Kenwood Excelon CA-PLT14SG Manual de Usario

Kenwood No categorizado Excelon CA-PLT14SG

Lee a continuación 📖 el manual en español para Kenwood Excelon CA-PLT14SG (2 páginas) en la categoría No categorizado. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new product.
© 2023 JVCKENWOOD Corporation
CA-PLT14SG
AMPLIFIER MOUNTING PLATE DESIGNED AND ENGINEERED FOR
2014-UP HARLEY-DAVIDSON® STREET GLIDE®, ULTRA, OR ULTRA TRIKE
MOTORCYCLES
INSTRUCTION MANUAL
JVCKENWOOD Corporation
Important Notes
©2023 JVCKENWOOD Corporation. All Rights Reserved. KENWOOD® and eXcelon®
are registered trademarks of JVCKENWOOD Corporation. Harley-Davidson®, Electra
Glide®, Road Glide®, Street Glide®, Ultra Classic®, Tri Glide®, CVO™, Screamin Eagle®
and Tour-Paare trademarks or registered trademarks of Harley-Davidson, Inc. and/
or its affiliates and if used or implied are for reference only. There is no affiliation
between Harley-Davidson, Inc. and/or its aliates and JVCKENWOOD Corporation
and/or its aliates. All other trademarks are the property of their respective owners.
Specications subject to change without notice.
The CA-PLT14SG plate is made to mount ampliers
with a maximum dimension of 8.5” W x 7” D x 2” H
(216mm x 178mm x 51mm).
Installation procedure
1. Over the top of the radio, pull up to release each wire harness from the black plate
via the factory “Christmas tree fasteners. If your bike has factory GPS, the small square
antenna will need to be relocated just behind the voltmeter as shown in Fig 1.1 below.
Figure 1.1 - The white circle shows the new location for the GPS Antenna if your bike
came factory equipped with this feature.
2. Remove the four factory T-20 “Torx screws that go through the top of the black plate
and into the top of the radio. Set these screws aside for now.
3. Sit the main amplier plate over the top of the radio, noting the 4 holes in the plate will
line up with the 4 holes left by the factory screws just removed. The factory screws will
now go through the main mounting plate, through the black plate over the top of the
radio, and into the top of the radio.
4. Locate the Velcro® that came in the box and stick it to the bottom plate of the amp
being installed. You can now stick the amp to the mounting plate just installed.
Depending on the amp you are installing, you can use the “tabs on the CA-PLT14SG to
re-secure the wire harnesses that were held in place using the Christmas Tree Fasteners.
For updated information (the latest Instruction Manual, etc.),
please visit the following website:
https://manual.kenwood.com/en_contents/search/

Especificaciones del producto

Marca: Kenwood
Categoría: No categorizado
Modelo: Excelon CA-PLT14SG

¿Necesitas ayuda?

Si necesitas ayuda con Kenwood Excelon CA-PLT14SG haz una pregunta a continuación y otros usuarios te responderán




No categorizado Kenwood Manuales

No categorizado Manuales

Últimos No categorizado Manuales