Signature Hardware Bennett 433107 Manual de Usario

Lee a continuación 📖 el manual en español para Signature Hardware Bennett 433107 (2 páginas) en la categoría No categorizado. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
1Bennett Kitchen Faucet Installation Instructions
INSTALLATION
BENNETT KITCHEN FAUCET INSTALLATION
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
faucet, plumbing, sink, counter top, or for personal injury
during installation.
Observe all local plumbing and building codes.
Unpack and inspect the faucet for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-8 -55 71 18005- .
Note: Make sure to winterize your outdoor faucet
before cold weather arrives to prevent burst pipes and
protect the faucet’s hardware.
*not included
TOOLS AND MATERIALS:
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the old
faucet has been completely removed and any
necessary repairs or modifications to the water
supply have been completed.
Plumbers
Tape*
Thread
Sealant*
Adjustable
Wrench*
Phillips
Screwdriver*
Small
Bucket*
Basin
Wrench*
2. Remove the lock nut, rubber washer, and metal
washer from the faucet body. Insert the faucet through
the mounting hole in your counter top.
1. Ensure that the water supply below your sink is
completely shut off by turning the shutoff valves all the
way to the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
OFF
SKU(s): 433107, 433135
1.855.715.18001.855.715.1800
Bennett Kitchen Faucet Installation Instructions
BENNETT KITCHEN FAUCET INSTALLATION
2
5. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
6. Remove the aerator from the spout. Turn the faucet
on and allow the water to flow for approximately 60
seconds. Ensure that there are no leaks, and that both
hot and cold water are running properly. Divert water to
the sprayer setting and allow it to flow for another 60
seconds.
3. From beneath the sink, slide the rubber washer and
metal washer back onto the faucet body. Thread the
lock nut back onto the shank and hand tighten. Finish
securing the faucet by tightening the two screws
attached to the lock nut with a Phillip’s screwdriver.
Note: For thin mounting surfaces, use the provided
plastic support. The support should slide on first,
before the rubber gasket.
4. Apply plumber’s tape or thread sealant to the
threading on each of the faucet’s water lines, and
connect the main water hoses to the faucet. Ensure
that you are connecting the hot and cold lines appro-
priately.
ON
1.855.715.18001.855.715.1800

Especificaciones del producto

Marca: Signature Hardware
Categoría: No categorizado
Modelo: Bennett 433107

¿Necesitas ayuda?

Si necesitas ayuda con Signature Hardware Bennett 433107 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Signature Hardware Manuales

No categorizado Manuales

Últimos No categorizado Manuales