Ozito PXBSDMK-4182 Manual de Usario

Ozito No categorizado PXBSDMK-4182

Lee a continuación 📖 el manual en español para Ozito PXBSDMK-4182 (10 páginas) en la categoría No categorizado. Esta guía fue útil para 12 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/10
BRUSHLESS
STEEL DECK
LAWN MOWER
ORIGINAL INSTRUCTIONS
SPECIFICATIONS
Voltage: 18V x 2
Cutting Diameter: 460mm (18”)
Cutting Heights: 25 - 80mm, 9 position
No Load Speed: 2,900/min
Grass Catcher: 50 litres
Noise Rating: 96dB
Tool Weight: 19.75kg
PXBSDMS-0182
Brushless Lawn Mower
ozito.com.au
Safety Key & Cable Clips
Top Handle
Lower Handle
Handle Assembly Fasteners &
Spanner
STANDARD EQUIPMENT
WARRANTY
0920
IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST
RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE
WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO RETURNING
YOUR PRODUCT FOR WARRANTY PLEASE TELEPHONE OUR CUSTOMER
SERVICE HELPLINE:
Australia 1800 069 486
New Zealand 0508 069 486
TO ENSURE A SPEEDY RESPONSE PLEASE HAVE THE MODEL
NUMBER AND DATE OF PURCHASE AVAILABLE. A CUSTOMER
SERVICE REPRESENTATIVE WILL TAKE YOUR CALL
AND ANSWER ANY QUESTIONS YOU MAY
HAVE RELATING TO THE WARRANTY POLICY
OR PROCEDURE.
The benets provided under this warranty are in addition
to other rights and remedies which are available to you at law.
Our goods come with guarantees that cannot be excluded
at law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
Generally you will be responsible for all costs associated with
a claim under this warranty, however, where you have suffered
any additional direct loss as a result of a defective product you
may be able to claim such expenses by contacting our customer service helpline
above.
WARNING
The following actions will result in the warranty being
void.
• If the tool has been operated on a supply voltage other
than that specied on the tool.
• If the tool shows signs of damage or defects caused
by or resulting from abuse, accidents or alterations.
• Failure to perform maintenance as set out within the instruction manual.
• If the tool is disassembled or tampered with in any way.
5 YEAR REPLACEMENT WARRANTY
Your Product is guaranteed for a period of 60 months from the original date of
purchase and is intended for DIY (Do It Yourself) use only. If a product is defective it
will be replaced in accordance with the terms of this warranty. Lithium Ion
batteries and chargers are covered by a 36 month
warranty. Warranty excludes consumable parts, for example: grass catcher,
wheels, blade, cord clips, bearings etc..
OZITO Australia/New Zealand (Head Ofce) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
11. Safety Key
12. Cable Clip x 2
13. Nut x 4
14. Upper Handle Knob x 2
15. Round Head Bolt-Short x 2
16. Round Head Bolt-Long x 2
17. Spanner
18. CSK Head Bolt x 2
1. Wheels
2. Battery Cover
3. Grass Catcher Flap
4. Lower Handle
5. Safety Switch
6. Start/Stop Lever
7. Sure Grip
8. Top Handle
9. Grass Catcher
10. Cutting Deck
BRUSHLESS LAWN MOWER
KNOW YOUR PRODUCT
1
9
2
10
3
15
4
12
5 6 7
8
11
1. ASSEMBLY
SETUP & PREPARATION
1. Place the lower handle over the
outside of the mower handle
brackets aligning the upper holes in
the handle and each bracket. Fit the
CSK bolt through mounting brackets
then through hole in each side of
lower handle.
Fitting the Lower Handle
WARNING! ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
ACCESSORIES
2. There are three holes remaining
in each bracket, select the
appropriate hole for the height of
the user.
BATTERY & CHARGER
This tool is compatible with all batteries and chargers from the Ozito
Power X Change Range.
Fitting the Upper Handle
1. Place the upper handle over
the lower handle. Fit long
round head bolts through
the lower handle and then
through the upper handle.
3. Fit the short round head bolt
through the brackets and then
through the lower handle. Secure
each bolt with the 4 nuts and
spanner provided.
2. Secure knobs over
the protruding ends
of the bolts.
13 14 16 17 18
2. PREPARATION
1. Open the battery cover. Slide two
batteries of the same capacity
and same charge state into the
mower aligning the ribs so that
they click into place.
2. Insert the safety key.
(If the mower is not going to be
used immediately, do not insert
the safety key.)
1. Lift up the grass catcher ap
with one hand and guide the
catcher with your other hand
over the two hooks on the
mower housing.
3. To remove, raise the grass catcher ap and lift the grass catcher out.
3. Close the battery cover.
2. Lower the grass catcher and
allow it to sit in place. Lower
the grass catcher ap.
Inserting the Batteries into the Mower
Adjusting the Cutting Height
Securing the Cord
WARNING! ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
NOTE: The grass catcher ap
is held against the grass catcher
by a spring.
The cutting height adjustment lever provides 9 cutting heights from 25mm -
80mm.
1. Pull lever outwards away from
the mower body.
2. Adjust until the required
cutting height is selected.
3. Release lever and check
that it is securely seated in
the required cutting height
position.
Only use 2 batteries with the same capacity. For best performance use 3.0Ah
batteries and above. Always use 2 batteries with the same charge state with
the mower.
WARNING! WHEN FITTING THE GRASS CATCHER
AFTER EMPTYING, ALWAYS ENSURE THERE IS NO
BUILD UP OF GRASS IN THE GRASS CHUTE.
Grass Catcher Indicator
The grass catcher is tted with an
indicator at the rear of the catcher to
help identify when to empty.
When in operation the indicator oats
up when the catcher is empty. If the
indicator drops down then the grass
catcher is full and needs emptying.
WARNING! ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Fitting and Removing the Grass Catcher
Ensure the cord follows the inside
of the handles smoothly from the
switch to the body of the mower.
1. Place the supplied cord clips
over the cord. Push the cord
clip onto the handle to secure
in place.
WARNING! ALWAYS ENSURE THE KEY IS REMOVED
WHEN NOT IN USE.

Especificaciones del producto

Marca: Ozito
Categoría: No categorizado
Modelo: PXBSDMK-4182

¿Necesitas ayuda?

Si necesitas ayuda con Ozito PXBSDMK-4182 haz una pregunta a continuación y otros usuarios te responderán


No categorizado Ozito Manuales

Ozito

Ozito PXBSPS-180 Manual de Usario

6 Octubre 2024
Ozito

Ozito SSH-240 Manual de Usario

6 Octubre 2024
Ozito

Ozito PXTLS-905 Manual de Usario

3 Octubre 2024
Ozito

Ozito ADWH-913V Manual de Usario

2 Octubre 2024
Ozito

Ozito PXBLEK-418 Manual de Usario

24 Septiembre 2024
Ozito

Ozito DMC-1000 Manual de Usario

21 Septiembre 2024
Ozito

Ozito PXMFTS-018 Manual de Usario

19 Septiembre 2024
Ozito

Ozito PXBCSS-184 Manual de Usario

15 Septiembre 2024
Ozito

Ozito PXPPS-1820 Manual de Usario

14 Septiembre 2024
Ozito

Ozito PXNGS-218 Manual de Usario

14 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales

POLARIS

POLARIS RZR S 1000 EPS (2018) Manual de Usario

27 Octubre 2024
Workzone

Workzone 20V Li-Ion Reciprocating Saw PT160501 Manual de Usario

27 Octubre 2024
Philips

Philips 43PUL7672 Manual de Usario

27 Octubre 2024
Manhattan

Manhattan 461504 Manual de Usario

27 Octubre 2024
Sungrow

Sungrow SG125HV Manual de Usario

27 Octubre 2024
Schneider

Schneider CCT724319 Manual de Usario

27 Octubre 2024
Technoline

Technoline WS 250 Manual de Usario

27 Octubre 2024
Livarno

Livarno IAN 354423 Manual de Usario

27 Octubre 2024
Kupper

Kupper 12152 Manual de Usario

27 Octubre 2024
JennAir

JennAir CARBON24L Manual de Usario

27 Octubre 2024