Prem-i-air EH1614 Manual de Usario

Lee a continuación 📖 el manual en español para Prem-i-air EH1614 (14 páginas) en la categoría aire acondicionado. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/14
Page 1
EH1614 / EU
2.3kW (8000 BTU/hour)
Portable Air Conditioner
Climatiseur Local
Page 2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.
BEFORE USE
Inspect the product including its cable and plug for any signs of damage. If the
product is damaged, DO NOT use it, and contact your supplier immediately. The
appliance contains a refrigerant gas, so must be kept upright at all times. After
unpacking wait 3 hours for the refrigerant gas to stabilise before use. The
following is a list of parts that should be included in the packaging.
INSTALLATION
Stand the EH01614 on a firm, flat; level surface at least 30cm (12”) from the
nearest wall. Before use you will need to install the drainage pipe at the rear of
the unit.
Installing Drainage Pipe
First remove the rubber plug from the drain port on the rear of the air
Drain Port
Rubber
Plug
Page 3
Attach the drain pipe clip to rear panel of the air conditioner using the screw
provided.
Firmly attach the drainage pipe to the drain port and secure using the pipe hoop
spring clip provided. The other end of the drainage pipe should be sealed using
the rubber plug which again should be secured using the spring clip. Attach the
drainage pipe to the unit by clipping into the drain pipe clip.
In normal operation t EH1614 tank should only gather a small amount of water he
as any condensate water is usually vented off with the hot exhaust air
If you wish the condensate tank, can be permanently connected to the drain. To
do this a long drain tube may be attached to the drain port and ran to a suitable
drain.
EMPTY CONDENSATE TANK
To empty the water tank, switch the unit off by pressing the ON/OFF button, wait
for three minutes then disconnect from the mains supply. Place a drainage pan
underneath the drain pipe (at the bottom, rear of the unit in the centre).Release
the spring clip and withdraw the bung, allow the water to drain into the drainage
pan. Replace the bung spring clip then reconnect the unit to the mains and
supply
Drain Port
Drain Pipe Clip
Screw
Dran Pipe
Drain Port
Dran Pipe Clip
Spring Clip
Rubber Plug

Especificaciones del producto

Marca: Prem-i-air
Categoría: aire acondicionado
Modelo: EH1614

¿Necesitas ayuda?

Si necesitas ayuda con Prem-i-air EH1614 haz una pregunta a continuación y otros usuarios te responderán




aire acondicionado Prem-i-air Manuales

aire acondicionado Manuales

Últimos aire acondicionado Manuales