Kicker KX300.4 Manual de Usario
Kicker
Radio del coche
KX300.4
Lee a continuación 📖 el manual en español para Kicker KX300.4 (12 páginas) en la categoría Radio del coche. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/12
Congratulations! You have just purchased the latest in amplifier tech-
nology to carry the famous KICKER name. Your KICKER KX series
amplifier is designed and built to give you years of powerful and trou-
ble-free performance. This installation manual contains valuable infor-
mation on how to get the most out of your new KX series amplifier.
Thanks for buying KICKER. Enjoy!
KX Amplifier Features
Low Impedance Operation Stable into 2 ohm stereo or 4 ohm mono loads.
SORT Protection Circuitry ( ver-voltage, Short circuit, O Reverse polarity,
Thermal) Protects amplifier from accidents and undesired operation.
MOSFET Power Supply Provides high efficiency operation.
KickBass Variable bass boost circuit which provides up to 18 dB of boost at 40
Hz.
Built-In Variable Crossover 12 dB High pass or Low pass variable from 50-
200 Hz. Defeatable for full range operation.
High & Low level inputs Allows connection to various sources such as: after-
market stereo, factory radio, DVD Player, Video Cassette Player, etc..
Custom tooled gold plated connectors Assure maximum power transfer
and damping.
SAMS S A M S( tereo nd ono imultaneously) Amplifier will operate into a bridged
mono load and a stereo load at the same time.
Remote Bass Level Control Dash mounted for maximum control.
(Not included in the KX300.4)
Two Year Warranty When
purchased from and installed by
an Authorized
KICKER Dealer.
KX300.4 / KX600.4 / KX800.4
2
With the shroud removed, you now have access to the four mounting holes in
the mounting feet and all wiring connections. Drill 4 holes using a 7/64” drill bit
and use the supplied #8 screws to mount the amplifier.
REMOVE REMOVE
REMOVE
REMOVE
Mounting Instructions
When selecting a location to mount your Kicker amplifier be sure it is struc-
turally sound and that there are no items behind the area that could be dam-
aged by the screws. Check for brake lines, fuel lines, gas tanks, or wiring harness-
es etc.
All amplifiers generate heat under normal operation. Be sure to choose a loca-
tion that allows adequate ventilation for the amplifier. Also consider that the air
temperature inside an automobiles trunk can reach upwards of 140 degrees
fahrenheit. An amplifier mounted here may require additional cooling tactics
such as fans or venting to allow cool operation. If possible, mounting the amp in
the passenger compartment will allow cooler operation.
Remember that the controls on top of the amp will need to be accessible for
adjustment later. Keep this in mind as you choose your amplifier’s mounting
location.
Now that you are ready to mount your amplifier, use the supplied 3mm allen
wrench to remove the amplifier shroud. This will give you access to the mount-
ing holes in the amplifier and all wiring connections.
3
Wiring Instructions
Signal can be input into the amplifier using either the low level RCA input con-
nections or the high level (speaker level) connections. Using the low level RCA
connections is the preferred method. Use the high level inputs only if your head
unit does not have low level RCA type outputs.
The use of twisted pair interconnects is recommended for all installations to
minimize noise. When routing these cables through the automobile, try to keep
them away from factory wiring harnesses and other power wiring. If you need to
cross any of this wiring do so at a 90 degree angle to reduce the potential of
noise problems.
When working with power connections it is always recommended that you dis-
connect the battery to prevent accidents.
The ground should be connected to the amplifier first before making any of
the other connections. This wire should be as short as possible (24 inches or less)
and connected to a paint/corrosion free solid metal area of the car’s chassis. Use
the same gauge wire as recommended for the amplifiers power connection to
the battery. Adding an additional ground wire between the car battery’s negative
post and the car chassis of this same gauge (or larger) is also recommended.
If you ever need to remove the amp from the vehicle after it has been
installed, the ground wire should be the last wire disconnected from the amplifi-
er, just the opposite as when you installed it.
A fuse must be installed within 18 inches of the battery to protect the power
wire feeding your amplifier. This fuse should be of at least the same value used
in the amplifier but no higher than the capacity of the wire. See the chart below
for wire size and fusing recommendations.
Model Fuse Size Wire Size
KX-300.4 40A 8 GA
KX-600.4 80A 4 GA
KX-800.4 120A 2 GA
L R L R
Amp 1 Amp 2
L+ L - R + R - L+ L - R + R -
SOURCE UNIT
BRIDGE BRIDGE
LEFT +
LEFT -
RIGHT -
RIGHT +
LEFT +
LEFT -
RIGHT -
RIGHT +
Amp 2
A MP 1
Amp 1 Amp 2
+ - - + + - - + WARNING-Use Only
High Or Low Level
NOT...Both!!!
OFF
HI
PAS S
LO PASS
OFF
HI PASS
LO PASS
AMP 1 AMP 2
HI-LEVEL INPUT
A
MP 1
AMP 2
REMOT E B ASS
Especificaciones del producto
| Marca: | Kicker |
| Categoría: | Radio del coche |
| Modelo: | KX300.4 |
¿Necesitas ayuda?
Si necesitas ayuda con Kicker KX300.4 haz una pregunta a continuación y otros usuarios te responderán
Radio del coche Kicker Manuales
4 Octubre 2024
1 Octubre 2024
29 Septiembre 2024
23 Septiembre 2024
18 Septiembre 2024
16 Septiembre 2024
12 Septiembre 2024
12 Septiembre 2024
3 Septiembre 2024
30 Agosto 2024
Radio del coche Manuales
- Radio del coche Sony
- Radio del coche LG
- Radio del coche AEG
- Radio del coche Philips
- Radio del coche Panasonic
- Radio del coche Daewoo
- Radio del coche Ford
- Radio del coche Grundig
- Radio del coche JVC
- Radio del coche JBL
- Radio del coche Kenwood
- Radio del coche Medion
- Radio del coche Pioneer
- Radio del coche Volvo
- Radio del coche Aiwa
- Radio del coche Akai
- Radio del coche Alpine
- Radio del coche Audison
- Radio del coche Silvercrest
- Radio del coche Lenco
- Radio del coche Pyle
- Radio del coche Manta
- Radio del coche Tevion
- Radio del coche Caliber
- Radio del coche Hyundai
- Radio del coche Renkforce
- Radio del coche Clatronic
- Radio del coche Blaupunkt
- Radio del coche Harman Kardon
- Radio del coche Crunch
- Radio del coche Skoda
- Radio del coche Denver
- Radio del coche Stinger
- Radio del coche Hifonics
- Radio del coche Maginon
- Radio del coche Varta
- Radio del coche Rockford Fosgate
- Radio del coche Marquant
- Radio del coche Clarion
- Radio del coche Muse
- Radio del coche Mac Audio
- Radio del coche Audiovox
- Radio del coche Dual
- Radio del coche Boss
- Radio del coche MB Quart
- Radio del coche Auna
- Radio del coche Xblitz
- Radio del coche Trevi
- Radio del coche Orion
- Radio del coche Magnat
- Radio del coche Technaxx
- Radio del coche Mercedes-Benz
- Radio del coche Autovision
- Radio del coche Lanzar
- Radio del coche Hertz
- Radio del coche Jensen
- Radio del coche Roadstar
- Radio del coche Scott
- Radio del coche Zenec
- Radio del coche MT Logic
- Radio del coche Shuttle
- Radio del coche Ultimate
- Radio del coche Conceptronic
- Radio del coche Fusion
- Radio del coche Revo
- Radio del coche Elta
- Radio del coche Axton
- Radio del coche VDO
- Radio del coche Soundstream
- Radio del coche DLS
- Radio del coche VDO Dayton
- Radio del coche Macrom
- Radio del coche Watssound
- Radio del coche Tamashi
- Radio del coche Orava
- Radio del coche Emphaser
- Radio del coche Scion
- Radio del coche RTO
- Radio del coche Spectron
- Radio del coche Mtx Audio
- Radio del coche Ground Zero
- Radio del coche Multilaser
- Radio del coche Raveland
- Radio del coche ESX
- Radio del coche RetroSound
- Radio del coche Planet Audio
- Radio del coche Rodek
- Radio del coche Eclipse
- Radio del coche Voxx
- Radio del coche SoundMAX
- Radio del coche Mystery
Últimos Radio del coche Manuales
27 Octubre 2024
27 Octubre 2024
27 Octubre 2024
27 Octubre 2024
23 Octubre 2024
20 Octubre 2024
20 Octubre 2024
20 Octubre 2024
20 Octubre 2024
20 Octubre 2024