Kramer SKIC-6 Manual de Usario

Kramer soporte de altavoz SKIC-6

Lee a continuación 📖 el manual en español para Kramer SKIC-6 (2 páginas) en la categoría soporte de altavoz. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/2
SKIC Speaker Mounting Kit
Congratulations on purchasing your Kramer SKIC Speaker Mounting Kit which used for is
securing in-ceiling speakers to the ceiling T-channel grid and comes in three sizes: SKIC-4 for
the Galil 4-CO, SKIC-6 for the Galil 6-CO for the and SKIC-8 Galil 8-CO.
The back can speakers are supported by a C-ring and two tile rails he tile rails prevent the (t
speakers from falling if the tile itself comes out or falls apart, as their ends catch onto the
T-grid). When mounting onto the ceiling tiles, use both supports. When mounting onto a
sheetrock ceiling, the C-ring alone is used to reinforce the ceiling material.
Be sure that the tiles can support the speaker. Smaller sized tiles or fiberglass-type tiles cannot
support the weight of the speakers. In such a case, the speakers will require additional support.
Each Speaker Mounting Kit includes: SKIC
Eight support ring screws, washers
and nuts
Two ceiling support rings (C-ring)
Four tile rails
Installing the Speaker Mounting Kit
The is installed after cutting the opening in the ceiling tile for the speakers. SKIC
To install the SKIC, as illustrated in the example in Figure 1, do the following:
1. Place the C-ring over the hole cut in the ceiling tile (on the “ceiling” side). Place it around
the hole so that the tabs located in parallel to the tile edges. are
Figure 1: Installing the Back Can Speakers
2. Place the tile rails the tile and snap them into the two tabs on the C-ring. on
Align the rails so that the ends extend over the T-channel grid.
3. Insert 2 screws through each tab on the C-ring to secure the rails.
4. Push the speaker into the ceiling hole until the front baffle rim is leveled with the ceiling.
5. Tighten the mounting tabs (see Figure 2).
When tightening the mounting tabs, the tabs automatically turn outward, thus clamping
the speaker to the wall from its rear side.
Note: Do not over-tighten the mounting tabs. It may cause damage to both the speakers
and the surface.
Figure 2: Tightening the Mounting Tabs
Specifications
DIMENSIONS:
Tile rails: 64.1cm x 2.2cm x 3cm ( .2 0.2. 25 ” x 0.87” x 97”) W, D, H
21.6cm x 8cm (8.5” x 3.15”)
Model
Outer Diameter
Inner Diameter
SKIC 4
18.5 ( ) cm 7.28”
14.2 cm (5.6”)
SKIC 6
24. 9.532 (cm ”)
20cm (7.9”)
SKIC 8
28.6cm (11.3”)
24.4cm (9.6 ) ”
DISTANCE
BETWEEN FIXING
POINTS:
SKIC 4: 19.1cm (7. ) approx. 5”
SKIC 6: 25.1cm (9. ) approx. 9”
SKIC 8: 29.5cm ( . ) approx.11 6”
WEIGHT OF
MOUNTING KIT
(FOR PAIR):
SKIC 4: 1.03kg (2.27lbs) approx.
SKIC 6: 1.08kg (2. lbs) approx. 38
SKIC 8: 1.14kg (2. lbs) approx. 51
SHIPPING WEIGHT
(FOR PAIR):
SKIC 4: 1.18kg (2.6lbs) approx.
SKIC 6: 1.27kg (2.8lbs) approx.
SKIC 8: 1.36kg (3lbs) approx.
K RAMER ELECT RONICS LT D .
Installation
Instructions
MODELS:
SKIC-4 (for the Galil 4-CO)
SKIC-6 (for the Galil 6-CO)
SKIC-8 (for the Galil 8-CO)
Speaker Mounting Kits
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to these installation
instructions may be found.
We welcome y
We welcome y
We welcome y
We welcome yWe welcome your questions, comments, and feedback.
our questions, comments, and feedback.
our questions, comments, and feedback.
our questions, comments, and feedback.our questions, comments, and feedback.
Web site: www.kramerelectronics.com
E-mail: info@kramerel.com
SAFETY WARNING
Disconnect the unit from the power
supply before opening and servicing
P/N: 29 00-300440 Rev 2
P/N:
2900- 300440
Rev:
2
!

Especificaciones del producto

Marca: Kramer
Categoría: soporte de altavoz
Modelo: SKIC-6

¿Necesitas ayuda?

Si necesitas ayuda con Kramer SKIC-6 haz una pregunta a continuación y otros usuarios te responderán


soporte de altavoz Kramer Manuales

Kramer

Kramer SKIC-6 Manual de Usario

29 Agosto 2024

soporte de altavoz Manuales

Últimos soporte de altavoz Manuales

Pioneer

Pioneer CP-4EX Manual de Usario

4 Octubre 2024
Nedis

Nedis SPMT5750BK Manual de Usario

3 Octubre 2024
Bose

Bose FS3B-II Surface Mount Kit Manual de Usario

30 Septiembre 2024
Vogels

Vogels Sound 4203 Manual de Usario

27 Septiembre 2024
Extron

Extron V-Lock Manual de Usario

19 Septiembre 2024
Extron

Extron SMK VRE 48 Manual de Usario

19 Septiembre 2024
Sanus

Sanus BSWM3IWP Manual de Usario

19 Septiembre 2024
Sanus

Sanus WSWM3IWP Manual de Usario

19 Septiembre 2024
Valcom

Valcom V-9915M Manual de Usario

19 Septiembre 2024
Valcom

Valcom V-9912M Manual de Usario

19 Septiembre 2024