Sharkoon Vibe-Fixer III 5.25" Manual de Usario
Sharkoon
Lector de tarjetas de memoria
Vibe-Fixer III 5.25"
Lee a continuación 📖 el manual en español para Sharkoon Vibe-Fixer III 5.25" (2 páginas) en la categoría Lector de tarjetas de memoria. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/2
Manual
www.sharkoon.com
HDD VIBE FIXER
1. Apply the cushion pads to the frame (fig. 1).
2. Slide the silicone covers over the 6 clamps of the
frame (fig. 2).
3. Fasten the rubber bands to the outer clamps of
the frame (fig. 3).
9. Fasten the last rubber band to the frame’s central
hook (fig. 7).
This is how the frame should finally look like (fig. 8).
10. Install the frame with the HDD into the computer
case. Secure it with the included screws.
Operating conditions:
Any hard disk of 3.5" width and 1" height can be
mounted and operated with the Vibe-Fixer. The
operation temperature should not exceed 50°
Celsius permanently. For short periods of time, up
to 70° Celsius are tolerable for the rubber bands.
Keep in mind that the aging process of the rubber is
accelerated by heat! The rubber bands must not be
exposed to daylight (UV light) for long periods of
time.
Transportation note:
Rough handling during transportation may cause
some displacement of the hard disk from its rubber
suspension. After transportation open the PC, check
and correct any possible displacement of the disk to
ensure perfect operation of the unit.
It is strongly recommended to check the rubber
bands prior to any movement/shipment of the
computer (see section "Maintenance").
Maintenance:
The rubber bands of the VIBE FIXER are subject to
an aging process. Therefore it is required that the
rubber bands’ condition is checked every 12-18
months and to replace them if needed. Take a very
close look at the spots where the rubber is bent the
most, at the hooks and at the edges of the hard disk.
If cracking shows up, any part of the rubber feels
tacky or if the surface of the rubber bands looks
distinctively whitish, do not use the unit until the
rubbers have been replaced. You can order /
purchase substitution rubber bands at
support@sharkoon.com.
4. Two silicone covers come with a lengthwise cut.
Slide these covers over both inner parts of the
rubber bands (fig. 4).
5. Fasten the two inner parts of the rubber bands
with the included cable tie. Take care to move the
cable tie over the silicone covers (fig. 4). Cut the
overlaying end of the cable tie with a pair of
scissors.
6. Place the frame on a flat surface in front of you.
7. Pull up the outer string of a rubber band and
carefully slide the HDD into the gap (the strings of
the rubber bands which are tied together by the
cable tie go underneath the HDD) (fig. 5).
Note:
Take care that the rubber bands will not be amaged
by the HDD or parts of it.
8. Slide the outer string of the second rubber band
over the HDD and center the drive between the
rubber bands (fig. 6).
Note:
The rubber bands of the frame are quite sensitive to
mechanical damage. Sharp edges of the hard disk
may cause small cuts in the rubber, which might go
unnoticed but could eventually lead to disruption of
the rubber. While inserting the hard disk into the
frame this risk is most present. Therefore any sharp
edges on the hard disk must be covered using
standard isolating tape.
Important:
Never pull or press the rubber bands directly onto
any electronics of the hard disk. It is harmless if the
rubber bands touch the electronics, yet force must
be avoided. Try to avoid placing rubber bands
directly across processor chips of the hard disk as
they might get hot.
1
2
3
4
5
6
7
8
Especificaciones del producto
| Marca: | Sharkoon |
| Categoría: | Lector de tarjetas de memoria |
| Modelo: | Vibe-Fixer III 5.25" |
¿Necesitas ayuda?
Si necesitas ayuda con Sharkoon Vibe-Fixer III 5.25" haz una pregunta a continuación y otros usuarios te responderán
Lector de tarjetas de memoria Sharkoon Manuales
31 Agosto 2024
29 Agosto 2024
Lector de tarjetas de memoria Manuales
- Lector de tarjetas de memoria Akasa
- Lector de tarjetas de memoria Icy Box
- Lector de tarjetas de memoria Hikvision
- Lector de tarjetas de memoria SilverStone
- Lector de tarjetas de memoria Vivanco
- Lector de tarjetas de memoria Sitecom
- Lector de tarjetas de memoria Manhattan
- Lector de tarjetas de memoria Trust
- Lector de tarjetas de memoria Hama
- Lector de tarjetas de memoria DeLock
- Lector de tarjetas de memoria SanDisk
- Lector de tarjetas de memoria Connect IT
- Lector de tarjetas de memoria Blackberry
- Lector de tarjetas de memoria Digitus
- Lector de tarjetas de memoria ICIDU
- Lector de tarjetas de memoria Speed-Link
- Lector de tarjetas de memoria Sven
- Lector de tarjetas de memoria Konig
- Lector de tarjetas de memoria Sweex
- Lector de tarjetas de memoria Conrad
- Lector de tarjetas de memoria D-Link
- Lector de tarjetas de memoria Conceptronic
- Lector de tarjetas de memoria Satechi
- Lector de tarjetas de memoria NZXT
- Lector de tarjetas de memoria Arctic Cooling
- Lector de tarjetas de memoria Icy Dock
- Lector de tarjetas de memoria Maxell
- Lector de tarjetas de memoria Vantec
- Lector de tarjetas de memoria Sonnet
- Lector de tarjetas de memoria StarTech.com
- Lector de tarjetas de memoria SIIG
- Lector de tarjetas de memoria IOGEAR
- Lector de tarjetas de memoria Media-tech
- Lector de tarjetas de memoria Enermax
- Lector de tarjetas de memoria Sabrent
- Lector de tarjetas de memoria Lloyds Bank
- Lector de tarjetas de memoria Hamlet
- Lector de tarjetas de memoria Lexar
- Lector de tarjetas de memoria Equip
- Lector de tarjetas de memoria Raidsonic
- Lector de tarjetas de memoria Approx
- Lector de tarjetas de memoria I-Tec
- Lector de tarjetas de memoria Rocstor
- Lector de tarjetas de memoria Urban Factory
- Lector de tarjetas de memoria EXSYS
- Lector de tarjetas de memoria Green House
- Lector de tarjetas de memoria ID-Tech
- Lector de tarjetas de memoria CSL
Últimos Lector de tarjetas de memoria Manuales
8 Octubre 2024
4 Octubre 2024
1 Octubre 2024
30 Septiembre 2024
25 Septiembre 2024
19 Septiembre 2024
18 Septiembre 2024
18 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024