers, which work according to the phase section

principle.

- Output extension of universal dimmers, which have detected an ohmic or capacitive basic

load.

Do not operate universal dimmers with an inductive load.

- Connection of filament lamps, HV halogen lamps and TRONIC transformers with halogen

lamps.

- Suitable for mixed operation up to the specified output (see chapter 5.1. Technical data)

- Do not operate the corresponding dimmers without a load.

- Installation in false ceilings or surface mounting

1/4

82539913

J:0082539913 11.08.2010

Product characteristics

- Connection of multiple power extensions to one dimmer possible

- Operation using upstream dimmer

- Electronic short-circuit protection with permanent switch-off after 7 seconds at the latest

- Electronic over-temperature protection

i Brightness differences between the lighting at the dimmer and the lightning at the power

extension are possible.

4 Information for electrically skilled persons

4.1 Fitting and electrical connection

DANGER!

Electrical shock when live parts are touched.

Electrical shocks can be fatal.

Before carrying out work on the device or load, disengage all the

corresponding circuit breakers. Cover up live parts in the working environment.

Fitting and connecting the power extension

i Use the same external conductor for dimmers and power extensions. Do not swap L and N

on the power extension. Otherwise, there is the risk of malfunction.

picture 2

(1) Power extension

(4) Dimmer

o Fit the power extension.

i Minimum diameter of ceiling opening for installation in false ceilings: 63 mm.

o Connect the power extension according to the connection diagram (picture 2).

i In the case of lighting systems with an output of more than 3500 W/VA, the installation

must divided across two circuit breakers with the same external conductor.

o If multiple circuit breakers supply dangerous voltages to the device or load, couple the

circuit breaker to ensure tripping.

2/4

82539913

J:0082539913 11.08.2010

Light Management

TRONIC amplifier, built-in

5 Appendix

5.1 Technical data

Rated voltage AC 230 V ~

Mains frequency 50 Hz

Ambient temperature +5 ... +45 °C

Housing temperature 70 °C (tc)

Power loss max. 10 W

Connected load at 25 °C

i Power specifications including transformer power dissipation.

Incandescent lamps 100 ... 700 W

HV halogen lamps 100 ... 700 W

Tronic transformers 100 ... 700 W

ohmic-capacitive 100 ... 700 W

Connection

Single stranded max. 4 mm²

finely stranded with conductor sleeve max. 1.5 mm²

Finely stranded max. 2.5 mm²

Number of power extensions max. 10

Total length power cable max. 100 m

Dimensions L×W×H 212×48.5×46 mm

The symbols used to label the dimmer load shows the load type that can be

connected to a dimmer and the electric behaviour of a load:

R = ohmic, C = capacitive

5.2 Troubleshooting

The power extension briefly switches its load off and on again.

Cause: short-circuit protection has tripped but now there is no longer a fault.

The power extension switches its load off and cannot be switched on again.

Cause 1: short-circuit protection has tripped.

Eliminate short-circuit.

Switch the power extension on again with the upstream dimmer.

i Short-circuit protection is not based on a conventional fuse, no metallic separation of the

operational current.

Cause 2: overheating protection has tripped.

Disconnect device from mains, also switch associated off circuit breakers.

Let device cool down for at least 15 minutes.

Check the installation situation.

Reduce the connected load.

Switch circuit breakers and device on again.

All the loads are switched off.

Cause: Device protection dimmer has tripped.

Check the dimmer.

3/4

82539913

J:0082539913 11.08.2010

Light Management

TRONIC amplifier, built-in

Especificaciones del producto

Marca:	Jung
Categoría:	receptor
Modelo:	247EB
Peso.:	880 g
Ancho:	63 mm
Profundidad:	219 mm
Altura:	35.5 mm
Código de seguridad internacional (IP):	IP20
Certificados de sostenibilidad:	RoHS
Potencia de salida:	150 W
Abarcando:	24 V
voltaje-de-entrada-de-CA:	100 - 305 V