Kicker SubStage SSIEXT07 Manual de Usario

Kicker Altavoz de subgraves SubStage SSIEXT07

Lee a continuación 📖 el manual en español para Kicker SubStage SSIEXT07 (10 páginas) en la categoría Altavoz de subgraves. Esta guía fue útil para 14 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/10

SSIEXT07

Designed for 2007 and newer GM® Silverado/Sierra Extended Cab vehicles

(Not compatible with vehicles equipped with the full-width rear bench)

Subwoofer Assembly

Subwoofer Power Harness

Subwoofer Body Harness

Wire Taps x2

25A Fuse

Wire Ties x6

Adaptor Harness

SSIEXT07-A.2-20121213

Installation

1. Disconnect the negative battery cable from the battery. (For diesel engines with dual batteries disconnect

both negative cables)

2. Remove cover on the driver’s end of the dash. Fig. 1

3. Remove the bolt securing the parking brake release lever. Some trucks may not have a release lever but

there is still a bolt in that location that needs to be removed. Fig. 2

4. Remove the two screws securing the panel below the steering column and pull the panel loose. Fig. 2

5. Remove the two screws securing the panel below the radio and pull the panel loose.

6. Pull loose the radio bezel and disconnect wiring. Fig. 3

7. Remove the six screws securing the radio and HVAC controls. HVAC control wiring does not need to be

disconnected. Fig. 4

8. Pull radio from dash and disconnect all wiring.

9. Route the signal input wire with the white two pin connector on it along the driver’s side of the vehicle and

up to the driver’s kick panel or radio opening depending on installation. (If vehicle is equipped with the

Factory Premium sound system, refer to the instructions for Factory Premium sound system for signal wire

routing and connection.)

Subwoofer Input Connection with Optional Ampliﬁ er

10. Connect the white two pin connector of the ampliﬁ er harness to the corresponding connector of the

subwoofer harness.

Subwoofer Input Connection without Optional Ampliﬁ er and without Factory Premium Audio

11. Connect the six inch adaptor harness to the end of the two pin connector. Locate position 2 and 9 on

the radio connector and install one of the blue wire taps onto the wire. Lay the wire in the open channel, fold

the wire tap over and squeeze with a pair of pliers until it snaps shut. Connect the green wire of the adaptor

harness to the wire in position 2 and the brown wire to the wire in position 9. Fig. 7

Subwoofer Input Connection with Factory Premium Audio

12. Pry loose the storage tray in the center console. Fig. 5

13. Starting at the end of the subwoofer harness that was routed toward the dash, carefully cut the

sheathing back about 30 inches. Fig. 6

14. Pull the signal wire out and route it under the carpet and into the center console. Connect the six inch

adaptor harness to the end of the two pin connector. Locate the blue with a white stripe wire and the green

with a black strip wire. Install one of the blue wire taps onto each wire. Lay the wire in the open channel, fold

the wire tap over and squeeze with a pair of pliers until the wire tap snaps shut. Fig. 7

15. Connect the green wire of the adaptor harness to the blue/white wire and the brown wire of the adaptor

harness to the green/black wire. Fig. 8

NOTE: Remember to place your warranty card in the glove box for future use.

Especificaciones del producto

Marca:	Kicker
Categoría:	Altavoz de subgraves
Modelo:	SubStage SSIEXT07
Color del producto:	Blauw
Peso.:	517.5 g
Ancho:	207 mm
Profundidad:	19 mm
Altura:	132 mm
Peso del embalaje:	1069 g
Ancho del embalaje:	330 mm
Empaquetadura en profundidad:	58 mm
Altura del embalaje:	279 mm
Material de la carcasa:	Kunststof
Edad recomendada (máx.):	11 jaar
Edad recomendada (mín.):	3 jaar
País de origen:	China
Número soportado de baterías/baterías:	1
Certificación:	CE
Se requieren baterías:	Ja
Idiomas soportados:	Nederlands
Género recomendado:	Jongen/meisje
se requiere ensamblaje:	Nee
Altura del paquete principal (exterior):	306 mm
Ancho del embalaje principal (exterior):	353 mm
Peso bruto del embalaje principal (exterior):	4690 g
Longitud del paquete principal (exterior):	261 mm
Cantidad por caja principal (exterior):	4 stuk(s)
Productos por palet:	180 stuk(s)
Baterias-incluidas:	Ja
Tecnología de batería:	Lithium-Polymeer (LiPo)
Batería recargable:	Nee
La ley por palet:	5 stuk(s)
Número de paquetes principales (exteriores) por palet:	45 stuk(s)
Número de cajas por capa de palet:	9 stuk(s)
Número GTIN (EAN/UPC) (exterior) embalaje principal:	43417761838233
Contenido del embalaje principal (exterior):	28192.7 cm³
Volumen de embalaje:	5340.06 cm³
Habilidades de aprendizaje y entrenamiento.:	Critical thinking training, Logical thinking training, Reading learning, Problem solving skills training, Creative thinking skills training, Math & counting learning