Ricatech RTT33 Manual de Usario

Ricatech tocadiscos RTT33

Lee a continuación 📖 el manual en español para Ricatech RTT33 (13 páginas) en la categoría tocadiscos. Esta guía fue útil para 12 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/13

IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS

PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE

APPLICABLE TO YOUR EQUIPMENT.

1. All the safety and operating instructions should be read before the Read Instructions -

appliance is operated.

2. The safety and operating instructions should be retained for future Retain Instructions -

reference.

3. All warnings on the appliance and in the operating instructions should Heed Warnings - be

adhered to.

4. All operating and use instructions should be Follow Instructions -

followed.

5. The appliance should not be used Water and Moisture -

near water-for example, near a bathtub,washbowl,kitchen

sink,laundry tub, in a wet basement, or near a swimming

pooland the like.

6. Carts and Stands - The appliance should be used only with a

cart or stan that is recommendedby the manufacturer.

6A.An appliance and cart combination should be moved with care. Quick stops, excessive force, and

uneven surfaces may cause the appliance and cart combination to overturn.

7. Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as

recommended by the manufacturer.

8. Ventilation - The appliance should be situated so that its location or position does not

interfere with-its proper ventilation.For example, the appliance should not be situated on a bed,

sofa, rug,or similar surface that may block the ventilation penings; or, placed in a built -in

installation, such as a bookcase or cabinet that may impede the flow of air through the

ventilation openings.

9. Heat - The appliance should be situated away from heat sources such as radiators, heat

registers, stoves,or other appliances (including amplifiers) that produce heat.

10.Power Sources - The appliance should be connected to a power supply only of the type

described in the operating instructions or as marked on the appliance.

11.Grounding or Polarization - Precautions should be taken so that the grounding or

polarization means of an appliance is not impeded.

12.Power - Cord Protection - Power-supply cords should be routed so that they are not likely to be

walked on or pinched by items placed upon or against them, paying particular attention to cords

at plugs, and the point where they exit from the appliance.

13.Cleaning - The appliance should be cleaned only as recommended by the manufacturer.

14.This product is designed for use with the antenna attached and should not be connected to any

other external antennas.

15.Non-use Periods - The power cord of the appliance should be unplugged from the outlet when

left unused for a long period of time.

16.Object and Liquid Entry - Care should be taken so objects do not fall and liquids are not

spilled into the enclosure through openings

17.Damage Requiring Service - The appliance should be serviced by qualified service personnel

when:

The power-supply cord of the plug has been damaged;or A.

Objects have fallen, or liquid has been spilled into the appliance;or B.

The appliance has been exposed to rain;or C.

The appliance does not appear to operate normally or exhibits a marked change D.

inperformance; or

E.The appliance has been dropped, or the enclosure damaged.

18.Servicing - The user should not attempt to service the appliance beyond that described in the

operating instructions. All other servicing should be referred to qualified service personnel.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lighting ﬂash with

arrowhead symbol, within an

equilateral triangle, is intended

to alert user to the presence of

uninsulated "dangerous voltage"

within the product's enclosure

that may be of suﬃcient

magnitude to constitute risk of

electric shock to persons.

CAUTION: TO REDUCE THE RISK

OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO

USER SERVICEABLE PARTS –

INSIDE. REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK DO

NOT OPEN

The exclamation point within an

equilateral triangle is intended to

alert user to the presence of

important operating and

maintenance (servicing)

instruction in the literature

accompanying the appliance.

SPECIFICATION

Power Source : DC 12V 1.2A via AC Adaptor (included)

Speaker : 28 x 40mm 8ohm 2W x 2

Three Speed : 33 1/3, 45, 78 rpm

*DESIGN AND SPECIFICATION SUBJECT TO CHANGE WITHOUT NOTICE.

CONTROL LOCATORS

POWER SOURCE

Unwind the power adaptor (Located in a white box inside the packaging foam). First connect the small end of

the adaptor to the back of the turntable, then the other end to an AC power outlet.

UNPACKING THE TURNTABLE

1. Remove packing materials from unit.(Note: Save all packing materials.)

2. Carefully remove unit from its styro-foam and take it out of the plastic bag.

3. Although records can be played with the lid attached and opened, it is recommended

this is removed.

4. Remove the white protective needle cover by gently pulling towards front of unit.

TURNTABLE OPERATION

1. Turn the unit on by rotating the ON-OFF VOLUME SWITCH located on the front panel to the ON position.

Release TONE ARM from the ARM LOCK and place it on the ARM REST.

Important: The ARM LOCK is taller than the turntable and needs to be folded down to allow larger

records to be played.

3 Set the SPEED CONTROL SWITCH to desire speed (33 1/3,45 or 78 rpm). Place the record on the

turntable.

4. Lift the TONE ARM by hand to the record and slowly lower it to the desired starting point. The turntable

will start to turn automatically. At the end of the record, the turntable will still turn. You must return the

TONE ARM to the ARM REST manually.

5. -adjust the ON-OFF VOLUME SWITCH to the desired level. Re

: After use and before closing the cover, always place the TONE ARM back on the ARM LOCK NOTE

after this has been pushed upwards again.

ACCESSORY: Adaptor for 45 rpm record

To play the 45 rpm record, place the ADAPTOR on the SPINDLE.

1. Place the 45 RPM adaptor over the spindle.

2. Gently place your 45 RPM record onto the turntable.

3. Follow the steps under turntable operation to play your record.

NEEDLE INSTALLATION

REMOVING NEEDLE:

1. Gently pull down the tip of the cartridge.

2. Pull cartridge forward.

3. Pull out and remove.

INSTALLING CARTRIDGE:

After following ―Remove instructions‖ above, follow steps 1 to 4.

1. Position red cartridge with sapphire stylus facing down.

2. Line up the tab on the back of the needle with the tone arm (as shown in picture 1 below).

3. Insert the cartridge with its front end at a downward angle (as shown in picture 2 below).

4. Lift front end of needle upward until it snaps into place.

ADDITIONAL INFORMATION:

• The red cartridge has a very small sapphire stylus that is barely visible.Take note the replacement needle

you are receiving is the same as the needle already on the tonearm.

• This needle is safe for 33 1/3, 45 & 78 speed records.

• Replacing the needle depends on how often you use your turntable.

• This sapphire stylus will provide an average of 1000 hours playing time.

LINE OUT OUTPUTS

1. Connect the auxiliary cables(not supplied) to the LINE OUT JACK and to the auxiliary inputs on the

desired component.

2. Plug Auxiliary cable into the LINE OUT JACK on the back of your unit.

3. Plug the other end of the Auxililary cable into the input jack on your desired external component.

4. Check the volume level of your external component.

5. See operators manual for correct operation of the external component.

SUBWOOFER OUTPUT JACK

The subwoofer output jack enables you to attach a subwoofer (not supplied) which will enhance bass

response. Please contact your retailer for suitable subwoofer models.

TROUBLESHOOTING GUIDE

THERE IS NO POWER

- The AC adaptor is not connected to either a power outlet or unit.

- The unit is not turned ON : Rotate the ON-OFF SWITCH from the OFF position.

TURNTABLE WILL NOT WORK

- The white protective needle cover was not removed.

- Adjust the VOLUME CONTROL knob.

- The volume is not turned up.

Especificaciones del producto

Marca:	Ricatech
Categoría:	tocadiscos
Modelo:	RTT33
Color del producto:	Roestvrijstaal
Peso.:	10000 g
Ancho:	600 mm
Profundidad:	500 mm
Altura:	- mm
Longitud del cable:	1.3 m
Nivel de ruido:	67 dB
Peso del embalaje:	13000 g
Amable:	Muurmontage
Potencia del motor:	180 W
iluminancia:	200 Lux
Capacidad máxima de extracción:	400 m³/uur
Método de extracción:	Afvoerend/recirculerend
Número de lámparas:	2 gloeilamp(en)
Tipo filtro veterinario:	Roestvrijstaal
Altura (mín.):	793 mm
Altura (máx.):	970 mm
Lámpara de encendido:	40 W
Fuente de alimentación:	220-240 V, 50 Hz, 10 A
Número de velocidades:	3
Dimensiones del paquete (AnxPrxAl):	650 x 670 x 480 mm
Mando a distancia incluido:	Nee
Consumo de energía (típico):	260 W