Kenwood SJM250 Manual de Usario

Kenwood Pava SJM250

Lee a continuación 📖 el manual en español para Kenwood SJM250 (55 páginas) en la categoría Pava. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/55
English 2 - 4
Nederlands 5 - 7
Français 8 - 10
Deutsch 11 - 13
Italiano 14 - 16
Português 17 - 19
Español 20 - 22
Dansk 23 - 25
Svenska 26 - 28
Norsk 29 - 31
Suomi 32 - 34
Türkçe 35 - 37
Ïesky 38 - 40
Magyar 41 - 43
Polski 44 - 46
Русский 47 - 49
Ekkgmij 50 - 53
Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
www.kenwoodworld.com 18261/1
SJM240 series
SJM250 series
´¸∂w
54 55-
UNFOLD
before using your Kenwood
appliance
Read these instructions carefully and
retain for future reference.
Remove all packaging and any
labels.
safety
Always use the filter and never
overfill - boiling water may splash
out.
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid or spout area
when refilling.
Beware: the metal body of the kettle
will get hot during operation.
Never let the cord hang down where
a child could grab it.
Always unplug your kettle
when not in use.
Never put the kettle, powerbase,
cord or plug in liquid.
Never use a damaged appliance.
Get it checked or repaired: see
‘service’
Caution: Do not operate the kettle
on an inclined surface.
Only use the powerbase supplied
and keep it clean and dry.
Make sure the lid is secure before
switching the kettle on.
Warning: Do not open the lid while
the water is boiling.
Take care when opening the lid -
droplets of hot water may be
ejected.
Make sure the kettle is switched off
before lifting or pouring.
Remove the kettle from the base
before filling or pouring.
Never put the kettle near or on
cooker hot plates or gas burners.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
This kettle is for boiling water only.
Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
1 Wrap any excess cord around the
bracket on the underside of the
powerbase .
2 Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
key
lid release
hinged lid
spout
filter
water level window
on/off switch with indicator light
360° powerbase
cord wrap
English
2
to use your kettle
1 Fill the kettle through either the
spout or lid. To open the lid, push
the lid release and pull the lid back
. The water level must be between
‘MAXand ‘MIN’.
Be economical: do not boil more
water than you need.
To improve the quality of your drinks
always use fresh water.
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
“descaling”.
Your kettle is fitted with a filter to
hold back limescale particles.
If you find drops of water under your
kettle, don’t worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
care and cleaning
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid.
2 Remove the filter by holding the tab
and then lifting the filter out .
3either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To re-fit the filter, hold the tab .
Then slide the filter down into the
bracket until secure .
descaling
Regular descaling of the flat element
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
problems may be experienced
with the kettle switching on and
off during use or switching off
before boiling.
the kettle may take longer to boil.
the flat element may be damaged.
Please note: Failure to descale your
kettle may invalidate your guarantee.
When limescale starts to build up on
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
Alternatively, to reduce limescale
build up, use filtered water to fill your
kettle.
A range of Kenwood jug water filters
are available.
3

Especificaciones del producto

Marca: Kenwood
Categoría: Pava
Modelo: SJM250

¿Necesitas ayuda?

Si necesitas ayuda con Kenwood SJM250 haz una pregunta a continuación y otros usuarios te responderán




Pava Kenwood Manuales

Pava Manuales

Últimos Pava Manuales