Majella MLEG Manual de Usario

Lee a continuación 📖 el manual en español para Majella MLEG (6 páginas) en la categoría No categorizado. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/6
!
!
!
!
!
!
!
!
!
MLEG USER MANUAL
Version 1.0
!
!
!
!
!
!
LOOPABLE ENVELOPE GENERATOR (MLEG))
User Manual
©2020 Majella Audio
2
INTRODUCTION
The MLEG is a loop-able envelope
generator. The envelope generator can be
set to loop, to continuously generate an
Attack/Decay signal (LFO). If not looped the
MLEG behaves as a normal ADSR envelope.
The MLEG has an attenuverter / polarizer on
the output, for amount/polarization control!
CONTENT
In the box of the assembled version of the
MLEG contains the. following
!Assembled and Tested Module
!16 pin to 16 pin ribbon cable
!Mounting hardware: 4x M3 screws
and M3 washers / rack crash
protectors
If anything of the above is missing. Please
contact your dealer or support@majella-
audio.com
SPECIFICATIONS
!Dimensions: 128.5 x 30 x 35mm
(6HP)
!Doepfer A-100 Eurorack compatible
(16 pin power connector)
!Power consumption: +/- 12V (27mA)
POWER CONNECTION
This module is designed to be connected to
your Eurorack system, using a 16- pin ribbon
cable. The -12V (red stripe) should be
directed as shown in the picture below.
W A RN IN G !
This module is designed for Eurorack
systems. The supply should be +-12V and
connected signals should not be out of the
+-12V range!
Do not reverse polarity when
connecting the power, this will damage
your module permanently!
LOOPABLE ENVELOPE GENERATOR (MLEG))
User Manual
©2020 Majella Audio
3
OVERVIEW
OVERVIEW
OVERVIEW
OVERVIEW OVERVIEW (See figu
(See figu
(See figu
(See figu(See figure 1)
re 1)
re 1)
re 1)re 1)
CONTROLS
1.!ATTACK
Controls the length of the Attack slope.
2.!DECAY
Controls the length of the Decay slope.
3.!SUSTAIN
Controls the Sustain level.
4.!RELEASE
Controls the length of the Release slope.
5.!ATTENUVERTER / POLARIZER
Controls the output level and polarization.
See page 4 for more info about the
attenuverter.
6.!FAST / SLOW button
When pressed, the slew time (rise/fall) of the
Attack, Decay and Sustain will be
significantly longer.
7.!LOOP
When pressed, the Attack and Decay stages
will loop. The speed / / rate frequency it
determined by Attack and Decay. page See
5 for more info about the loop functionality.
CONNECTIONS
8.!GATE
Gate input: At 0V (LOW) the envelope has
0V (LOW) output. At 5V (HIGH) or higher the
envelope will be triggered. See page 5 for
info about the behavior when LOOP is
pressed.
9.!OUTPUT
Envelope output (+- ) 8V .
Figure 1: Overview

Especificaciones del producto

Marca: Majella
Categoría: No categorizado
Modelo: MLEG

¿Necesitas ayuda?

Si necesitas ayuda con Majella MLEG haz una pregunta a continuación y otros usuarios te responderán




No categorizado Majella Manuales

No categorizado Manuales

Últimos No categorizado Manuales