Pioneer S-ES21-LR-K Manual de Usario
Lee a continuación 📖 el manual en español para Pioneer S-ES21-LR-K (16 páginas) en la categoría Oradores. Esta guía fue útil para 13 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/16
1
En
S-ES21-LR-K
S-ES21-LR-T
Operating Instructions
Speaker System
WHAT’S IN THE BOX
BEFORE USE
Thank you for buying this Pioneer product.
Please read through these operating instructions before
using your speaker system to optimize performance.
• This speaker system has an impedance of 8 Ω, and
should be connected only to an amplifier designed
with a load impedance of 8 Ω (the amplifier’s speaker
output connector should clearly be labeled “8 Ω“).
• In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
-Be sure to turn the connected devices off and
remove the power cord from the wall outlet
beforehand when changing the connection or
installation method.
-Do not use excessive amplifier volume if using a
tone control to emphasize high or low frequencies.
• Do not use the speaker to output distorted sound for
long periods of time. This can result in a fire hazard.
INSTALLATION PRECAUTIONS
• Do not install these units near a stove or other
heating appliance, or put them in a place exposed to
the sun. Such locations may cause the cabinet to
change color and the speaker system to break down.
• Do not attach the front speakers to the wall or ceiling.
It may fall off and cause injury.
• Placing the stand on an unstable surface can be
dangerous. Be sure to place it on a flat, firm surface.
• This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the television, then turn it on
again after 15 min to 30 min. If the problem persists,
place the speaker system away from the television
set.
• Do not install your speakers overhead on the ceiling
or wall. The grille is designed to be detachable, and
as such it may fall and cause damage or personal
injury if installed overhead.
• Do not place heavy or large objects on top of the
speaker. Doing so could provoke the speaker to fall,
causing damages or bodily injury.
PLACEMENT AND FINE TUNING
For best results the speakers should be separated a
distance approximately equal to the listening distance.
Angling the speakers inward towards the listener will
improve the image stability for non-central listeners.
Close proximity to a side or rear wall will enhance the
midbass performance, although too close (particularly a
corner location) and the bass may be unnaturally high
and image performance may be degraded.
Front speaker x 2
Speaker cords x 2
Front Grilles x 2
Operating instructions
S-ES21-LR.fm 1 ページ ２０１３年７月１８日 木曜日 午前９時２５分
2
En
STANDARD SURROUND SETUP
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
MAKING AMPLIFIER SETTINGS
Before connecting the speakers, please read the
operating instructions supplied with your amplifier to
select the speaker setting of amplifier :
• FRONT SPEAKERS : LARGE
CONNECTING YOUR SYSTEM
Make sure all equipment is turned off before making any
connections.
• Correct wiring of your speakers is essential for
achieving the best sound quality. Be careful to
ensure proper polarity of connection.
Connect to the speaker terminals on the rear of
the amplifier.
Connect the red marked speaker cord to the red (+)
terminal and the other cord to the black (–) terminal as
shown below (for more details, refer to your amplifier
instruction manual).
After connecting the plugs, pull lightly on the cords to
make sure that the ends of the cords are securely con-
nected to the terminals. Poor connections can create
noise and interruptions in the sound.
Connect to the speaker terminals on the rear of
the speakers.
Unscrew the terminals on the speaker and insert the red
marked speaker cord into the red (+) terminal and the
other cord into the black (–) terminal as shown below.
SECURING THE FRONT SPEAKERS
• Pass a commercially-available reinforced string
through the plastic catch to securely support the
speaker to the wall. Be sure that the wall to which you
fasten the speaker is strong enough to support the
weight of the speaker. After fastening the speaker,
make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the plastic catch directly to the wall. It
should only be used in conjunction with reinforced
string to prevent the speaker from falling.
Pass and tie two reinforced strings through the plastic
catch, and fasten the speaker to the wall as shown above.
• If you are unsure of the quality and strength of the
walls, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
Surround left Surround right
Center
Front
left
Listening position
Front
right
Subwoofer
(not supplied)
CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
D3-4-2-2-3_A1_En
SpeakersAmplifier
Red marked half of speaker cord
Other half of speaker cord
Black Red
Plastic catch
Reinforced strings
Backside of speaker
S-ES21-LR.fm 2 ページ ２０１３年７月１８日 木曜日 午前９時２５分
3
En
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the surfaces.
ATTACHING / DETATCHING THE GRILLE
The front grille of this speaker system is removable.
Proceed as follows:
1. To detatch the grille, grab it by its bottom with both
hands and toward you to separate the bottom part of
the grille from the speaker.
2. Next, grab the top part of the grille and gently pull it
toward you to remove the top portion.
3. To replace the grille, align the holes in the front of the
speaker’s corners with the projections on the grille,
and push each of the corners into place.
TROUBLESHOOTING
Symptom Possible cause Remedy
No sound • Bad speaker cord or
connection.
• Amplifier is off.
• Volume control is at zero.
• Connect correctly or
replace cord.
• Turn on amplifier.
• Slowly turn up volume.
Sound is
distorted.
• Extreme signal condition. • Turn down the
amplifier’s output level
(volume, bass control,
bass boost) to lower the
level.
S-ES21-LR.fm 3 ページ ２０１３年７月１８日 木曜日 午前９時２５分
Especificaciones del producto
| Marca: | Pioneer |
| Categoría: | Oradores |
| Modelo: | S-ES21-LR-K |
¿Necesitas ayuda?
Si necesitas ayuda con Pioneer S-ES21-LR-K haz una pregunta a continuación y otros usuarios te responderán
Oradores Pioneer Manuales
14 Julio 2024
Oradores Manuales
- Oradores JBL
- Oradores Onkyo
- Oradores Yamaha
- Oradores Albrecht
- Oradores Amazon
- Oradores Harman Kardon
- Oradores Telestar
- Oradores Ion
- Oradores Auna
- Oradores Numark
- Oradores Magnat
- Oradores Pure Acoustics
- Oradores Peaq
- Oradores Veho
- Oradores Beats
- Oradores IHome
- Oradores Skytec
- Oradores Dali
- Oradores Dymond
- Oradores XtremeMac
- Oradores Noxon
- Oradores REL Acoustics
- Oradores Konig Electronic
Últimos Oradores Manuales
19 Octubre 2024
18 Octubre 2024
18 Octubre 2024
16 Octubre 2024
16 Octubre 2024
5 Octubre 2024
5 Octubre 2024
5 Octubre 2024
5 Octubre 2024
23 Septiembre 2024