Scotsman HID525A-1A Manual de Usario

Scotsman máquina de cubitos de hielo HID525A-1A

Lee a continuación 📖 el manual en español para Scotsman HID525A-1A (41 páginas) en la categoría máquina de cubitos de hielo. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/41

Service Manual for

Meridian Ice Maker-Dispensers Models

HID312, HID525 and HID540

HID312, HID525, HID540

Service Manual

April 2015

Page 2

Introduction

The ice maker-dispensers covered in this manual

were designed by to be the nest on the market. Their

design is a result of Scotsman’s long experience in ice

maker-dispensers.

HID312 is 16 inches wide and air cooled only.

HID525 is 21 inches wide and 34.9 inches tall. it is

available as an air cooled or water cooled model.

HID540 is also 21 inches wide, but it is 40.9 inches

tall. it is also available either air or water cooled.

Observe any caution or warning notices. They are

important and provide notice of potential hazards.

Keep this manual for future reference.

Contents

Specications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

HID312 Cabinet Drawing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

HID525 Cabinet Drawing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

HID540 Cabinet Drawing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Placement 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Counter Installations 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Differences Between Models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Component Location 10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Start Up 12 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operation: Ice and Water Vending 13 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Controller Functions 15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Maintenance and Cleaning 16 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Air lter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Maintenance and Cleaning - Dispensing Bin Components . . . . . . . . . . . . . . . . . . . . 18

Ice level controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

Dispensing Bin 20. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Ice Making and Ice Dispensing System Cleaning Instructions 21 . . . . . . . . . . . . . . . . . .

Other Maintenance 23 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Basic Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24

Troubleshooting 25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Controller Diagnostics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26

Test Procedures 27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Test Procedures 28 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Test Procedures - Refrigeration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29

Test Procedures Auger and Gear Reducer 30 . . . . . . . . . . . . . . . . . . . . . . . . . .

Dispensing Motor 31. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Photo Eye - Bin Control 32 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Gear Reducer 33 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Auger 34 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Evaporator 35 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Water Seal and Auger Bearings 36 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HID312 Wiring Diagram 37 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HID312 Schematic Diagram 38 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HID525 or 540 Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39

HID525 or 540 Schematic Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40

HID312, HID525, HID540

Service Manual

April 2015

Page 3

Specications

The ice maker-dispenser is designed to be installed

indoors, in a controlled environment. Although

it can operate in a wide range of air and water

temperatures, it will provide the best performance if

not subject to extremes.

Air Temperature Limitations

• Maximum: 100oF. or 38oC.

• Minimum: 50oF. or 10oC.

Water Temperature Limitations

• Maximum: 100oF. or 38oC.

• Minimum: 40oF. or 4.4o

Water Pressure, potable

• Maximum: 80 PSI or 5.5 Bar

• Minimum: 20 PSI or 1.3 Bar

Water Pressure, condenser inlet

• Maximum: 145 PSI or 10 Bar

• Minimum: 20 PSI or 1.3 bar; can be as low as 5

PSI or .3 Bar if clean & supplied with 45oF. water)

Condenser GPM

• 70oF. water: .25 or .95 LPM

• 50oF. water: .15 or .57 LPM

Water Conductivity:

• Minimum: 10 microSiemens/cm

RO water may be supplied to the potable water

system, but if it has less than the above conductivity,

the water level sensor will not detect water and the

unit will not make ice.

Deionized water will not work and isn’t recommended.

Voltage - 60 Hz

• Maximum: 126 Minimum: 104

Operating the machine outside of any of the above

limitations is considered abuse and any resulting

damage is not covered by warranty and could cause a

complete loss of warranty coverage.

Warranty Information

The warranty statement for this product is provided

separately from this manual. Refer to it for applicable

coverage. In general warranty covers defects

in material or workmanship. It does not cover

maintenance, corrections to installations, or situations

when the machine is operated in circumstances that

exceed the limitations printed above.

Product Information

The product is an ice maker-dispenser. It is designed

to be installed on a countertop or on a specic

machine stand.

• All models require a drain. An internal drain basin

separates the ice storage bin’s drain from the drip tray

drain.

• A backow preventer may be required by local

plumbing codes.

• 60 Hz model has a 7.5 ft. power cord with NEMA

5-15P plug.

• Air cooled models ow air left to right and include

a cleanable air lter.

• 4” or 10 cm legs are optional for counter models.

Thread size 3/8 - 16.

• Special models are required for wall mounting.

• Ice or water vending is triggered by touch free

sensors, no other activation method is available.

• For available options and kits, see sales literature.

Scotsman Ice Systems are designed and

manufactured with the highest regard for safety and

performance.

Scotsman assumes no liability or responsibility of

any kind for products manufactured by Scotsman

that have been altered in any way, including the use

of any part and/or other components not specically

approved by Scotsman.

Scotsman reserves the right to make design changes

and/or improvements at any time. Specications and

design are subject to change without notice.

Especificaciones del producto

Marca:	Scotsman
Categoría:	máquina de cubitos de hielo
Modelo:	HID525A-1A
Peso.:	20400 g
Ancho:	700 mm
Profundidad:	500 mm
Altura (mín.):	1220 mm
Altura (máx.):	1290 mm
El número de ruedas:	5 wiel(en)
Color del marco:	Zwart
Cantidad por paquete:	1 stuk(s)
Tipo-producto:	PC-gamestoel
Rango de ángulo de inclinación:	90 - 135 °
Ruedas:	Ja
Reposacabezas:	Ja
tipo de silla:	Gecapitonneerde zitting
Color del asiento:	Black, Blue
Tipo de respaldo:	Gecapitonneerde rugleuning
Color del respaldo:	Black, Blue
Brazo:	Ja
Reposabrazos ajustable:	Ja
Incluye volante de carreras/modo vuelo:	Nee
Ancho-del-asiento:	550 mm
Profundidad-del-asiento:	480 mm
Altura del asiento (máx.):	470 mm
Material del respaldo:	Foam, Polyurethane (PU)
Material del asiento:	Foam, Polyurethane
Altura-del-respaldo:	820 mm
Ancho del respaldo:	615 mm