Kingston HyperX FURY Manual de Usario

Kingston Destello de luz HyperX FURY

Lee a continuación 📖 el manual en español para Kingston HyperX FURY (2 páginas) en la categoría Destello de luz. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/2

DESCRIPTION

HyperX HX316C10FB/8 is a 1G x 64-bit (8GB) DDR3-1600

CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module,

based on sixteen 512M x 8-bit DDR3 FBGA components. This

module has been tested to run at DDR3-1600 at a low latency

timing of 10-10-10 at 1.5V. Additional timing parameters are

shown in the PnP Timing Parameters section below. The

JEDEC standard electrical and mechanical specifications are

as follows:

Document No. 4807007-001.B00 04/23/15 Page 1

SPECIFICATIONS

selcyc 01)DDI(LC

Row Cycle Time (tRCmin) 48.125ns (min.)

Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 37.5ns (min.)

Maximum Operating Power TBD W*

0 - V 49gnitaR LU

Operating Temperature 0o C to 85o C

Storage Temperature -55o C to +100o C

*Power will vary depending on the SDRAM used.

FEATURES

•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

•VDDQ = 1.5V (1.425V ~ 1.575V)

•800MHz fCK for 1600Mb/sec/pin

•8 independent internal bank

•Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•8-bit pre-fetch

•Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the ﬂy using A12 or

MRS]

•Bi-directional Diﬀerential Data Strobe

•Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•On Die Termination using ODT pin

•Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•Asynchronous Reset

•Height 1.291” (32.80mm) w/heatsink, double sided

component

HX316C10FB/8

8GB 1G x 64-Bit DDR3-1600

CL10 240-Pin DIMM

Continued >>

kingston.com/hyperx

PnP JEDEC TIMING PARAMETERS:

•DDR3-1600 CL10-10-10 @1.5V

•DDR3-1333 CL9-9-9 @1.5V

•DDR3-1066 CL7-7-7 @1.5V

Note: The PnP feature oﬀers a range of speed and timing options to support

the widest variety of processors and chipsets. Your maximum speed will

be determined by your BIOS.

Document No. 4807007-001.B00 Page 2

continued HyperX

All Kingston products are tested to meet our published speciﬁcations. Some motherboards or system conﬁgurations may not operate at

the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers

faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX

kingston.com/hyperx

7.08 mm

133.35 mm

32.8 mm

MODULE DIMENSIONS

MODULE WITH HEAT SPREADER

Especificaciones del producto

Marca:	Kingston
Categoría:	Destello de luz
Modelo:	HyperX FURY
Tipo de operación:	Knoppen
Color del producto:	Zwart
Nivel de ruido:	57 dB
País de origen:	China
Kijkglas:	Ja
Ruedas:	Ja
hombre volumen:	41.64 l
Anchura de trabajo:	- mm
Destruye CD:	Ja
Triturar papel:	Ja
Trituración de tarjetas de crédito:	Ja
Destruye al tamaño:	- mm
tipo snij:	Dwarsversnippering
Capacidad de la destructora de documentos:	300 vel
tipo de destructor:	Kruisversnippering
Procesa grapas:	Ja
Procesa clips de papel:	Ja
Nivel de seguridad:	P-4
Capacidad-de-la-cesta:	450 vel
Indicación de uso:	16 min
Mecanismo antiobstrucción:	Ja
Indicador de bandeja de salida llena:	Ja
Modo-de-ahorro-de-energía:	Ja
Piezas autolubricantes:	Nee
Capacidad de trituración manual:	8 vel