Pharos iGPS-360 Manual de Usario

Pharos receptor iGPS-360

Lee a continuación 📖 el manual en español para Pharos iGPS-360 (17 páginas) en la categoría receptor. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/17
iGPS-BT User Manual
FCC Notices
This device complies with Part 15(b and c) of the FCC Rules. Operation is subject to
the following conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Change or modification not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Class B
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the manufacturer’s
instruction manual, may cause interference with radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
FCC ID# Q7M-IGPS-BT
CE Notices
This device has been tested and found to comply with CE marking according to the
R&TTE Directive, 99/5/EEC. The test standards are listed below:
CE/LVD EN60950: 1992+A1+A2+A3+A4+A11
CE/EMC EN301 489-17 V 1.1.1: 09-2000
EN301 489-1 V 1.3.1: 09-2001
Radio Spectrum EN300 328-1 V 1.3.1: 12-2001
EN300 328-2 V 1.2.1: 12-2001
1
I. iGPS-360 Receiver and Bluetooth Dock
iGPS-360
Receiver
iGPS-BT
Dock
DC Jack
for charging
On/Off
Switch
Bluetooth Status
Indicator
(Internal Blue LED)
DC Jack
- Plug either the DC charging adapter (included in PT200 and PT300) or
AC battery charger (included in PT100 and PXT02 accessory) into the
DC Jack to charge the battery.
Refer to III. Battery charging instructions.
- iGPS-BT will need to be charged for approximately 2-3 hours before
initial use.
On/Off Switch
- Turns the iGPS-BT on or off. Blue LED’s will light up when powered.
Bluetooth Status Indicator (Internal Blue LED)
- Blinking: Searching for Bluetooth signal
- Steady: Bluetooth communication established, ready to use.
2

Especificaciones del producto

Marca: Pharos
Categoría: receptor
Modelo: iGPS-360

¿Necesitas ayuda?

Si necesitas ayuda con Pharos iGPS-360 haz una pregunta a continuación y otros usuarios te responderán


receptor Pharos Manuales

Pharos

Pharos iGPS-360 Manual de Usario

25 Agosto 2024
Pharos

Pharos iGPS-180 Manual de Usario

20 Agosto 2024

receptor Manuales

Últimos receptor Manuales

Crown

Crown CDi DriveCore 2|300BL Manual de Usario

27 Octubre 2024
Boss

Boss PT3000 Manual de Usario

27 Octubre 2024
Speco Technologies

Speco Technologies PBM120AT Manual de Usario

27 Octubre 2024
Fosi Audio

Fosi Audio V3 Manual de Usario

26 Octubre 2024
Jensen

Jensen CAR710-4BC Manual de Usario

25 Octubre 2024
Onkyo

Onkyo TX-RZ830 Manual de Usario

24 Octubre 2024
Pioneer

Pioneer VSX-1122K Manual de Usario

22 Octubre 2024
Yamaha

Yamaha HTR-5072 Manual de Usario

21 Octubre 2024
NAD

NAD C 355BEE Manual de Usario

20 Octubre 2024
Yamaha

Yamaha RX-A810 Manual de Usario

20 Octubre 2024