Rolls RM64 Manual de Usario

Rolls consola de mezclas RM64

Lee a continuación 📖 el manual en español para Rolls RM64 (2 páginas) en la categoría consola de mezclas. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/2
RM64
FOUR ZONE MIXER
ROLLS CORPORATION
SALT LAKE CITY, UTAH
06-10
Setup Guide
FEATURES:
• Two Microphone and Four RCA Source Inputs
• Four XLR Balanced Zone Outputs
• 12 VDC Phantom Power available for each Mic Input
• Remote Volume control jacks for each Zone Output
• Switchable Ducking for the Mic Inputs
SPECIFICATIONS
Input Impedance: 10K Ohms balanced
50K Ohms unbalanced RCA
Output Impedance: 50 Ohms Balanced XLR
Max Input Level: Mic: +10 dB
Source: +22 dB
Phantom Power: +12 Volts DC, 5mA max.
Input Connectors: XLR and RCA
Outputs: 4 ea. XLR
Max Gain: 60 dB mic
30 dB line
S/N Ratio: >75 dB
THD < .3%
IMD (SMPTE) < .3%
CMRR 90 dB
Frequency Response: 20Hz to 20kHz +/- 0 dB
Power 120 VAC 50-60 Hz, 15 W
Weight: 7 lbs (3KG)
Size: 19” x 1.75” x 6.5”
(48cm x 4.5cm x 17cm)
SETTING THE REAR PANEL DIP SWITCHES
Zone Duck Assign
Switches 1 - 4 engage the Ducking function to the indicated zone.
First - in order for the ducking to operate properly in the assigned zone, the microphones
and sources must be assigned to that zone.
Select which zone you wish to have the ducking function by moving that Zone Duck As-
sign switch to the DOWN position. BOTH Mic 1 and Mic 2, if assigned to the selected zone
and have the Zone Duck Assign switch down, will duck the sources assigned to that zone.
For example; shown above - Mic 1 is selected on the front panel to Zones 1 - 4, and Mic 2
is selected only to Zone 1. Shown below, Zone 4 has no ducking assigned, while Zones 1
- 3 have ducking assigned. Therefore, Mic 1 and Mic 2 will duck whatever Source material
is present at Zone 1, Mic 1 will additionally duck material at Zones 2 and 3, but not Zone
4. Mic 2, since it is not selected to Zones 2 - 4, it will have no e ect on those zones.
1 2 3 4 5 6
SOURCE INPUTS MIC TWO MIC ONE
4321
INPUT
2
INPUT
1
TRIM TRIM
ZONE
DUCK
ASSIGN
4 3 2 1
PHANTOM
POWER
2 1
Phantom Power
Switch 5 applies Phantom Power to Mic 2, Switch 6 applies Phantom Power to Mic 1. The
Phantom Power is on when the switch is DOWN.
ZONE
SELECT
1 2 3 4 1 2 3 4
ZONE
SELECT
1 2 3 4 1 2 3 4
www.rolls.com
1 2 3 4 5 6 7 81 2 3 4 5 6 7 8
CONNECTION INFORMATION
Referring to the diagram above, connect microphones to the MIC INPUTs and apply
phantom power where needed by moving the corresponding Phantom Power switch to the
DOWN position. Connect sources such as cassette players, CD players, AM/FM tuners,
etc. to the RCA Source Inputs. Note which input each device is connected to as that input
corresponds to its front panel Level control. Connect the XLR outputs to their respec-
tive zone ampli ers and speakers. The balanced signals are con gured pin 2 hot, pin 3
neutral, and pin 1 ground. For ground lifting, it will be necessary to remove the connection
to pin 1.
REMOTE VOLUME INFORMATION
For Remote Volume operation, a Tip-Ring-Sleeve plug will need to
be wired to a 10 - 100 K Ohm potentiometer (NEITHER INCLUD-
ED) as shown here.
Sleeve
Ring
Tip
10K to 100K Ohm
Linear taper potentiometer
Thank your for your purchase of the Rolls RM64 Four Zone Mixer. The RM64 combines two paging
microphones with up to four line level source inputs. Each input is switch selected to output to any
combination of four zone outputs. The outputs are all balanced XLR connectors, and a 1/4” Remote
Volume jack provides each zone with the means for external volume control. The Microphone inputs
feature automatic ducking for easy paging.
The RM64 is the ideal solution for banquet rooms, o ces, restaurant/night clubs, etc.
NOTE: This unit is intended for professional installation. Certain assumptions have been made that
the installer has the required knowledge to properly install, setup and operate the RM64.
INSPECTION/WARRANTY
1. Unpack and inspect the RM64 box and package.
If obvious physical damage is noticed, contact the carrier immediately to make a damage
claim. We suggest saving the shipping carton and packing materials for safely transporting
the unit in the future.
2. Please visit our website at www.rolls.com for Warranty Information and Registration.
FRONT PANEL
pwr
ZONE
SELECT
1 2 3 4 1 2 3 4
ZONE
SELECT
1 2 3 4 1 2 3 4
ZONE
SELECT
1 2 3 4 1 2 3 4
FOUR
ZONE
MIXER
RM64
ZONE OUTPUTS
CH 4
INPUT
www.rolls.com
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 81 2 3 4 5 6 7 8
MIC INPUTS 1, 2: These LEVEL controls adjust the volume of the indicated
Microphone channel.
SOURCE INPUTS 1 - 4: These LEVEL controls adjust the volume of the indi-
cated Source channel.
ZONE SELECT: DIP switches for assigning the indicated Mic or Source channel
to the Zone Outputs. The four switches closest to the channel LEVEL control as-
sign that channel to the zones.
ZONE OUTPUTS: These LEVEL controls adjust the output volume of the indi-
cated ZONE.
CH 4 INPUT: 3.5mm (1/8” stereo) line level input for channel 4.
pwr LED: When lit, indicates the RM64 is on.
Power switch: Turns the RM64 on and o .
REAR PANEL
1 2 3 4 5 6
WARNING:
DO NO T EXPO SE THIS EQUIPM ENT
TO RAIN OR M OISTURE
NO USER SERVICABLE PARTS INSIDE.
MODEL RM 64
SERIAL NUMBER
RISQUE DE CHOC - NE PAS ENLEVER
REMOTE
VOLUME REMOTE
VOLUME REMOTE
VOLUME REMOTE
VOLUME
OUTPUT
3
OUTPUT
2
OUTPUT
1
OUTPUT
4
ZONE FOUR ZONE THREE ZONE TWO ZONE ONE SOURCE INPUTS MIC TWO MIC ONE
4321
INPUT
2INPUT
1
TRIM TRIM
ZONE
DUCK
ASSIGN
4 3 2 1
PHANTOM
POWER
2 1
120 VAC 50/60 Hz 15 VA
www.rolls.com
ZONE OUTPUTS 1 - 4: Line level (+4 dB ref.) balanced male XLR jacks for con-
nection to the zone ampli ers.
REMOTE VOLUME: These four 1/4” TRS jacks connect to a remote volume
potentiometer.
SOURCE INPUTS 1 - 4: RCA input jacks for connection to CD Players, Tuners
etc.
ZONE DUCK ASSIGN/PHANTOM POWER SWITCHES: This set of DIP switch-
es, from left to right;the  rst four assign which zone will have the source signal(s)
ducked by the Microphone Inputs, the last two apply phantom power to the indi-
cated microphone channel.
MIC INPUT 1 - 2: Balanced female XLR jacks for connection to dynamic or con-
denser type microphones.
TRIM 1 - 2: Adjusts the input sensitivity for the indicated Mic Input.
FROM AM/FM TUNER
FROM CD PLAYER
FROM DVD PLAYER
To Zone One
power amplifier
and speakers
To Zone One
Remote Volume
control
To Zone Two
power amplifier
and speakers
To Zone Two
Remote Volume
control
To Zone Three
power amplifier
and s
p
eakers
To Zone Three
Remote Volume
control
To Zone Three
power amplifier
and speakers
To Zone Three
Remote Volume
control
WARNING:
DO NOT EXPOSE THIS EQ UIPM ENT
TO RA IN OR MO ISTURE
NO USER SERVICABLE PARTS INSIDE.
MODEL RM64
SERIAL NUMBER
RISQUE DE CHOC - NE PAS ENLEVER
120 VAC 50/60 Hz 15 VA
www.rolls.com
ZONE
SELECT
1 2 3 4 1 2 3 4
ZONE
SELECT
1 2 3 4 1 2 3 4
www.rolls.com
1 2 3 4 5 6 7 81 2 3 4 5 6 7 8
SETTING THE FRONT PANEL DIP SWITCHES
Each input is assigned to a Zone via the four DIP switches nearest that Input
Level control. The zone is assigned when the switch is in the DOWN position.
For example, the switch settings above send Mic 1 to all four Zones; 1, 2, 3,
and 4. Mic 2 is sent to Zone 1 only. Source 1 is sent to Zone 1, and Source 2 is
sent to Zones 2, 3, and 4.

Especificaciones del producto

Marca: Rolls
Categoría: consola de mezclas
Modelo: RM64

¿Necesitas ayuda?

Si necesitas ayuda con Rolls RM64 haz una pregunta a continuación y otros usuarios te responderán


consola de mezclas Rolls Manuales

Rolls

Rolls Mic/Line Mixer RM82 Manual de Usario

9 Septiembre 2024
Rolls

Rolls DA134 Manual de Usario

9 Septiembre 2024
Rolls

Rolls PM59 Manual de Usario

9 Septiembre 2024
Rolls

Rolls Mini-Mix II MX51S Manual de Usario

9 Septiembre 2024
Rolls

Rolls MX44 Pro Manual de Usario

9 Septiembre 2024
Rolls

Rolls MX401 Manual de Usario

9 Septiembre 2024
Rolls

Rolls RM169 Manual de Usario

9 Septiembre 2024
Rolls

Rolls LiveMix MX34c Manual de Usario

9 Septiembre 2024
Rolls

Rolls MX422 Manual de Usario

9 Septiembre 2024
Rolls

Rolls MA1705 Manual de Usario

9 Septiembre 2024

consola de mezclas Manuales

Últimos consola de mezclas Manuales

Konig

Konig KN-DIGICON20 Manual de Usario

27 Octubre 2024
Rane

Rane Sixty-Four Manual de Usario

27 Octubre 2024
Wharfedale

Wharfedale SL 1224 USB Manual de Usario

27 Octubre 2024
American Audio

American Audio 14MXR Manual de Usario

23 Octubre 2024
Yamaha

Yamaha MG12XU Manual de Usario

21 Octubre 2024
Yamaha

Yamaha MG 10 Manual de Usario

20 Octubre 2024
Yamaha

Yamaha MG12 Manual de Usario

20 Octubre 2024
Midas

Midas PRO9 Manual de Usario

20 Octubre 2024
American Audio

American Audio Q-D6 Manual de Usario

20 Octubre 2024
Glemm

Glemm MXD 08 Manual de Usario

20 Octubre 2024