Kelty Tao 2 Manual de Usario

Kelty Carpa Tao 2

Lee a continuación 📖 el manual en español para Kelty Tao 2 (2 páginas) en la categoría Carpa. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
Setting up your tent
Spread the tent body on the ground.
Assemble the poles. Avoid having the shockcord snap the pole sections together
, this can damage the pole
Insert the spring pin found at a corner of the tent into the end of a pole.
Go to the opposite corner, and insert that spring pin into the other end of the pole.
Repeat for the other pole.
Attach the plastic clips on the tent body to the poles (notice they are color coded to make it even easier!).
Stake the tent down! (If you are having a hard time staking into the ground you can use rocks to anchor do
your tent. See Figures B-1and B-2) In order to get the tautest pitch, it is best to start at any corner, then mov
to the diagonal corner for the next stake until all four are staked out.
Figure B-1 Figure B-2
Tao 2
Pitching Directions
FastFACT
Both tent poles are
the same size.
Your Kelty Tao 2 tent should include:
1 Tent body
1 Tent Fly
2 12mm prebent DA17 aluminum tent poles
1 Small stake sack containing:
-13 Aluminum tent stakes
- 7 guylines with adjusters
- 1 Tent Manual
- 1 Set of Instructions
54"
88"
45.5"34"
34"
122"
Pitching the Rainfly
FastFACT
The rainfly clips
with quick-release
buckles. (see Figure C)
Figure C
a
b
a- tent clip
b- fly clip
Attaching the fly
Find the zipper in the fly. This will be the vestibule entrance at the front
of the tent. Drape the fly over the tent body.
Clip the buckles on the fly to the buckles at each corner of the tent body.
Stake out the vestibule at the front of the tent so that it is taut.
Cinch the webbing on the fly buckles at each corner of the tent.
Notes and Tips
If you pitch the tent in a wind, anchor the tent before you put the poles in. Also, gear alone probably won’t
hold down your tent even in winds as light as 25mph. Many tents have been destroyed by unexpected winds
rolling them away with gear inside! In strong winds you will want to anchor every stake loop and guyout.
The vestibules are equipped with closable vents. Opening both vents allows excellent flow-through ventilation.
Loops on the tent’s ceiling are for tying in the gear loft. You can also string cord between the loops to make a
drying rack. The small pockets next to the doors are for sunglasses and a flashlight.
Leaving the fly on the tent when you take it down is sometimes handy. Packing the tent and fly as a single
connected unit speeds setup and the tent will be immediately protected from rain when you pull it out next
time. Before packing you should dry out the tent and fly. This way you won’t have to carry water rolled into
the tent and it will help keep the tent from mildewing.
Fire near your tent is a no-no. Your tent can burn. Never cook in your tent or use candles for light inside.
To minimize UV damage from the sun, don’t keep tent set up for long periods of time or when not in use.
The best way to use rocks for staking and guying out in rocky terrain is to find one large and one small rock.
Tie a piece of cord from your stake or guy-out point around the small rock, then set the large rock on top of
the cord right next to the small rock. Pull back until it’s tight. (See figures B1 and B2)
If there is any part of these directions you do not fully understand please call Kelty customer services at 800•423•2320

Especificaciones del producto

Marca: Kelty
Categoría: Carpa
Modelo: Tao 2
Colocación del dispositivo: Aanrecht
Contenido (interior): 25 l
Tipo de operación: Draaiknop
poder del magnetrón: 900 W
Color del producto: Crème
Placa giratoria: Ja
Tamaño del tocadiscos: 270 mm
Pantalla incorporada: Nee
Temporizador: Ja
Ancho: 484 mm
Profundidad: 410 mm
Altura: 278 mm
Impuesto neto: 1400 W
Ancho del embalaje: 550 mm
Empaquetadura en profundidad: 455 mm
Altura del embalaje: 335 mm
Desactivación del tocadiscos: Ja
Función de descongelación: Ja
Manual de usuario: Ja
Tipo temporizador: Mechanisch
Cantidad de programas de descongelación: 6
voltaje-de-entrada-de-CA: 220 - 240 V
Frecuencia-de-entrada-de-CA: 50 Hz
Tipo-producto: Solo-magnetron

¿Necesitas ayuda?

Si necesitas ayuda con Kelty Tao 2 haz una pregunta a continuación y otros usuarios te responderán




Carpa Kelty Manuales

Carpa Manuales

Últimos Carpa Manuales